Health Violations Found WI 2 HEALTH VIOLATIONS

Plain Waterworks

EPA ID: WI1570098 · 792 people served · 1 ZIP code

While corrective steps may be in progress, Plain Waterworks currently shows 4 EPA violations unresolved — serving a population of approximately 792.

Data: EPA SDWIS Last verified: 2026-04-02

B · 77
Avg Safety Score
792
People Served
1
ZIP Code Served
9
Violations (5yr)
Groundwater
Water Source
0.0027 mg/L
Max Lead Level
Zone 2
Radon Risk · Moderate
3
Contaminants Flagged
$248K
Median Home Value in Service Area

Service Area Map

Coverage area for Plain Waterworks Source: EPA SDWIS service area boundaries.

Service area boundary — Grade B

Service Area Demographics

$88,750
Median Household Income
1,305
Service Area Population
8%
Disadvantaged Population
50th
Poverty Percentile
50th
Energy Burden Percentile
77%
Pre-1986 Housing

The Plain Waterworks serves a community with a median household income of $88,750 and an estimated 1,305 residents across its service area. Approximately 77% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

💧 Where Does Your Water Come From?

Groundwater

Plain Waterworks's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Elevated Risk
Source Contamination Risk
30th
Wastewater Discharge Proximity
50th
Superfund Site Proximity

About 2% of homes in Sauk County, Wisconsin rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Infrastructure Risk

76 yr
Avg Pipe Age
Galvanized Steel or Copper
Pipe Material
0 yr
Est. Remaining Life
Moderate Wear
Decay Status
Installed 100% of expected lifespan used End of life

Detected Contaminants

How Plain Waterworks compares to EPA limits

What This Means For You

Stage 2 DBP Rule at 5 mg/L exceeds the EPA maximum of mg/L.

Lead and Copper Rule at 3 mg/L exceeds the EPA maximum of mg/L.

Stage 1 DBP Rule at 1 mg/L exceeds the EPA maximum of mg/L.

Comparable Water Systems

Similar-sized systems in Wisconsin

Stoddard Waterworks
793 people
0 violations
Elmwood Waterworks
798 people
C 4 violations
0 violations
C 0 violations
C 0 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Radon Mitigation Water Filtration
Radon Mitigation $400
Water Filtration $300
Total Estimated Cost $700

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $1,000

Annual per household (CDC est.)

Estimated Cumulative Cost Per Household

5 years
$5,000
10 years
$10,000
20 years
$20,000

Compare: Estimated remediation cost is $700 (one-time) vs. $10,000 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

Plain Waterworks (EPA ID: WI1570098) is a community water system in Wisconsin that serves approximately 792 people from groundwater sources.

This system serves ZIP code 53577 in Plain.

Average Home Safety Score: B (77/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

2 health-based violations recorded in the past 5 years. 4 remain unresolved.

Recent Violations

Date Contaminant Type Status
July 2, 2025 Stage 2 DBP Rule Monitoring Resolved
October 17, 2024 Stage 2 DBP Rule Health-based Resolved
October 17, 2024 Lead and Copper Rule Monitoring Unresolved
October 17, 2024 Stage 2 DBP Rule Monitoring Resolved
January 1, 2023 Lead and Copper Rule Monitoring Resolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Stage 2 DBP Rule Treatment Failure 5 Yes
Lead and Copper Rule Treatment Failure 3 No
Stage 1 DBP Rule Treatment Failure 1 No

Lead & Copper

EPA Lead and Copper Rule sampling data for ZIP codes served by this system:

ZIP Code Lead Level Exceeds Limit Sample Date
53577 0.0027 mg/L No N/A

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 2 (Moderate Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Plain Waterworks (WI1570098) on EPA.gov.

Frequently Asked Questions

Is Plain Waterworks water safe to drink?

Plain Waterworks has recorded 2 health-based violations in the past 5 years. While the system is required to treat water to meet federal standards, you may want to consider additional precautions such as a certified water filter.

How many people does Plain Waterworks serve?

Plain Waterworks serves approximately 792 people across 1 ZIP code in Wisconsin.

Where does Plain Waterworks get its water?

The primary water source is groundwater.

Lead Service Line Inventory

Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:

0
Confirmed Lead
9
Galvanized — Replacement Required
140
Unknown Material
267
Confirmed Non-Lead

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Reported all required service line types
Latest tap sample on 2023-06-01 did not exceed the federal lead action level.
Reporting compliance issue flagged by EPA under Rule 2E.
Population served: 792
Reported to Wisconsin

Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

Frequently Asked Questions

Is water from Plain Waterworks safe to drink?
Plain Waterworks earns a B safety grade with 9 violations in the past 5 years. Tap water meets EPA standards for most contaminants.
What contaminants are in Plain Waterworks's water?
Detected contaminants include Stage 2 DBP Rule, Lead and Copper Rule, Stage 1 DBP Rule. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 3 contaminants above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does Plain Waterworks serve?
Plain Waterworks serves approximately 792 people with drinking water across 1 ZIP code.
What is Plain Waterworks's water source?
Plain Waterworks draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
Is there lead in Plain Waterworks's water?
The maximum detected lead level is 0.0027 mg/L. This is within EPA action level guidelines.
What is the demographic profile of Plain Waterworks's service area?
The Plain Waterworks service area has a median household income of $88,750. Demographic data is sourced from the U.S. Census Bureau and EPA EJScreen.
Where does Plain Waterworks get its water?
Plain Waterworks's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table. Based on violation history and environmental factors, the source contamination risk is currently elevated.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

Plain Waterworks (EPA ID: WI1570098) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Wisconsin Plain Waterworks

Get safety alerts for Plain Waterworks, Wisconsin

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found — check filter options Free tool — no phone call required.