Health Violations Found WA 1 HEALTH VIOLATION

Basin City Water Sewer District

EPA ID: WA5304461 · 1,740 people served · 1 ZIP code

Within the EPA compliance database, Basin City Water Sewer District shows 3 violations still pending resolution — a status that applies across the full service territory of approximately 1,740 people and reflects findings that have not yet cleared the federal enforcement process or received formal closure.

Data: EPA SDWIS Last verified: 2026-04-02

C · 62
Avg Safety Score
1,740
People Served
1
ZIP Code Served
16
Violations (5yr)
Groundwater
Water Source
0.01 mg/L
Max Lead Level
Zone 2
Radon Risk · Moderate
7
Contaminants Flagged
$245K
Median Home Value in Service Area

Service Area Map

Coverage area for Basin City Water Sewer District Source: EPA SDWIS service area boundaries.

Service area boundary — Grade C

Service Area Demographics

$72,400
Median Household Income
3,236
Service Area Population
42%
Disadvantaged Population
60th
Poverty Percentile
40th
Energy Burden Percentile
67%
Pre-1986 Housing

The Basin City Water Sewer District serves a community with a median household income of $72,400 and an estimated 3,236 residents across its service area. Approximately 67% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

Environmental Justice Note: 42% of the population in this service area is classified as disadvantaged under EPA's EJScreen criteria. Communities with higher disadvantaged populations often face disproportionate environmental and health burdens, including aging water infrastructure and limited resources for remediation.

💧 Where Does Your Water Come From?

Groundwater

Basin City Water Sewer District's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Elevated Risk
Source Contamination Risk
10th
Wastewater Discharge Proximity
70th
Superfund Site Proximity

About 1% of homes in Franklin County, Washington rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Superfund Proximity Note: This service area ranks in the 70th percentile nationally for proximity to Superfund (NPL) sites. Groundwater sources near contaminated sites may face elevated risk from industrial chemicals.

Infrastructure Risk

53 yr
Avg Pipe Age
Copper
Pipe Material
17 yr
Est. Remaining Life
Moderate Wear
Decay Status
Installed 76% of expected lifespan used End of life

Detected Contaminants

How Basin City Water Sewer District compares to EPA limits

Lead 4 mg/L (action level) (EXCEEDS LIMIT)
0 EPA Limit: 0.015 mg/L (action level)
Brain damage in children, kidney & blood pressure in adults
Haloacetic Acids (HAA5) 1 mg/L (EXCEEDS LIMIT)
0 EPA Limit: 0.06 mg/L
Cancer risk; reproductive & developmental effects
Total Trihalomethanes (TTHM) 1 mg/L (EXCEEDS LIMIT)
0 EPA Limit: 0.08 mg/L
Bladder & rectal cancer risk; reproductive concerns

What This Means For You

Lead at 4 mg/L (action level) exceeds the EPA maximum of 0.015 mg/L (action level). Brain damage in children, kidney & blood pressure in adults. Consider reverse osmosis filtration.

Haloacetic Acids (HAA5) at 1 mg/L exceeds the EPA maximum of 0.06 mg/L. Cancer risk; reproductive & developmental effects. Consider granular activated carbon (GAC) filtration.

Total Trihalomethanes (TTHM) at 1 mg/L exceeds the EPA maximum of 0.08 mg/L. Bladder & rectal cancer risk; reproductive concerns. Consider granular activated carbon (GAC) filtration.

Consumer Confidence Report Rule at 6 mg/L exceeds the EPA maximum of mg/L.

Surface Water Treatment Rule at 2 mg/L exceeds the EPA maximum of mg/L.

Lead was detected in this water system. reverse osmosis filtration can reduce exposure.

Find a certified water filter →

Comparable Water Systems

Similar-sized systems in Washington

Sumas Water Department
1,740 people
B 0 violations
City of Entiat
1,730 people
B 2 violations
B 4 violations
0 violations
B 3 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Radon Mitigation Water Filtration
Radon Mitigation $400
Water Filtration $300
Total Estimated Cost $700

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $1,500

Annual per household (CDC est.)

Estimated Cumulative Cost Per Household

5 years
$7,500
10 years
$15,000
20 years
$30,000

Compare: Estimated remediation cost is $700 (one-time) vs. $15,000 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

Basin City Water Sewer District (EPA ID: WA5304461) is a community water system in Washington that serves approximately 1,740 people from groundwater sources.

This system serves ZIP code 99343 in Mesa.

Average Home Safety Score: C (62/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

1 health-based violation recorded in the past 5 years. 3 remain unresolved.

Recent Violations

Date Contaminant Type Status
July 1, 2025 Surface Water Treatment Rule Monitoring Resolved
January 1, 2025 Lead Health-based Unresolved
May 1, 2024 Consumer Confidence Report Rule Monitoring Resolved
January 1, 2024 Contaminant 2440 Monitoring Resolved
July 1, 2023 Surface Water Treatment Rule Monitoring Resolved
April 1, 2023 Consumer Confidence Report Rule Monitoring Resolved
January 1, 2023 Lead Monitoring Unresolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Consumer Confidence Report Rule Reporting Failure 6 No
Lead Inorganic 4 Yes
Surface Water Treatment Rule Treatment Failure 2 No
Contaminant 2440 Other Violation 1 No
Total Trihalomethanes (TTHM) Disinfection Byproducts 1 No
Haloacetic Acids (HAA5) Disinfection Byproducts 1 No
Stage 1 DBP Rule Treatment Failure 1 No

Health Risk Details

Lead (EPA limit: 0.015 mg/L (action level))

Brain damage in children, kidney & blood pressure in adults At-risk groups: infants, children under 6, pregnant women.

Removal methods: reverse osmosis, distillation, certified carbon block filter (NSF/ANSI 53). Find the right filter →

Lead & Copper

EPA Lead and Copper Rule sampling data for ZIP codes served by this system:

ZIP Code Lead Level Exceeds Limit Sample Date
99343 0.01 mg/L No N/A

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 2 (Moderate Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Basin City Water Sewer District (WA5304461) on EPA.gov.

Frequently Asked Questions

Is Basin City Water Sewer District water safe to drink?

Basin City Water Sewer District has recorded 1 health-based violation in the past 5 years. While the system is required to treat water to meet federal standards, you may want to consider additional precautions such as a certified water filter.

How many people does Basin City Water Sewer District serve?

Basin City Water Sewer District serves approximately 1,740 people across 1 ZIP code in Washington.

Where does Basin City Water Sewer District get its water?

The primary water source is groundwater.

Lead Service Line Inventory

Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:

0
Confirmed Lead
0
Galvanized — Replacement Required
0
Unknown Material
252
Confirmed Non-Lead

This system reports zero confirmed lead service lines in its inventory. Unknown-material counts may still warrant verification.

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Reported all required service line types
Latest tap sample on 2022-01-01 did not exceed the federal lead action level.
Population served: 1,740
Reported to Washington

Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

Frequently Asked Questions

Is water from Basin City Water Sewer District safe to drink?
Basin City Water Sewer District has a C safety grade based on 16 recorded violations. Some contaminants may exceed EPA limits — independent testing is recommended.
What contaminants are in Basin City Water Sewer District's water?
Detected contaminants include Lead, Haloacetic Acids (HAA5), Total Trihalomethanes (TTHM), Consumer Confidence Report Rule. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 5 contaminants above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does Basin City Water Sewer District serve?
Basin City Water Sewer District serves approximately 1,740 people with drinking water across 1 ZIP code.
What is Basin City Water Sewer District's water source?
Basin City Water Sewer District draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
Is there lead in Basin City Water Sewer District's water?
The maximum detected lead level is 0.01 mg/L. This is within EPA action level guidelines.
What is the demographic profile of Basin City Water Sewer District's service area?
The Basin City Water Sewer District service area has a median household income of $72,400. EPA EJScreen data classifies 42% of the population as disadvantaged, which may indicate greater vulnerability to environmental health risks.
Where does Basin City Water Sewer District get its water?
Basin City Water Sewer District's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table. Based on violation history and environmental factors, the source contamination risk is currently elevated.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

Basin City Water Sewer District (EPA ID: WA5304461) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Washington Basin City Water Sewer District

Get safety alerts for Basin City Water Sewer District, Washington

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found — check filter options Free tool — no phone call required.