Water System Report MA

Gloucester Public Utility Division

EPA ID: MA3107000 · 37,440 people served · 2 ZIP codes

Water monitoring for Gloucester Public Utility Division: clean, five years, 37,440 residents.

Data: EPA SDWIS Last verified: 2026-04-02

C · 63
Avg Safety Score
37,440
People Served
2
ZIP Codes Served
0
Violations (5yr)
Surface Water
Water Source
0.003 mg/L
Max Lead Level
Zone 1
Radon Risk · High
0
Contaminants Flagged

Service Area Map

Coverage area for Gloucester Public Utility Division Source: EPA SDWIS service area boundaries.

Service area boundary — Grade C

Service Area Demographics

$87,898
Median Household Income
29,862
Service Area Population
27%
Disadvantaged Population
30th
Poverty Percentile
60th
Energy Burden Percentile
81%
Pre-1986 Housing

The Gloucester Public Utility Division serves a community with a median household income of $87,898 and an estimated 29,862 residents across its service area. Approximately 81% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

🌊 Where Does Your Water Come From?

Surface Water

Gloucester Public Utility Division's water is drawn from rivers, lakes, or reservoirs. Surface water sources are more exposed to agricultural runoff, stormwater, and upstream discharges, but they typically receive more intensive treatment before reaching your tap.

Moderate Risk
Source Contamination Risk
40th
Wastewater Discharge Proximity
70th
Superfund Site Proximity

About 1% of homes in Essex County, Massachusetts rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Superfund Proximity Note: This service area ranks in the 70th percentile nationally for proximity to Superfund (NPL) sites.

Infrastructure Risk

63 yr
Avg Pipe Age
Galvanized Steel or Copper
Pipe Material
10 yr
Est. Remaining Life
Moderate Wear
Decay Status
Installed 86% of expected lifespan used End of life

Comparable Water Systems

Similar-sized systems in Massachusetts

C 1 violation
Mashpee Water District
36,922 people
B 3 violations
Andover Water Department
36,569 people
D 5 violations
A 0 violations
C 0 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Flood Insurance Radon Mitigation
Flood Insurance $1,500
Radon Mitigation $1,200
Total Estimated Cost $2,700

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

System Overview

Gloucester Public Utility Division (EPA ID: MA3107000) is a community water system in Massachusetts that serves approximately 37,440 people from surface water sources.

This system provides water to 2 ZIP codes across 1 community.

Average Home Safety Score: C (63/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

No violations recorded — This water system has no recorded EPA violations in the past 5 years.

Lead & Copper

EPA Lead and Copper Rule sampling data for ZIP codes served by this system:

ZIP Code Lead Level Exceeds Limit Sample Date
01930 0.003 mg/L No N/A
01931 0.003 mg/L No N/A

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 1 (High Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Coverage: 1 ZIP code confirmed via EPA Community Water System Service Area Boundaries v3 plus 1 additional ZIP inferred from SDWIS registry data. The EPA-confirmed set is the most reliable; SDWIS-inferred entries may be narrower than the real deployment area.

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Gloucester Public Utility Division (MA3107000) on EPA.gov.

Frequently Asked Questions

Is Gloucester Public Utility Division water safe to drink?

Based on EPA records, Gloucester Public Utility Division has no recorded violations in the past 5 years — a positive indicator of water quality management.

How many people does Gloucester Public Utility Division serve?

Gloucester Public Utility Division serves approximately 37,440 people across 2 ZIP codes in Massachusetts.

Where does Gloucester Public Utility Division get its water?

The primary water source is surface water.

Contact Your Water Utility

Public-record contact information for the water utility serving this system. Use these channels to request water quality reports, ask about service, or report issues directly.

Phone
978-325-5220
ZipCheckup is not affiliated with this water utility, does not act as its agent, and does not provide customer support for it. Contact details shown are public-record information from CCR filings. For service issues, contact the utility directly using the information above.
Address
3 Pond Rd., Gloucester, MA 01930

Contact information from City of Gloucester Consumer Confidence Report.

ZipCheckup is not affiliated with this water utility, does not act as its agent, and does not provide customer support for it. Contact details shown are public-record information from CCR filings. For service issues, contact the utility directly using the information above.

Water Source & Treatment

Where this water originates and how it's treated before reaching your tap.

Source
Surface water
Drawn from rivers, lakes, or reservoirs.
Disinfectant used
Chlorine
Treatment chemicals reported
chlorinefluorideorthophosphate

Source: City of Gloucester Consumer Confidence Report.

ZipCheckup is not affiliated with this water utility. Treatment and source data are sourced from the utility's published CCR filings.

Source water assessment from City of Gloucester Consumer Confidence Report:
MassDEP has prepared a Source Water Assessment & Protection (SWAP) Report for Gloucester’s water system supply. The report identifies sources of potential contamination and assesses the susceptibility of the public water supply.

Treatment regime

How this utility classifies its treatment process and what each reported treatment chemical does.

Treatment classification
Multi-stage
Multiple treatment stages — typically coagulation, filtration, and disinfection. Common for surface-water systems requiring removal of particulates, microorganisms, and dissolved organic compounds before disinfection.

Treatment chemicals and what each one does

Chemical names are reported verbatim by the utility. Purpose categories are ZipCheckup annotations based on standard drinking-water treatment practice.

Disinfectant
Inactivates bacteria, viruses, and parasites in the treated water.
chlorine
Corrosion inhibitor
Coats pipe interiors to reduce lead and copper leaching from premise plumbing.
orthophosphate
Fluoridation
Added at low levels per state or local public-health policy for dental health.
fluoride

Treatment classification and chemical list sourced from City of Gloucester Consumer Confidence Report.

Treatment intensity is a ZipCheckup-derived classification based on the chemicals and processes the utility reports. Chemicals and contamination sources are taken verbatim from the utility's CCR filing. Routine federal monitoring and contaminant testing shown elsewhere on this page determine whether the water meets safety standards, not the treatment classification.

Federal UCMR5 PFAS Monitoring: Tested Clean

This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). No PFAS compounds were detected.

Samples collected
232

Current MCL reflects the lowest state-enforceable limit (NYS 10 ppt for PFOA/PFOS, effective August 2020). The federal final MCL of 4 ppt for PFOA/PFOS (EPA April 2024 rule) is not enforceable until April 2029. Detections above 4 ppt but below 10 ppt are below current MCL but above the future federal limit.

Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) — per-system federal sampling, 2023–2025. EPA UCMR5 monitoring program →

Understand PFAS health context and filtration →

Lead service line replacement plan from City of Gloucester Consumer Confidence Report:
The City of Gloucester DPW is working on developing a lead service line inventory and will be conducting a lead service line survey later this year if we have identified a lead service line.

Lead Service Line Replacement Tracker

This water utility's lead service line (LSL) replacement program is tracked from public Consumer Confidence Report filings. Email signup notifies subscribers when the utility files an updated replacement plan or progress milestone.

Get notified on replacement progress

Subscribers receive an email when this utility updates its LSL plan, files a milestone report, or adjusts replacement timelines. No marketing, no third-party sharing.

By submitting you agree to Privacy Policy. Unsubscribe anytime via the link in any email.

City of Gloucester

ZipCheckup is not affiliated with this water utility. LSL replacement-program data is sourced from public CCR filings published by the utility. Subscription notifications are based on automated parsing of subsequent CCR releases.

Learn more about Lead and Copper Rule replacement requirements →

Lead Service Line Inventory

Utility-reported lead service line presence and tap-sample lead level under federal LCRI requirements:

None reported
Lead Service Lines Reported
0.003 mg/L
Tap Sample Lead Level

Below federal action level (0.015 mg/L)

MassDEP reports utility-level presence flag and tap-sampling without per-line breakdown. Customers should inquire with the utility about service line material at a specific address.

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Did not report any required service line types
Latest tap sample on 2021-01-01 did not exceed the federal lead action level.
Population served: 37,440
Reported to Massachusetts

Source: MassDEP LCRR Service Line Inventory · Submitted 2024

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

Notable events and violations

This section summarizes events the utility chose to disclose in its most recent Consumer Confidence Report, plus any federal compliance violations the utility recorded against itself. Both lists are utility-authored — ZipCheckup does not audit, judge, or reorder them.

Federal compliance violations on record

These entries are taken verbatim from the utility's CCR violations section. EPA defines four broad violation categories: Maximum Contaminant Level (MCL), Treatment Technique (TT), Monitoring & Reporting (M&R), and Public Notification (PN).

  • monitoring · Distribution Systems flushing
    Date not published
    In 2023, there was one violation for not following protocols for Distribution Systems flushing.

Violations record from City of Gloucester Consumer Confidence Report.

ZipCheckup note: items above reflect what the utility published in its most recent CCR. Federal violation records are also tracked separately by the EPA Safe Drinking Water Information System (SDWIS) — the SDWIS record is the authoritative federal source for any specific regulatory action.

Frequently Asked Questions

Is water from Gloucester Public Utility Division safe to drink?
Gloucester Public Utility Division has a C safety grade based on 0 recorded violations. Some contaminants may exceed EPA limits — independent testing is recommended.
Should I use a water filter?
Gloucester Public Utility Division meets EPA standards, but a water filter can reduce trace contaminants below detectable levels for added peace of mind.
How many people does Gloucester Public Utility Division serve?
Gloucester Public Utility Division serves approximately 37,440 people with drinking water across 2 ZIP codes.
What is Gloucester Public Utility Division's water source?
Gloucester Public Utility Division draws water from surface water sources. Source type affects which contaminants are most likely to be present.
Is there lead in Gloucester Public Utility Division's water?
The maximum detected lead level is 0.003 mg/L. This is within EPA action level guidelines.
What is the demographic profile of Gloucester Public Utility Division's service area?
The Gloucester Public Utility Division service area has a median household income of $87,898. Demographic data is sourced from the U.S. Census Bureau and EPA EJScreen.
Where does Gloucester Public Utility Division get its water?
Gloucester Public Utility Division's water is drawn from rivers, lakes, or reservoirs. Surface water sources are more exposed to agricultural runoff, stormwater, and upstream discharges, but they typically receive more intensive treatment before reaching your tap. Based on available data, the source contamination risk is moderate.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

Gloucester Public Utility Division (EPA ID: MA3107000) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Massachusetts Gloucester Public Utility Division

Get safety alerts for Gloucester Public Utility Division, Massachusetts

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Check your water filter options Free tool — no phone call required.