Current Noncompliance OH

Ashville Village Public Water System

EPA ID: OH6500012 ยท 4,529 people served ยท 2 ZIP codes

ZipCheckup's reading of EPA SDWIS for Ashville Village Public Water System (OH6500012): 1 unresolved EPA violation on record. With 1 unresolved EPA violation, Ashville Village Public Water System is currently out of full compliance - approximately 4,529 people in its service area.

Data: EPA SDWIS

4,529
People Served
2
ZIP Codes Served
8
Violations (5yr)
Groundwater
Water Source
0.0055 mg/L
Max Lead Level
Zone 1
Radon Risk ยท High
4
Contaminants Flagged
$231K
Median Home Value in Service Area

Service Area Map

Coverage area for Ashville Village Public Water System Source: EPA SDWIS service area boundaries.

Service area boundary

Service Area Demographics

$70,736
Median Household Income
15,169
Service Area Population
35%
Disadvantaged Population
45th
Poverty Percentile
50th
Energy Burden Percentile
57%
Pre-1986 Housing

The Ashville Village Public Water System serves a community with a median household income of $70,736 and an estimated 15,169 residents across its service area. Approximately 57% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

Environmental Justice Note: 35% of the population in this service area is classified as disadvantaged under EPA's EJScreen criteria. Communities with higher disadvantaged populations often face disproportionate environmental and health burdens, including aging water infrastructure and limited resources for remediation.

๐Ÿ’ง Where Does Your Water Come From?

Groundwater

Ashville Village Public Water System's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Elevated Risk
Source Contamination Risk
55th
Wastewater Discharge Proximity
45th
Superfund Site Proximity

Infrastructure Risk

49 yr
Avg Pipe Age
Copper
Pipe Material
22 yr
Est. Remaining Life
Moderate Wear
Decay Status
Installed 69% of expected lifespan used End of life

Detected Contaminants

How Ashville Village Public Water System compares to EPA limits

What This Means For You

Surface Water Treatment Rule at 4 mg/L exceeds the EPA maximum of mg/L.

Lead and Copper Rule at 2 mg/L exceeds the EPA maximum of mg/L.

Total Coliform at 1 presence exceeds the EPA maximum of presence.

Consumer Confidence Report Rule at 1 mg/L exceeds the EPA maximum of mg/L.

PFAS Detected in Service Area

PFAS ("forever chemicals") have been detected in water serving this system's area. 6 detections recorded. 1 exceeds federal EPA limits (4 ppt for PFOA/PFOS).

State limits: PFOA: 0.012 ppt, PFOS: 0.012 ppt, PFBS: 2.1 ppt, PFHxS: 0.14 ppt, HFPO-DA: 0.7 ppt
Health concern: PFAS are linked to cancer, thyroid disease, immune suppression, and developmental effects. They do not break down naturally.
Recommended filter: Reverse osmosis (RO) or activated carbon filters certified for PFAS removal. Find the right filter โ†’

Comparable Water Systems

Similar-sized systems in Ohio

1 violation
C 2 violations
0 violations
3 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Flood Insurance Radon Mitigation PFAS Treatment Water Filtration
Flood Insurance $1,500
Radon Mitigation $1,200
PFAS Treatment $300
Water Filtration $150
Total Estimated Cost $3,150

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $1,000

Annual per household (CDC est.)

PFAS Exposure - Lifetime Cost $1,000

Per person (emerging research est.)

Estimated Cumulative Cost Per Household

5 years
$5,165
10 years
$10,330
20 years
$20,660

Compare: Estimated remediation cost is $3,150 (one-time) vs. $10,330 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

Ashville Village Public Water System (EPA ID: OH6500012) is a community water system in Ohio that serves approximately 4,529 people from groundwater sources.

This system provides water to 2 ZIP codes across 2 communities.

Violation History

1 current noncompliance record in the accepted 2026Q2 snapshot; none are classified as health-based in this evidence.

Status breakdown for accepted records with record years 2021-2026: 7 resolved, 0 archived, 0 addressed, and 1 unaddressed. Under this source contract, current noncompliance is the sum of addressed and unaddressed records. Archived and resolved records are excluded from current noncompliance.

Recent Violations

Date Contaminant Type Status
November 5, 2025 Surface Water Treatment Rule Non-health-based Unaddressed (current)
December 19, 2024 Surface Water Treatment Rule Non-health-based Resolved
October 17, 2023 Surface Water Treatment Rule Non-health-based Resolved
May 23, 2023 Lead and Copper Rule Non-health-based Resolved
August 23, 2022 Surface Water Treatment Rule Non-health-based Resolved
April 1, 2022 Consumer Confidence Report Rule Non-health-based Resolved
March 25, 2022 Lead and Copper Rule Non-health-based Resolved
March 19, 2021 Total Coliform Non-health-based Resolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Surface Water Treatment Rule Treatment Failure 4 No
Lead and Copper Rule Treatment Failure 2 No
Total Coliform Microbiological 1 No
Consumer Confidence Report Rule Reporting Failure 1 No

Lead & Copper

EPA Lead and Copper Rule evidence attributed directly to this water system:

Lead Level Exceeds Action Level Sample Date
0.0055 mg/L No N/A

No copper action-level exceedance record appears for this PWSID in the accepted LCR snapshot. This does not establish a clean copper measurement.

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 1 (High Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20โ€“$50 (DIY kit) ยท Professional inspection: $150โ€“$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking โ€” this helps flush lead from your pipes.

ZIP Codes Served

Coverage: Service area ZIP codes sourced from EPA Community Water System Service Area Boundaries v3 (March 2026 release). These ZIPs reflect the actual deployment footprint recorded by OH or modeled from parcel and building-footprint data.

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Ashville Village Public Water System (OH6500012) on EPA.gov.

Frequently Asked Questions

Is Ashville Village Public Water System water safe to drink?

The accepted 2026Q2 ECHO snapshot shows 1 current noncompliance record and zero current records classified as health-based. That classification is not a property-specific water test or safety guarantee.

How many people does Ashville Village Public Water System serve?

Ashville Village Public Water System serves approximately 4,529 people across 2 ZIP codes in Ohio.

Where does Ashville Village Public Water System get its water?

The primary water source is groundwater.

Federal UCMR5 PFAS Monitoring: Tested Clean

This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). No PFAS compounds were detected.

Samples collected
58

Current MCL reflects the lowest state-enforceable limit (NYS 10 ppt for PFOA/PFOS, effective August 2020). The federal final MCL of 4 ppt for PFOA/PFOS (EPA April 2024 rule) is not enforceable until April 2029. Detections above 4 ppt but below 10 ppt are below current MCL but above the future federal limit.

Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) โ€” per-system federal sampling, 2023โ€“2025. EPA UCMR5 monitoring program โ†’

Understand PFAS health context and filtration โ†’

Frequently Asked Questions

What contaminants are in Ashville Village Public Water System's water?
Detected contaminants include Surface Water Treatment Rule, Lead and Copper Rule, Total Coliform, Consumer Confidence Report Rule. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 4 contaminants above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does Ashville Village Public Water System serve?
Ashville Village Public Water System serves approximately 4,529 people with drinking water across 2 ZIP codes.
What is Ashville Village Public Water System's water source?
Ashville Village Public Water System draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
Is there lead in Ashville Village Public Water System's water?
The maximum detected lead level is 0.0055 mg/L. This is within EPA action level guidelines.
What is the demographic profile of Ashville Village Public Water System's service area?
The Ashville Village Public Water System service area has a median household income of $70,736. EPA EJScreen data classifies 35% of the population as disadvantaged, which may indicate greater vulnerability to environmental health risks.
Where does Ashville Village Public Water System get its water?
Ashville Village Public Water System's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table. Based on the exported violation history and environmental factors, the source contamination risk is classified as elevated.

How to cite this page

APA ZipCheckup. (n.d.). Ashville Village Public Water System (OH): 8 EPA Violations. https://zipcheckup.com/water-system/oh6500012/
BibTeX
@misc{zipcheckup-water-system-oh6500012,
  author = {{ZipCheckup}},
  title  = {{Ashville Village Public Water System (OH): 8 EPA Violations}},
  year   = {n.d.},
  url    = {https://zipcheckup.com/water-system/oh6500012/}
}

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter โ†’

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report โ†’

3

Contact your utility

Ashville Village Public Water System (EPA ID: OH6500012) - request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Ohio Ashville Village Public Water System

Get safety alerts for Ashville Village Public Water System, Ohio

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found - check filter options Free tool - no phone call required.