Monitoring Violations MN

Mountain Iron

EPA ID: MN1690035 · 2,880 people served · 4 ZIP codes

Water monitoring history for Mountain Iron includes 2 violations, each addressed and closed — the system holds no active EPA enforcement today for its 2,880 residents.

Data: EPA SDWIS Last verified: 2026-04-02

B · 74
Avg Safety Score
2,880
People Served
4
ZIP Codes Served
2
Violations (5yr)
Groundwater
Water Source
Zone 2
Radon Risk · Moderate
2
Contaminants Flagged
$163K
Median Home Value in Service Area

Service Area Map

Coverage area for Mountain Iron Source: EPA SDWIS service area boundaries.

Service area boundary — Grade B

Service Area Demographics

$69,360
Median Household Income
20,335
Service Area Population
23%
Disadvantaged Population
40th
Poverty Percentile
40th
Energy Burden Percentile
78%
Pre-1986 Housing

The Mountain Iron serves a community with a median household income of $69,360 and an estimated 20,335 residents across its service area. Approximately 78% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

💧 Where Does Your Water Come From?

Groundwater

Mountain Iron's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Moderate Risk
Source Contamination Risk
30th
Wastewater Discharge Proximity
40th
Superfund Site Proximity

About 2% of homes in St. Louis County, Minnesota rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Infrastructure Risk

62 yr
Avg Pipe Age
Galvanized Steel or Copper
Pipe Material
9 yr
Est. Remaining Life
Moderate Wear
Decay Status
Installed 87% of expected lifespan used End of life

Detected Contaminants

How Mountain Iron compares to EPA limits

What This Means For You

Consumer Confidence Report Rule at 1 mg/L exceeds the EPA maximum of mg/L.

Revised Total Coliform Rule at 1 presence exceeds the EPA maximum of presence.

PFAS Detected in Service Area

PFAS ("forever chemicals") have been detected in water serving this system's area. 1 detection recorded.

State limits: PFOA: 0.035 ppt, PFOS: 0.015 ppt, PFBS: 2 ppt, PFHxS: 0.047 ppt
Health concern: PFAS are linked to cancer, thyroid disease, immune suppression, and developmental effects. They do not break down naturally.
Recommended filter: Reverse osmosis (RO) or activated carbon filters certified for PFAS removal. Find the right filter →

Comparable Water Systems

Similar-sized systems in Minnesota

Granite Falls
2,843 people
0 violations
C 3 violations
Caledonia
2,824 people
C 2 violations
Dodge Center
2,939 people
C 1 violation
Albany
2,805 people
C 2 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Lead Pipe Replacement Flood Insurance Radon Mitigation PFAS Treatment Water Filtration
Lead Pipe Replacement $1,035
Flood Insurance $900
Radon Mitigation $400
PFAS Treatment $125
Water Filtration $75
Total Estimated Cost $2,535

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $500

Annual per household (CDC est.)

PFAS Exposure — Lifetime Cost $1,000

Per person (emerging research est.)

Estimated Cumulative Cost Per Household

5 years
$2,665
10 years
$5,330
20 years
$10,660

Compare: Estimated remediation cost is $2,535 (one-time) vs. $5,330 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

Mountain Iron (EPA ID: MN1690035) is a community water system in Minnesota that serves approximately 2,880 people from groundwater sources.

This system provides water to 4 ZIP codes across 4 communities.

Average Home Safety Score: B (74/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

2 monitoring/reporting violations recorded. These are procedural violations (missed tests or late reports), not necessarily water safety issues.

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Consumer Confidence Report Rule Reporting Failure 1 No
Revised Total Coliform Rule Microbiological 1 No

Lead & Copper

No Lead and Copper Rule sampling data available for this water system.

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 2 (Moderate Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Coverage: Service area ZIP codes sourced from EPA Community Water System Service Area Boundaries v3 (March 2026 release). These ZIPs reflect the actual deployment footprint recorded by MN or modeled from parcel and building-footprint data.

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Mountain Iron (MN1690035) on EPA.gov.

Frequently Asked Questions

Is Mountain Iron water safe to drink?

Mountain Iron has only monitoring/reporting violations, which are procedural in nature. The system meets federal health-based standards.

How many people does Mountain Iron serve?

Mountain Iron serves approximately 2,880 people across 4 ZIP codes in Minnesota.

Where does Mountain Iron get its water?

The primary water source is groundwater.

Contact Your Water Utility

Public-record contact information for the water utility serving this system. Use these channels to request water quality reports, ask about service, or report issues directly.

Contact information from Mountain Iron Consumer Confidence Report.

ZipCheckup is not affiliated with this water utility, does not act as its agent, and does not provide customer support for it. Contact details shown are public-record information from CCR filings. For service issues, contact the utility directly using the information above.

Treatment regime

How this utility classifies its treatment process and what each reported treatment chemical does.

Treatment classification
Minimal — disinfection only
Disinfection (typically chlorine) without additional filtration or coagulation stages. Common for groundwater systems where source water meets federal standards after disinfection alone.

Treatment chemicals and what each one does

Chemical names are reported verbatim by the utility. Purpose categories are ZipCheckup annotations based on standard drinking-water treatment practice.

Disinfectant
Inactivates bacteria, viruses, and parasites in the treated water.
chlorine
Fluoridation
Added at low levels per state or local public-health policy for dental health.
fluoride

Treatment classification and chemical list sourced from Mountain Iron Consumer Confidence Report.

Treatment intensity is a ZipCheckup-derived classification based on the chemicals and processes the utility reports. Chemicals and contamination sources are taken verbatim from the utility's CCR filing. Routine federal monitoring and contaminant testing shown elsewhere on this page determine whether the water meets safety standards, not the treatment classification.

PFAS Substances Detected in This System

This water system's Consumer Confidence Report disclosed the following PFAS compounds. Levels are from the utility's most recent reporting cycle.

Substance Detected level EPA limit Status
Perfluorobutanoic acid (PFBA)
Not yet EPA-regulated
1.3 ppt No federal limit set
Perfluorooctanoic acid (PFOA)
Not yet EPA-regulated
0.23 ppt No federal limit set
Perfluorooctanesulfonate (PFOS)
Not yet EPA-regulated
0.15 ppt No federal limit set

In April 2024, EPA finalized the first National Primary Drinking Water Regulation for six PFAS. Public water systems have until 2029 to comply. EPA — PFAS regulation overview →

Source: Consumer Confidence Report disclosed by Mountain Iron.

ZipCheckup is not affiliated with this water utility. PFAS detection data is sourced from public Consumer Confidence Reports filed by the utility itself.

Learn more about PFAS health effects and filtration →

Lead Service Line Inventory

Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:

0
Confirmed Lead
10
Galvanized — Replacement Required
481
Unknown Material
443
Confirmed Non-Lead

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Reported all required service line types
Latest tap sample on 2021-01-01 did not exceed the federal lead action level.
Population served: 2,880
Reported to Minnesota

Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

Frequently Asked Questions

Is water from Mountain Iron safe to drink?
Mountain Iron earns a B safety grade with 2 violations in the past 5 years. Tap water meets EPA standards for most contaminants.
What contaminants are in Mountain Iron's water?
Detected contaminants include Consumer Confidence Report Rule, Revised Total Coliform Rule. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 2 contaminants above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does Mountain Iron serve?
Mountain Iron serves approximately 2,880 people with drinking water across 4 ZIP codes.
What is Mountain Iron's water source?
Mountain Iron draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
What is the demographic profile of Mountain Iron's service area?
The Mountain Iron service area has a median household income of $69,360. Demographic data is sourced from the U.S. Census Bureau and EPA EJScreen.
Where does Mountain Iron get its water?
Mountain Iron's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table. Based on available data, the source contamination risk is moderate.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

Mountain Iron (EPA ID: MN1690035) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Minnesota Mountain Iron

Get safety alerts for Mountain Iron, Minnesota

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found — check filter options Free tool — no phone call required.