Copper in Laguna Hills, CA Drinking Water
Copper data for Laguna Hills, California · 29,596 residents · 2 ZIP codes
Across Laguna Hills, California, federal monitoring data has captured Copper in water samples at detectable concentrations in the most recent available reporting cycle.
Data: EPA SDWIS, CCR Reports, ECHO Last verified: 2026-04-05
Copper in Laguna Hills Tap Water
Copper has been detected in Laguna Hills, California drinking water at a maximum level of 1.3 ppb — below the EPA action level of 1.3 mg/L (action level).
This analysis covers 29,596 residents across 2 ZIP codes in Laguna Hills.
Laguna Hills's overall water quality grade is A (95/100).
Is Copper in Laguna Hills Water Safe?
Copper was detected in Laguna Hills water but currently falls within EPA limits. However, some health organizations argue the EPA action level may not be protective enough.
If you are concerned, a reverse osmosis or nsf 53 carbon block filter can reduce copper levels further.
Copper Levels by ZIP Code
| ZIP Code | Copper Level | EPA Limit | Status |
|---|---|---|---|
| 92653 | 1.3 ppm | 1.3 mg/L (action level) | OK |
| 92654 | 1.3 ppm | 1.3 mg/L (action level) | OK |
Average copper level across Laguna Hills: 1.3 ppb
Health Effects of Copper
- Nausea, vomiting, and diarrhea (short-term, high levels)
- Liver and kidney damage (long-term)
- Particularly dangerous for people with Wilson's disease
- Infants are more sensitive than adults
Health risk severity: Moderate. Governed by the Lead and Copper Rule.
How Copper Gets Into Drinking Water
- Corrosion of copper household plumbing
- Acidic (low pH) water accelerates copper leaching
- New copper pipes leach more than aged ones
- Mining and industrial discharge (rare for tap water)
What to Do About Copper in Laguna Hills Water
- Run water for 30-60 seconds before use (flushes stagnant water)
- Install an NSF 53 or NSF 58 certified filter
- If pH is low, consider a whole-home acid neutralizer
- Test first-draw morning water to check actual copper levels
Look for filters certified under NSF 53 for copper removal.