Health Violations Found TX 3 HEALTH VIOLATIONS

Sanford Municipal Water System

EPA ID: TX1170018 · 120 people served · 1 ZIP code

3 open EPA findings remain on record at Sanford Municipal Water System — the utility supplies approximately 120 people.

Data: EPA SDWIS Last verified: 2026-04-02

D · 46
Avg Safety Score
120
People Served
1
ZIP Code Served
9
Violations (5yr)
Groundwater
Water Source
0.014 mg/L
Max Lead Level
Zone 2
Radon Risk · Moderate
4
Contaminants Flagged

Compliance Trajectory

Stable · Risk tier: High · 95% chance of violation in next 12 months

Violations went from 2 (2023) to 1 (2024). Violation counts have remained relatively steady.

Service Area Map

Coverage area for Sanford Municipal Water System Source: EPA SDWIS service area boundaries.

Service area boundary — Grade D

💧 Where Does Your Water Come From?

Groundwater

Sanford Municipal Water System's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Elevated Risk
Source Contamination Risk
50th
Wastewater Discharge Proximity
20th
Superfund Site Proximity

About 1% of homes in Hutchinson County, Texas rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Infrastructure Risk

53 yr
Avg Pipe Age
Copper
Pipe Material
17 yr
Est. Remaining Life
Moderate Wear
Decay Status
Installed 76% of expected lifespan used End of life

Detected Contaminants

How Sanford Municipal Water System compares to EPA limits

What This Means For You

Stage 1 DBP Rule at 3 mg/L exceeds the EPA maximum of mg/L.

Lead and Copper Rule at 3 mg/L exceeds the EPA maximum of mg/L.

Stage 2 DBP Rule at 2 mg/L exceeds the EPA maximum of mg/L.

Surface Water Treatment Rule at 1 mg/L exceeds the EPA maximum of mg/L.

Comparable Water Systems

Similar-sized systems in Texas

0 violations
Eldorado Water
120 people
0 violations
0 violations
0 violations
B 5 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Water Filtration Radon Mitigation
Water Filtration $600
Radon Mitigation $400
Total Estimated Cost $1,000

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $1,000

Annual per household (CDC est.)

Estimated Cumulative Cost Per Household

5 years
$5,000
10 years
$10,000
20 years
$20,000

Compare: Estimated remediation cost is $1,000 (one-time) vs. $10,000 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

Sanford Municipal Water System (EPA ID: TX1170018) is a community water system in Texas that serves approximately 120 people from groundwater sources.

This system serves ZIP code 79078 in Sanford.

Average Home Safety Score: D (46/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

3 health-based violations recorded in the past 5 years. 3 remain unresolved.

Recent Violations

Date Contaminant Type Status
May 1, 2025 Lead and Copper Rule Monitoring Unresolved
October 17, 2024 Stage 2 DBP Rule Health-based Unresolved
October 17, 2024 Stage 2 DBP Rule Monitoring Unresolved
April 1, 2023 Stage 1 DBP Rule Health-based Resolved
March 31, 2023 Stage 1 DBP Rule Health-based Resolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Stage 1 DBP Rule Treatment Failure 3 Yes
Lead and Copper Rule Treatment Failure 3 No
Stage 2 DBP Rule Treatment Failure 2 Yes
Surface Water Treatment Rule Treatment Failure 1 No

Lead & Copper

EPA Lead and Copper Rule sampling data for ZIP codes served by this system:

ZIP Code Lead Level Exceeds Limit Sample Date
79078 0.014 mg/L No N/A

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 2 (Moderate Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Sanford Municipal Water System (TX1170018) on EPA.gov.

Frequently Asked Questions

Is Sanford Municipal Water System water safe to drink?

Sanford Municipal Water System has recorded 3 health-based violations in the past 5 years. While the system is required to treat water to meet federal standards, you may want to consider additional precautions such as a certified water filter.

How many people does Sanford Municipal Water System serve?

Sanford Municipal Water System serves approximately 120 people across 1 ZIP code in Texas.

Where does Sanford Municipal Water System get its water?

The primary water source is groundwater.

Lead Service Line Inventory

Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:

0
Confirmed Lead
1
Galvanized — Replacement Required
61
Unknown Material
14
Confirmed Non-Lead

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Reported all required service line types
Latest tap sample on 2024-01-01 did not exceed the federal lead action level.
Population served: 120
Reported to Texas

Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

Frequently Asked Questions

Is water from Sanford Municipal Water System safe to drink?
Sanford Municipal Water System has a D safety grade based on 9 recorded violations. Some contaminants may exceed EPA limits — independent testing is recommended.
What contaminants are in Sanford Municipal Water System's water?
Detected contaminants include Stage 1 DBP Rule, Lead and Copper Rule, Stage 2 DBP Rule, Surface Water Treatment Rule. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 4 contaminants above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does Sanford Municipal Water System serve?
Sanford Municipal Water System serves approximately 120 people with drinking water across 1 ZIP code.
What is Sanford Municipal Water System's water source?
Sanford Municipal Water System draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
Is there lead in Sanford Municipal Water System's water?
The maximum detected lead level is 0.014 mg/L. This is within EPA action level guidelines.
Where does Sanford Municipal Water System get its water?
Sanford Municipal Water System's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table. Based on violation history and environmental factors, the source contamination risk is currently elevated.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

Sanford Municipal Water System (EPA ID: TX1170018) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Texas Sanford Municipal Water System

Get safety alerts for Sanford Municipal Water System, Texas

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found — check filter options Free tool — no phone call required.