Health Violations Found CT 1 HEALTH VIOLATION

Meriden Water Division

EPA ID: CT0800011 · 58,441 people served · 6 ZIP codes

In the current EPA monitoring period, Meriden Water Division has 3 violations still listed as unresolved, with the utility supplying water to approximately 58,441 residents.

Data: EPA SDWIS Last verified: 2026-04-02

C · 58
Avg Safety Score
58,441
People Served
6
ZIP Codes Served
5
Violations (5yr)
Surface Water
Water Source
0.0013 mg/L
Max Lead Level
Zone 1
Radon Risk · High
3
Contaminants Flagged
$328K
Median Home Value in Service Area

Compliance Trajectory

Worsening · Risk tier: High · 95% chance of violation in next 12 months

Violations went from 1 (2023) to 2 (2024). The pattern suggests growing compliance challenges.

Service Area Map

Coverage area for Meriden Water Division Source: EPA SDWIS service area boundaries.

Service area boundary — Grade C

Service Area Demographics

$101,757
Median Household Income
165,753
Service Area Population
26%
Disadvantaged Population
30th
Poverty Percentile
68th
Energy Burden Percentile
76%
Pre-1986 Housing

The Meriden Water Division serves a community with a median household income of $101,757 and an estimated 165,753 residents across its service area. Approximately 76% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

🌊 Where Does Your Water Come From?

Surface Water

Meriden Water Division's water is drawn from rivers, lakes, or reservoirs. Surface water sources are more exposed to agricultural runoff, stormwater, and upstream discharges, but they typically receive more intensive treatment before reaching your tap.

Elevated Risk
Source Contamination Risk
50th
Wastewater Discharge Proximity
60th
Superfund Site Proximity

Superfund Proximity Note: This service area ranks in the 60th percentile nationally for proximity to Superfund (NPL) sites.

Infrastructure Risk

58 yr
Avg Pipe Age
Copper
Pipe Material
13 yr
Est. Remaining Life
Accelerating Decay
Decay Status
Installed 82% of expected lifespan used End of life

Detected Contaminants

How Meriden Water Division compares to EPA limits

What This Means For You

Surface Water Treatment Rule at 3 mg/L exceeds the EPA maximum of mg/L.

Stage 1 DBP Rule at 1 mg/L exceeds the EPA maximum of mg/L.

Contaminant 0700 at 1 mg/L exceeds the EPA maximum of mg/L.

PFAS Detected in Service Area

PFAS ("forever chemicals") have been detected in water serving this system's area. 36 detections recorded. 12 exceed federal EPA limits (4 ppt for PFOA/PFOS).

State limits: PFOA: 0.012 ppt, PFOS: 0.016 ppt, PFHxS: 0.018 ppt, PFHpA: 0.018 ppt, PFNA: 0.013 ppt
Health concern: PFAS are linked to cancer, thyroid disease, immune suppression, and developmental effects. They do not break down naturally.
Recommended filter: Reverse osmosis (RO) or activated carbon filters certified for PFAS removal. Find the right filter →

Comparable Water Systems

Similar-sized systems in Connecticut

Danbury Water Department
62,055 people
C 9 violations
Aquarion-greenwich
53,297 people
0 violations
Bristol Water Department
52,079 people
B 7 violations
A 5 violations
A 4 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Radon Mitigation Flood Insurance PFAS Treatment Water Filtration
Radon Mitigation $1,000
Flood Insurance $1,000
PFAS Treatment $500
Water Filtration $250
Total Estimated Cost $2,750

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $1,000

Annual per household (CDC est.)

PFAS Exposure — Lifetime Cost $1,000

Per person (emerging research est.)

Estimated Cumulative Cost Per Household

5 years
$5,165
10 years
$10,330
20 years
$20,660

Compare: Estimated remediation cost is $2,750 (one-time) vs. $10,330 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

Meriden Water Division (EPA ID: CT0800011) is a community water system in Connecticut that serves approximately 58,441 people from surface water sources.

This system provides water to 6 ZIP codes across 4 communities.

Average Home Safety Score: C (58/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

1 health-based violation recorded in the past 5 years. 3 remain unresolved.

Recent Violations

Date Contaminant Type Status
August 10, 2025 Surface Water Treatment Rule Monitoring Unresolved
July 31, 2025 Contaminant 0700 Health-based Unresolved
July 1, 2025 Surface Water Treatment Rule Monitoring Unresolved
August 10, 2024 Surface Water Treatment Rule Monitoring Resolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Surface Water Treatment Rule Treatment Failure 3 No
Stage 1 DBP Rule Treatment Failure 1 No
Contaminant 0700 Other Violation 1 Yes

Lead & Copper

EPA Lead and Copper Rule sampling data for ZIP codes served by this system:

ZIP Code Lead Level Exceeds Limit Sample Date
06450 0.0013 mg/L No N/A
06451 0.0013 mg/L No N/A
06454 0.0013 mg/L No N/A

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 1 (High Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Coverage: 5 ZIP codes confirmed via EPA Community Water System Service Area Boundaries v3 plus 1 additional ZIP inferred from SDWIS registry data. The EPA-confirmed set is the most reliable; SDWIS-inferred entries may be narrower than the real deployment area.

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Meriden Water Division (CT0800011) on EPA.gov.

Frequently Asked Questions

Is Meriden Water Division water safe to drink?

Meriden Water Division has recorded 1 health-based violation in the past 5 years. While the system is required to treat water to meet federal standards, you may want to consider additional precautions such as a certified water filter.

How many people does Meriden Water Division serve?

Meriden Water Division serves approximately 58,441 people across 6 ZIP codes in Connecticut.

Where does Meriden Water Division get its water?

The primary water source is surface water.

Federal UCMR5 PFAS Monitoring: Detected

This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). PFAS compounds were detected below the current state-enforceable MCL.

Samples collected
547
Detections
12
Latest sample
4/2/2024
Highest analyte
PFOS: 9.5 ppt
Analyte Max detected Current MCL Status
PFOS 9.5 ppt 10 ppt Above 2029 federal MCL
PFOA 6.1 ppt 10 ppt Above 2029 federal MCL
PFHxA 5.8 ppt
PFBA 5 ppt
PFPeA 4.8 ppt
PFHxS 4 ppt 10 ppt Below current MCL

Current MCL reflects the lowest state-enforceable limit (NYS 10 ppt for PFOA/PFOS, effective August 2020). The federal final MCL of 4 ppt for PFOA/PFOS (EPA April 2024 rule) is not enforceable until April 2029. Detections above 4 ppt but below 10 ppt are below current MCL but above the future federal limit.

Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) — per-system federal sampling, 2023–2025. EPA UCMR5 monitoring program →

Understand PFAS health context and filtration →

Lead Service Line Inventory

Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:

0
Confirmed Lead
30
Galvanized — Replacement Required
417
Unknown Material
20,770
Confirmed Non-Lead

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Reported all required service line types
Latest tap sample on 2025-07-01 did not exceed the federal lead action level.
Population served: 58,441
Reported to Connecticut

Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

How Water Systems Appear in Rankings

Water systems are evaluated by violation history, contaminant detections, and service population. Larger systems with more service connections appear in more rankings.

Frequently Asked Questions

Is water from Meriden Water Division safe to drink?
Meriden Water Division has a C safety grade based on 5 recorded violations. Some contaminants may exceed EPA limits — independent testing is recommended.
What contaminants are in Meriden Water Division's water?
Detected contaminants include Surface Water Treatment Rule, Stage 1 DBP Rule, Contaminant 0700. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 3 contaminants above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does Meriden Water Division serve?
Meriden Water Division serves approximately 58,441 people with drinking water across 6 ZIP codes.
What is Meriden Water Division's water source?
Meriden Water Division draws water from surface water sources. Source type affects which contaminants are most likely to be present.
Is there lead in Meriden Water Division's water?
The maximum detected lead level is 0.0013 mg/L. This is within EPA action level guidelines.
What is the demographic profile of Meriden Water Division's service area?
The Meriden Water Division service area has a median household income of $101,757. Demographic data is sourced from the U.S. Census Bureau and EPA EJScreen.
Where does Meriden Water Division get its water?
Meriden Water Division's water is drawn from rivers, lakes, or reservoirs. Surface water sources are more exposed to agricultural runoff, stormwater, and upstream discharges, but they typically receive more intensive treatment before reaching your tap. Based on violation history and environmental factors, the source contamination risk is currently elevated.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

Meriden Water Division (EPA ID: CT0800011) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Connecticut Meriden Water Division

Get safety alerts for Meriden Water Division, Connecticut

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found — check filter options Free tool — no phone call required.