Historical Compliance Records NM 1 HEALTH-BASED VIOLATION ON RECORD

Sandia Peak Utility

EPA ID: NM3562201 ยท 6,079 people served ยท 3 ZIP codes

ZipCheckup's reading of EPA records for Sandia Peak Utility (NM3562201): 1 health-based violation recorded since 2021. Past violations at Sandia Peak Utility total 2, all marked resolved; it supplies 6,079 residents.

Data: EPA SDWIS

6,079
People Served
3
ZIP Codes Served
2
Violations (since 2021)
Groundwater
Water Source
0.0021 mg/L
Most recent lead 90th percentile on record (monitoring period ending 2023-12-31)
1
Contaminants Flagged
$362K
Median Home Value in ZIP Codes Served

Service Area Map

Coverage area for Sandia Peak Utility Source: EPA SDWIS service area boundaries.

Service area boundary

Demographics of ZIP Codes Served

$92,083
Median Household Income
92,364
Population of ZIP Codes Served (Census)
35%
Disadvantaged Population
50th
Poverty Percentile
30th
Energy Burden Percentile
33%
Pre-1986 Housing

The ZIP codes associated with Sandia Peak Utility have a median household income of $92,083 and about 92,364 residents live in those ZIP codes (Census; not the number of people this system supplies).

Environmental Justice Note: On average, 35% of census tracts in the counties mapped to this service area are designated disadvantaged by the federal Climate and Economic Justice Screening Tool (CEJST, 2022 version). Communities with higher disadvantaged populations often face disproportionate environmental and health burdens, including aging water infrastructure and limited resources for remediation.

๐Ÿ’ง Where Does Your Water Come From?

Groundwater

Sandia Peak Utility's water is classified in EPA records as a groundwater source. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Moderate Risk
Source Contamination Risk
40th
Wastewater Discharge Proximity
70th
Superfund Site Proximity

Superfund Proximity Note: This service area ranks in the 70th percentile nationally for proximity to Superfund (NPL) sites. Groundwater sources near contaminated sites may face elevated risk from industrial chemicals.

Infrastructure Risk

30 yr
Estimated pipe age (modeled from housing age)
Copper
Likely pipe material (modeled)
38 yr
Est. Remaining Life
Stable
Decay Status
Installed 44% of expected lifespan used (estimate) End of life

Comparable Water Systems

Similar-sized systems in New Mexico

Tucumcari Water System
6,064 people
0 violations
1 violation
D 0 violations
3 violations
Truth or Consequences
6,783 people
19 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Water Filtration
Water Filtration $400
Total Estimated Cost $400

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

Illustrative per-household cost scenario based on stated assumptions:

Estimated Healthcare Costs $500

Annual per household (ZipCheckup estimate)

Estimated Cumulative Cost Per Household

5 years
$2,500
10 years
$5,000
20 years
$10,000

Compare: Estimated remediation cost is $400 (one-time) vs. $5,000 in estimated inaction costs over 10 years.

Individual costs vary by household size, property, and health factors. These estimates are for awareness, not financial advice.

System Overview

Sandia Peak Utility (EPA ID: NM3562201) is a community water system in New Mexico that serves approximately 6,079 people from groundwater sources.

This system provides water to 3 ZIP codes across 1 community.

Violation History

No current noncompliance in the accepted 2026Q2 snapshot. The 2 records in the 2021-2026 window are classified as resolved or archived, not current.

Status breakdown for accepted records with record years 2021-2026: 2 resolved, 0 archived, 0 addressed, and 0 unaddressed. Under this source contract, current noncompliance is the sum of addressed and unaddressed records. Archived and resolved records are excluded from current noncompliance.

Recent Violations

Date Contaminant Type Status
October 17, 2024 LEAD AND COPPER RULE REVISIONS Non-health-based Resolved
October 17, 2024 LEAD AND COPPER RULE REVISIONS Health-based Resolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
LEAD AND COPPER RULE REVISIONS Treatment Technique, Monitoring & Reporting 2 Yes

Lead & Copper

EPA Lead and Copper Rule evidence attributed directly to this water system:

Lead Level Exceeds Action Level Sample Date
0.0021 mg/L No 2023-12-31

No copper action-level exceedance record appears for this PWSID in the accepted LCR snapshot. This does not establish a clean copper measurement.

Need help with your water quality?

Typical cost: Water test: typically $20โ€“$50 (DIY kit) ยท Professional inspection: $150โ€“$400

Find the Right Water Filter

Free tip: Ask your water utility whether running cold water for 2 minutes is enough to flush your plumbing before drinking.

ZIP Codes Served

Coverage: Service area ZIP codes sourced from EPA Community Water System Service Area Boundaries v3 (March 2026 release). These ZIPs reflect the actual deployment footprint recorded by NM or modeled from parcel and building-footprint data.

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View available EPA compliance records for Sandia Peak Utility (NM3562201) on EPA.gov.

Frequently Asked Questions

Is Sandia Peak Utility water safe to drink?

The accepted 2026Q2 ECHO snapshot shows no current noncompliance for Sandia Peak Utility; its 2 accepted 2021-2026 records are resolved or archived. Historical compliance status does not establish conditions at a specific tap.

How many people does Sandia Peak Utility serve?

Sandia Peak Utility serves approximately 6,079 people across 3 ZIP codes in New Mexico.

Where does Sandia Peak Utility get its water?

The primary water source is groundwater.

Federal UCMR5 PFAS Monitoring: No PFAS Reported Above Reporting Levels

This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). No PFAS compounds were reported above UCMR5 minimum reporting levels.

Samples collected
58

EPA's April 2024 PFAS rule sets MCLs of 4 ppt for PFOA and PFOS and 10 ppt for PFHxS, PFNA and HFPO-DA (GenX); water systems must comply from 2029. Other PFAS compounds have no individual federal MCL. A state standard is shown only where this system's state has its own enforceable PFAS limit. Detection results are EPA UCMR5 samples, not a measurement at your tap.

Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) โ€” per-system federal sampling, 2023โ€“2025. EPA UCMR5 monitoring program โ†’

Understand PFAS health context and filtration โ†’

Frequently Asked Questions

Should I use a water filter? ▼
Given 2 recorded violations, review the violation types and dates; a filter certified for a specific contaminant of concern can reduce that contaminant at the tap. Monitoring or reporting violations are not something a filter addresses.
How many people does Sandia Peak Utility serve? ▼
Sandia Peak Utility serves approximately 6,079 people with drinking water across 3 ZIP codes.
What is Sandia Peak Utility's water source? ▼
Sandia Peak Utility draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
Is there lead in Sandia Peak Utility's water? ▼
The most recent 90th-percentile lead result on record is 0.0021 mg/L (sample period ending 2023-12-31). This is at or below the EPA lead action level, which triggers system action and is not a safe level; the EPA health goal for lead is zero.
What is the demographic profile of the ZIP codes associated with Sandia Peak Utility? ▼
The ZIP codes mapped to Sandia Peak Utility have a median household income of $92,083 (Census ZIP-code estimate). In CEJST data, 35% of census tracts in the counties mapped to this area are designated disadvantaged (average across mapped ZIP codes), which may indicate greater vulnerability to environmental health risks.
Where does Sandia Peak Utility get its water? ▼
Sandia Peak Utility's water is classified in EPA records as a groundwater source. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table. Based on the available data, the modeled source-contamination category is moderate; test local water to assess actual exposure.

How to cite this page

APA ZipCheckup. (n.d.). Sandia Peak Utility (NM): 1 Health Violation. https://zipcheckup.com/water-system/nm3562201/
BibTeX
@misc{zipcheckup-water-system-nm3562201,
  author = {{ZipCheckup}},
  title  = {{Sandia Peak Utility (NM): 1 Health Violation}},
  year   = {n.d.},
  url    = {https://zipcheckup.com/water-system/nm3562201/}
}

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter โ†’

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report โ†’

3

Contact your utility

Sandia Peak Utility (EPA ID: NM3562201) - request the latest Consumer Confidence Report or ask about specific contaminants.

Home › Water Systems › New Mexico › Sandia Peak Utility

Get safety alerts for Sandia Peak Utility, New Mexico

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found - check filter options Free tool - no phone call required.