Redmond Water Department
EPA ID: OR4100693 · 37,566 people served · 2 ZIP codes
In the most recent five-year monitoring window, Redmond Water Department posted zero EPA violations serving 37,566 residents.
Data: EPA SDWIS Last verified: 2026-04-02
Service Area Map
Coverage area for Redmond Water Department Source: EPA SDWIS service area boundaries.
Service area boundary — Grade B
Service Area Demographics
The Redmond Water Department serves a community with a median household income of $106,268 and an estimated 47,328 residents across its service area.
Environmental Justice Note: 42% of the population in this service area is classified as disadvantaged under EPA's EJScreen criteria. Communities with higher disadvantaged populations often face disproportionate environmental and health burdens, including aging water infrastructure and limited resources for remediation.
💧 Where Does Your Water Come From?
Redmond Water Department's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.
About 2% of homes in Crook County, Oregon rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.
Infrastructure Risk
Comparable Water Systems
Similar-sized systems in Oregon
System Overview
REDMOND WATER DEPARTMENT (EPA ID: OR4100693) is a community water system in Oregon that serves approximately 37,566 people from groundwater sources.
This system provides water to 2 ZIP codes across 2 communities.
Average Home Safety Score: B (83/100)
Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.
Violation History
Lead & Copper
EPA Lead and Copper Rule sampling data for ZIP codes served by this system:
| ZIP Code | Lead Level | Exceeds Limit | Sample Date |
|---|---|---|---|
| 97756 | 0.001 mg/L | No | N/A |
Radon Risk in Service Area
Dominant radon zone for ZIP codes served by this system: Zone 3 (Low Risk)
Need help with your water quality?
Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400
Find the Right Water FilterFree tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.
ZIP Codes Served
Coverage: 1 ZIP code confirmed via EPA Community Water System Service Area Boundaries v3 plus 1 additional ZIP inferred from SDWIS registry data. The EPA-confirmed set is the most reliable; SDWIS-inferred entries may be narrower than the real deployment area.
Data Sources
This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Redmond Water Department (OR4100693) on EPA.gov.
Frequently Asked Questions
Is Redmond Water Department water safe to drink?
Based on EPA records, Redmond Water Department has no recorded violations in the past 5 years — a positive indicator of water quality management.
How many people does Redmond Water Department serve?
Redmond Water Department serves approximately 37,566 people across 2 ZIP codes in Oregon.
Where does Redmond Water Department get its water?
The primary water source is groundwater.
Contact Your Water Utility
Public-record contact information for the water utility serving this system. Use these channels to request water quality reports, ask about service, or report issues directly.
Contact information from City of Redmond Consumer Confidence Report.
ZipCheckup is not affiliated with this water utility, does not act as its agent, and does not provide customer support for it. Contact details shown are public-record information from CCR filings. For service issues, contact the utility directly using the information above.
Water Source & Treatment
Where this water originates and how it's treated before reaching your tap.
Source: City of Redmond Consumer Confidence Report.
ZipCheckup is not affiliated with this water utility. Treatment and source data are sourced from the utility's published CCR filings.
All surface waters in Washington State are given a contamination susceptibility rating of 'high'. Contamination that might occur would most likely be from soil erosion or animal activity. Redmond maintains compliance with the three components of the Washington State Source Water Assessment Program.
Treatment regime
How this utility classifies its treatment process and what each reported treatment chemical does.
Treatment chemicals and what each one does
Chemical names are reported verbatim by the utility. Purpose categories are ZipCheckup annotations based on standard drinking-water treatment practice.
Watershed exposure sources reported
Land-use and natural conditions identified in the utility's source-water assessment as potential contamination sources upstream of treatment.
Treatment classification and chemical list sourced from City of Redmond Consumer Confidence Report.
Treatment intensity is a ZipCheckup-derived classification based on the chemicals and processes the utility reports. Chemicals and contamination sources are taken verbatim from the utility's CCR filing. Routine federal monitoring and contaminant testing shown elsewhere on this page determine whether the water meets safety standards, not the treatment classification.
Federal UCMR5 PFAS Monitoring: Tested Clean
This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). No PFAS compounds were detected.
Current MCL reflects the lowest state-enforceable limit (NYS 10 ppt for PFOA/PFOS, effective August 2020). The federal final MCL of 4 ppt for PFOA/PFOS (EPA April 2024 rule) is not enforceable until April 2029. Detections above 4 ppt but below 10 ppt are below current MCL but above the future federal limit.
Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) — per-system federal sampling, 2023–2025. EPA UCMR5 monitoring program →
PFAS Substances Detected in This System
This water system's Consumer Confidence Report disclosed the following PFAS compounds. Levels are from the utility's most recent reporting cycle.
In April 2024, EPA finalized the first National Primary Drinking Water Regulation for six PFAS. Public water systems have until 2029 to comply. EPA — PFAS regulation overview →
Source: Consumer Confidence Report disclosed by City of Redmond.
ZipCheckup is not affiliated with this water utility. PFAS detection data is sourced from public Consumer Confidence Reports filed by the utility itself.
The City has no lead service lines. The Lead Service Line Inventory (LSLI) was submitted to the Washington Department of Health on Oct. 1, 2024.
Lead Service Line Replacement Tracker
This water utility's lead service line (LSL) replacement program is tracked from public Consumer Confidence Report filings. Email signup notifies subscribers when the utility files an updated replacement plan or progress milestone.
City of Redmond
ZipCheckup is not affiliated with this water utility. LSL replacement-program data is sourced from public CCR filings published by the utility. Subscription notifications are based on automated parsing of subsequent CCR releases.
Learn more about Lead and Copper Rule replacement requirements →
Lead Service Line Inventory
Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:
This system reports zero confirmed lead service lines in its inventory. Unknown-material counts may still warrant verification.
Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.
Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026
ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.
Notable events and violations
This section summarizes events the utility chose to disclose in its most recent Consumer Confidence Report, plus any federal compliance violations the utility recorded against itself. Both lists are utility-authored — ZipCheckup does not audit, judge, or reorder them.
Federal compliance violations on record
These entries are taken verbatim from the utility's CCR violations section. EPA defines four broad violation categories: Maximum Contaminant Level (MCL), Treatment Technique (TT), Monitoring & Reporting (M&R), and Public Notification (PN).
-
MCL · Perfluorooctanesulfonic Acid (PFOS)Date not published
PFOS level of 15 ppt exceeded the MCL of 4 ppt.
Violations record from City of Redmond Consumer Confidence Report.
ZipCheckup note: items above reflect what the utility published in its most recent CCR. Federal violation records are also tracked separately by the EPA Safe Drinking Water Information System (SDWIS) — the SDWIS record is the authoritative federal source for any specific regulatory action.