Health Violations Found OR 2 HEALTH VIOLATIONS

Shaniko Water System

EPA ID: OR4105384 · 38 people served · 2 ZIP codes

Not yet resolved: 1 EPA violation at Shaniko Water System, affecting about 38 residents.

Data: EPA SDWIS Last verified: 2026-04-02

C · 65
Avg Safety Score
38
People Served
2
ZIP Codes Served
12
Violations (5yr)
Groundwater
Water Source
0.0013 mg/L
Max Lead Level
Zone 2
Radon Risk · Moderate
4
Contaminants Flagged

Compliance Trajectory

Stable · Risk tier: High · 94% chance of violation in next 12 months

Violations went from 2 (2021) to 2 (2025). Violation counts have remained relatively steady.

Service Area Map

Coverage area for Shaniko Water System Source: EPA SDWIS service area boundaries.

Service area boundary — Grade C

💧 Where Does Your Water Come From?

Groundwater

Shaniko Water System's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Elevated Risk
Source Contamination Risk
25th
Wastewater Discharge Proximity
55th
Superfund Site Proximity

About 2% of homes in Sherman County, Oregon rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Infrastructure Risk

102 yr
Avg Pipe Age
Galvanized Steel or Copper
Pipe Material
0 yr
Est. Remaining Life
Moderate Wear
Decay Status
Installed 100% of expected lifespan used End of life

Detected Contaminants

How Shaniko Water System compares to EPA limits

What This Means For You

Consumer Confidence Report Rule at 6 mg/L exceeds the EPA maximum of mg/L.

Surface Water Treatment Rule at 4 mg/L exceeds the EPA maximum of mg/L.

Stage 1 DBP Rule at 1 mg/L exceeds the EPA maximum of mg/L.

Lead and Copper Rule at 1 mg/L exceeds the EPA maximum of mg/L.

Comparable Water Systems

Similar-sized systems in Oregon

Red Hills Estates
39 people
0 violations
0 violations
0 violations
0 violations
B 0 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Radon Mitigation Water Filtration
Radon Mitigation $400
Water Filtration $150
Total Estimated Cost $550

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $1,000

Annual per household (CDC est.)

Estimated Cumulative Cost Per Household

5 years
$5,000
10 years
$10,000
20 years
$20,000

Compare: Estimated remediation cost is $550 (one-time) vs. $10,000 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

SHANIKO WATER SYSTEM (EPA ID: OR4105384) is a community water system in Oregon that serves approximately 38 people from groundwater sources.

This system provides water to 2 ZIP codes across 2 communities.

Average Home Safety Score: C (65/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

2 health-based violations recorded in the past 5 years. 1 remains unresolved.

Recent Violations

Date Contaminant Type Status
August 1, 2025 Consumer Confidence Report Rule Health-based Unresolved
July 1, 2025 Surface Water Treatment Rule Monitoring Resolved
October 1, 2024 Stage 1 DBP Rule Monitoring Resolved
October 1, 2024 Surface Water Treatment Rule Monitoring Resolved
February 1, 2024 Consumer Confidence Report Rule Monitoring Resolved
October 1, 2023 Surface Water Treatment Rule Monitoring Resolved
July 1, 2023 Surface Water Treatment Rule Monitoring Resolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Consumer Confidence Report Rule Reporting Failure 6 Yes
Surface Water Treatment Rule Treatment Failure 4 No
Stage 1 DBP Rule Treatment Failure 1 No
Lead and Copper Rule Treatment Failure 1 No

Lead & Copper

EPA Lead and Copper Rule sampling data for ZIP codes served by this system:

ZIP Code Lead Level Exceeds Limit Sample Date
97057 0.0013 mg/L No N/A

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 2 (Moderate Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Shaniko Water System (OR4105384) on EPA.gov.

Frequently Asked Questions

Is Shaniko Water System water safe to drink?

Shaniko Water System has recorded 2 health-based violations in the past 5 years. While the system is required to treat water to meet federal standards, you may want to consider additional precautions such as a certified water filter.

How many people does Shaniko Water System serve?

Shaniko Water System serves approximately 38 people across 2 ZIP codes in Oregon.

Where does Shaniko Water System get its water?

The primary water source is groundwater.

Lead Service Line Inventory

Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:

0
Confirmed Lead
0
Galvanized — Replacement Required
0
Unknown Material
31
Confirmed Non-Lead

This system reports zero confirmed lead service lines in its inventory. Unknown-material counts may still warrant verification.

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Reported all required service line types
Latest tap sample on 2025-01-01 did not exceed the federal lead action level.
Population served: 38
Reported to Oregon

Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

Frequently Asked Questions

Is water from Shaniko Water System safe to drink?
Shaniko Water System has a C safety grade based on 12 recorded violations. Some contaminants may exceed EPA limits — independent testing is recommended.
What contaminants are in Shaniko Water System's water?
Detected contaminants include Consumer Confidence Report Rule, Surface Water Treatment Rule, Stage 1 DBP Rule, Lead and Copper Rule. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 4 contaminants above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does Shaniko Water System serve?
Shaniko Water System serves approximately 38 people with drinking water across 2 ZIP codes.
What is Shaniko Water System's water source?
Shaniko Water System draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
Is there lead in Shaniko Water System's water?
The maximum detected lead level is 0.0013 mg/L. This is within EPA action level guidelines.
Where does Shaniko Water System get its water?
Shaniko Water System's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table. Based on violation history and environmental factors, the source contamination risk is currently elevated.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

Shaniko Water System (EPA ID: OR4105384) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Oregon Shaniko Water System

Get safety alerts for Shaniko Water System, Oregon

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found — check filter options Free tool — no phone call required.