Monitoring Violations TX

Dalhart Municipal Water System

EPA ID: TX0560001 · 8,256 people served · 1 ZIP code

Dalhart Municipal Water System carries 1 open EPA violation that remain unresolved in the federal system — approximately 8,256 people fall within its service area.

Data: EPA SDWIS Last verified: 2026-04-02

B · 73
Avg Safety Score
8,256
People Served
1
ZIP Code Served
2
Violations (5yr)
Groundwater
Water Source
Zone 2
Radon Risk · Moderate
2
Contaminants Flagged
$167K
Median Home Value in Service Area

Service Area Map

Coverage area for Dalhart Municipal Water System Source: EPA SDWIS service area boundaries.

Service area boundary — Grade B

Service Area Demographics

$78,373
Median Household Income
10,764
Service Area Population
0%
Disadvantaged Population
60th
Poverty Percentile
40th
Energy Burden Percentile
62%
Pre-1986 Housing

The Dalhart Municipal Water System serves a community with a median household income of $78,373 and an estimated 10,764 residents across its service area. Approximately 62% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

💧 Where Does Your Water Come From?

Groundwater

Dalhart Municipal Water System's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Moderate Risk
Source Contamination Risk
0th
Wastewater Discharge Proximity
0th
Superfund Site Proximity

About 0% of homes in Hartley County, Texas rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Infrastructure Risk

53 yr
Avg Pipe Age
Copper
Pipe Material
17 yr
Est. Remaining Life
Stable
Decay Status
Installed 76% of expected lifespan used End of life

Detected Contaminants

How Dalhart Municipal Water System compares to EPA limits

What This Means For You

Total Coliform at 1 presence exceeds the EPA maximum of presence.

Lead and Copper Rule at 1 mg/L exceeds the EPA maximum of mg/L.

Comparable Water Systems

Similar-sized systems in Texas

C 0 violations
Santa Fe Utility
8,265 people
0 violations
A 5 violations
City of Floresville
8,306 people
A 9 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Flood Insurance Radon Mitigation
Flood Insurance $1,200
Radon Mitigation $400
Total Estimated Cost $1,600

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $500

Annual per household (CDC est.)

Estimated Cumulative Cost Per Household

5 years
$2,500
10 years
$5,000
20 years
$10,000

Compare: Estimated remediation cost is $1,600 (one-time) vs. $5,000 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

Dalhart Municipal Water System (EPA ID: TX0560001) is a community water system in Texas that serves approximately 8,256 people from groundwater sources.

This system serves ZIP code 79022 in Dalhart.

Average Home Safety Score: B (73/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

2 monitoring/reporting violations recorded. These are procedural violations (missed tests or late reports), not necessarily water safety issues.

Recent Violations

Date Contaminant Type Status
August 29, 2023 Total Coliform Monitoring Unresolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Total Coliform Microbiological 1 No
Lead and Copper Rule Treatment Failure 1 No

Lead & Copper

No Lead and Copper Rule sampling data available for this water system.

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 2 (Moderate Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Coverage: Service area ZIP codes sourced from EPA Community Water System Service Area Boundaries v3 (March 2026 release). These ZIPs reflect the actual deployment footprint recorded by TX or modeled from parcel and building-footprint data.

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Dalhart Municipal Water System (TX0560001) on EPA.gov.

Frequently Asked Questions

Is Dalhart Municipal Water System water safe to drink?

Dalhart Municipal Water System has only monitoring/reporting violations, which are procedural in nature. The system meets federal health-based standards.

How many people does Dalhart Municipal Water System serve?

Dalhart Municipal Water System serves approximately 8,256 people across 1 ZIP code in Texas.

Where does Dalhart Municipal Water System get its water?

The primary water source is groundwater.

Federal UCMR5 PFAS Monitoring: Tested Clean

This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). No PFAS compounds were detected.

Samples collected
58

Current MCL reflects the lowest state-enforceable limit (NYS 10 ppt for PFOA/PFOS, effective August 2020). The federal final MCL of 4 ppt for PFOA/PFOS (EPA April 2024 rule) is not enforceable until April 2029. Detections above 4 ppt but below 10 ppt are below current MCL but above the future federal limit.

Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) — per-system federal sampling, 2023–2025. EPA UCMR5 monitoring program →

Understand PFAS health context and filtration →

Lead Service Line Inventory

Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:

0
Confirmed Lead
0
Galvanized — Replacement Required
4,269
Unknown Material
3
Confirmed Non-Lead

This system reports zero confirmed lead service lines in its inventory. Unknown-material counts may still warrant verification.

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Reported all required service line types
Latest tap sample on 2021-01-01 did not exceed the federal lead action level.
Population served: 8,256
Reported to Texas

Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

Frequently Asked Questions

Is water from Dalhart Municipal Water System safe to drink?
Dalhart Municipal Water System earns a B safety grade with 2 violations in the past 5 years. Tap water meets EPA standards for most contaminants.
What contaminants are in Dalhart Municipal Water System's water?
Detected contaminants include Total Coliform, Lead and Copper Rule. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 2 contaminants above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does Dalhart Municipal Water System serve?
Dalhart Municipal Water System serves approximately 8,256 people with drinking water across 1 ZIP code.
What is Dalhart Municipal Water System's water source?
Dalhart Municipal Water System draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
What is the demographic profile of Dalhart Municipal Water System's service area?
The Dalhart Municipal Water System service area has a median household income of $78,373. Demographic data is sourced from the U.S. Census Bureau and EPA EJScreen.
Where does Dalhart Municipal Water System get its water?
Dalhart Municipal Water System's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table. Based on available data, the source contamination risk is moderate.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

Dalhart Municipal Water System (EPA ID: TX0560001) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Texas Dalhart Municipal Water System

Get safety alerts for Dalhart Municipal Water System, Texas

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found — check filter options Free tool — no phone call required.