Monitoring Violations MT

Manhattan Town of

EPA ID: MT0000285 · 1,800 people served · 1 ZIP code

Water monitoring history for Manhattan Town of includes 10 violations, each addressed and closed — the system holds no active EPA enforcement today for its 1,800 residents.

Data: EPA SDWIS Last verified: 2026-04-02

C · 65
Avg Safety Score
1,800
People Served
1
ZIP Code Served
10
Violations (5yr)
Groundwater
Water Source
0.002 mg/L
Max Lead Level
Zone 1
Radon Risk · High
5
Contaminants Flagged
$562K
Median Home Value in Service Area

Service Area Map

Coverage area for Manhattan Town of Source: EPA SDWIS service area boundaries.

Service area boundary — Grade C

Service Area Demographics

$86,382
Median Household Income
5,635
Service Area Population
5%
Disadvantaged Population
30th
Poverty Percentile
30th
Energy Burden Percentile
48%
Pre-1986 Housing

The Manhattan Town of serves a community with a median household income of $86,382 and an estimated 5,635 residents across its service area. Approximately 48% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

💧 Where Does Your Water Come From?

Groundwater

Manhattan Town of's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Moderate Risk
Source Contamination Risk
60th
Wastewater Discharge Proximity
70th
Superfund Site Proximity

About 1% of homes in Gallatin County, Montana rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Wastewater Proximity Note: This service area ranks in the 60th percentile nationally for proximity to wastewater discharge points.

Superfund Proximity Note: This service area ranks in the 70th percentile nationally for proximity to Superfund (NPL) sites. Groundwater sources near contaminated sites may face elevated risk from industrial chemicals.

Infrastructure Risk

43 yr
Avg Pipe Age
Copper
Pipe Material
27 yr
Est. Remaining Life
Stable
Decay Status
Installed 61% of expected lifespan used End of life

Detected Contaminants

How Manhattan Town of compares to EPA limits

Arsenic 1 mg/L (EXCEEDS LIMIT)
0 EPA Limit: 0.01 mg/L
Barium 2 mg/L (100% of limit)
0 EPA Limit: 2 mg/L

What This Means For You

Arsenic at 1 mg/L exceeds the EPA maximum of 0.01 mg/L.

Stage 1 DBP Rule at 3 mg/L exceeds the EPA maximum of mg/L.

Surface Water Treatment Rule at 3 mg/L exceeds the EPA maximum of mg/L.

Gross Alpha at 1 pCi/L exceeds the EPA maximum of pCi/L. Increased cancer risk from radioactive particles. Consider reverse osmosis filtration.

Gross Alpha was detected in this water system. reverse osmosis filtration can reduce exposure.

Find a certified water filter →

Comparable Water Systems

Similar-sized systems in Montana

0 violations
City of Malta
1,800 people
C 12 violations
City of Baker
1,858 people
D 10 violations
C 0 violations
Columbus Town of
1,900 people
0 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Radon Mitigation Flood Insurance
Radon Mitigation $1,200
Flood Insurance $1,200
Total Estimated Cost $2,400

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $1,000

Annual per household (CDC est.)

Estimated Cumulative Cost Per Household

5 years
$5,000
10 years
$10,000
20 years
$20,000

Compare: Estimated remediation cost is $2,400 (one-time) vs. $10,000 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

Manhattan Town of (EPA ID: MT0000285) is a community water system in Montana that serves approximately 1,800 people from groundwater sources.

This system serves ZIP code 59741 in Manhattan.

Average Home Safety Score: C (65/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

10 monitoring/reporting violations recorded. These are procedural violations (missed tests or late reports), not necessarily water safety issues.

Recent Violations

Date Contaminant Type Status
December 30, 2024 Stage 1 DBP Rule Monitoring Resolved
July 1, 2024 Surface Water Treatment Rule Monitoring Resolved
October 1, 2023 Stage 1 DBP Rule Monitoring Resolved
July 1, 2023 Surface Water Treatment Rule Monitoring Resolved
January 1, 2023 Arsenic Monitoring Resolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Stage 1 DBP Rule Treatment Failure 3 No
Surface Water Treatment Rule Treatment Failure 3 No
Barium Inorganic 2 No
Arsenic Inorganic 1 No
Gross Alpha Radionuclides 1 No

Lead & Copper

EPA Lead and Copper Rule sampling data for ZIP codes served by this system:

ZIP Code Lead Level Exceeds Limit Sample Date
59741 0.002 mg/L No N/A

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 1 (High Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Manhattan Town of (MT0000285) on EPA.gov.

Frequently Asked Questions

Is Manhattan Town of water safe to drink?

Manhattan Town of has only monitoring/reporting violations, which are procedural in nature. The system meets federal health-based standards.

How many people does Manhattan Town of serve?

Manhattan Town of serves approximately 1,800 people across 1 ZIP code in Montana.

Where does Manhattan Town of get its water?

The primary water source is groundwater.

Water Source & Treatment

Where this water originates and how it's treated before reaching your tap.

Source
Groundwater
Drawn from underground aquifers via wells.
Disinfectant used
Chlorine

Source: MANHATTAN TOWN OF Consumer Confidence Report.

ZipCheckup is not affiliated with this water utility. Treatment and source data are sourced from the utility's published CCR filings.

Treatment regime

How this utility classifies its treatment process and what each reported treatment chemical does.

Treatment classification
Standard
Disinfection plus one or more treatment additives — typically corrosion control, pH adjustment, or fluoridation. Standard regime for utilities serving treated municipal water.

Treatment classification and chemical list sourced from MANHATTAN TOWN OF Consumer Confidence Report.

Treatment intensity is a ZipCheckup-derived classification based on the chemicals and processes the utility reports. Chemicals and contamination sources are taken verbatim from the utility's CCR filing. Routine federal monitoring and contaminant testing shown elsewhere on this page determine whether the water meets safety standards, not the treatment classification.

Lead Service Line Inventory

Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:

0
Confirmed Lead
7
Galvanized — Replacement Required
7
Unknown Material
864
Confirmed Non-Lead

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Reported all required service line types
Latest tap sample on 2022-01-01 did not exceed the federal lead action level.
Population served: 1,800
Reported to Montana

Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

Frequently Asked Questions

Is water from Manhattan Town of safe to drink?
Manhattan Town of has a C safety grade based on 10 recorded violations. Some contaminants may exceed EPA limits — independent testing is recommended.
What contaminants are in Manhattan Town of's water?
Detected contaminants include Arsenic, Stage 1 DBP Rule, Surface Water Treatment Rule, Barium. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 4 contaminants above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does Manhattan Town of serve?
Manhattan Town of serves approximately 1,800 people with drinking water across 1 ZIP code.
What is Manhattan Town of's water source?
Manhattan Town of draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
Is there lead in Manhattan Town of's water?
The maximum detected lead level is 0.002 mg/L. This is within EPA action level guidelines.
What is the demographic profile of Manhattan Town of's service area?
The Manhattan Town of service area has a median household income of $86,382. Demographic data is sourced from the U.S. Census Bureau and EPA EJScreen.
Where does Manhattan Town of get its water?
Manhattan Town of's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table. Based on available data, the source contamination risk is moderate.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

Manhattan Town of (EPA ID: MT0000285) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Montana Manhattan Town of

Get safety alerts for Manhattan Town of, Montana

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found — check filter options Free tool — no phone call required.