Health Violations Found MN 3 HEALTH VIOLATIONS

Stewart

EPA ID: MN1430009 · 482 people served · 1 ZIP code

Stewart carries 3 open EPA violations that remain unresolved in the federal system — approximately 482 people fall within its service area.

Data: EPA SDWIS Last verified: 2026-04-02

D · 51
Avg Safety Score
482
People Served
1
ZIP Code Served
4
Violations (5yr)
Groundwater
Water Source
0.002 mg/L
Max Lead Level
Zone 1
Radon Risk · High
1
Contaminants Flagged
$181K
Median Home Value in Service Area

Compliance Trajectory

Worsening · Risk tier: High · 95% chance of violation in next 12 months

Violations went from 1 (2022) to 3 (2025). The pattern suggests growing compliance challenges.

Service Area Map

Coverage area for Stewart Source: EPA SDWIS service area boundaries.

Service area boundary — Grade D

Service Area Demographics

$75,365
Median Household Income
1,285
Service Area Population
14%
Disadvantaged Population
50th
Poverty Percentile
50th
Energy Burden Percentile
78%
Pre-1986 Housing

The Stewart serves a community with a median household income of $75,365 and an estimated 1,285 residents across its service area. Approximately 78% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

💧 Where Does Your Water Come From?

Groundwater

Stewart's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Elevated Risk
Source Contamination Risk
30th
Wastewater Discharge Proximity
20th
Superfund Site Proximity

About 1% of homes in McLeod County, Minnesota rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Infrastructure Risk

72 yr
Avg Pipe Age
Galvanized Steel or Copper
Pipe Material
0 yr
Est. Remaining Life
Moderate Wear
Decay Status
Installed 100% of expected lifespan used End of life

Detected Contaminants

How Stewart compares to EPA limits

Haloacetic Acids (HAA5) 4 mg/L (EXCEEDS LIMIT)
0 EPA Limit: 0.06 mg/L
Cancer risk; reproductive & developmental effects

What This Means For You

Haloacetic Acids (HAA5) at 4 mg/L exceeds the EPA maximum of 0.06 mg/L. Cancer risk; reproductive & developmental effects. Consider granular activated carbon (GAC) filtration.

Haloacetic Acids (HAA5) was detected in this water system. granular activated carbon (GAC) filtration can reduce exposure.

Find a certified water filter →

Comparable Water Systems

Similar-sized systems in Minnesota

Racine
482 people
C 2 violations
Upsala
482 people
B 0 violations
Sacred Heart
485 people
C 0 violations
Kiester
491 people
C 0 violations
Pennock
492 people
C 0 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Radon Mitigation Water Filtration
Radon Mitigation $1,200
Water Filtration $600
Total Estimated Cost $1,800

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $500

Annual per household (CDC est.)

Estimated Cumulative Cost Per Household

5 years
$2,500
10 years
$5,000
20 years
$10,000

Compare: Estimated remediation cost is $1,800 (one-time) vs. $5,000 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

Stewart (EPA ID: MN1430009) is a community water system in Minnesota that serves approximately 482 people from groundwater sources.

This system serves ZIP code 55385 in Stewart.

Average Home Safety Score: D (51/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

3 health-based violations recorded in the past 5 years. 3 remain unresolved.

Recent Violations

Date Contaminant Type Status
July 1, 2025 Haloacetic Acids (HAA5) Health-based Unresolved
January 1, 2025 Haloacetic Acids (HAA5) Health-based Unresolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Haloacetic Acids (HAA5) Disinfection Byproducts 4 Yes

Health Risk Details

Haloacetic Acids (HAA5) (EPA limit: 0.06 mg/L)

Cancer risk; reproductive & developmental effects At-risk groups: pregnant women, infants, long-term consumers of chlorinated municipal water.

Removal methods: granular activated carbon (GAC), carbon block filter, reverse osmosis. Find the right filter →

Lead & Copper

EPA Lead and Copper Rule sampling data for ZIP codes served by this system:

ZIP Code Lead Level Exceeds Limit Sample Date
55385 0.002 mg/L No N/A

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 1 (High Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Stewart (MN1430009) on EPA.gov.

Frequently Asked Questions

Is Stewart water safe to drink?

Stewart has recorded 3 health-based violations in the past 5 years. While the system is required to treat water to meet federal standards, you may want to consider additional precautions such as a certified water filter.

How many people does Stewart serve?

Stewart serves approximately 482 people across 1 ZIP code in Minnesota.

Where does Stewart get its water?

The primary water source is groundwater.

Contact Your Water Utility

Public-record contact information for the water utility serving this system. Use these channels to request water quality reports, ask about service, or report issues directly.

Phone
507-327-3643
ZipCheckup is not affiliated with this water utility, does not act as its agent, and does not provide customer support for it. Contact details shown are public-record information from CCR filings. For service issues, contact the utility directly using the information above.

Contact information from Stewart Consumer Confidence Report.

ZipCheckup is not affiliated with this water utility, does not act as its agent, and does not provide customer support for it. Contact details shown are public-record information from CCR filings. For service issues, contact the utility directly using the information above.

Treatment regime

How this utility classifies its treatment process and what each reported treatment chemical does.

Treatment classification
Minimal — disinfection only
Disinfection (typically chlorine) without additional filtration or coagulation stages. Common for groundwater systems where source water meets federal standards after disinfection alone.

Treatment chemicals and what each one does

Chemical names are reported verbatim by the utility. Purpose categories are ZipCheckup annotations based on standard drinking-water treatment practice.

Disinfectant
Inactivates bacteria, viruses, and parasites in the treated water.
chlorine
Fluoridation
Added at low levels per state or local public-health policy for dental health.
fluoride

Treatment classification and chemical list sourced from Stewart Consumer Confidence Report.

Treatment intensity is a ZipCheckup-derived classification based on the chemicals and processes the utility reports. Chemicals and contamination sources are taken verbatim from the utility's CCR filing. Routine federal monitoring and contaminant testing shown elsewhere on this page determine whether the water meets safety standards, not the treatment classification.

PFAS Substances Detected in This System

This water system's Consumer Confidence Report disclosed the following PFAS compounds. Levels are from the utility's most recent reporting cycle.

Substance Detected level EPA limit Status
PFBA
Not yet EPA-regulated
2.4 ppt No federal limit set
PFHxA
Not yet EPA-regulated
0.6 ppt No federal limit set

In April 2024, EPA finalized the first National Primary Drinking Water Regulation for six PFAS. Public water systems have until 2029 to comply. EPA — PFAS regulation overview →

Source: Consumer Confidence Report disclosed by Stewart.

ZipCheckup is not affiliated with this water utility. PFAS detection data is sourced from public Consumer Confidence Reports filed by the utility itself.

Learn more about PFAS health effects and filtration →

Lead Service Line Inventory

Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:

0
Confirmed Lead
6
Galvanized — Replacement Required
42
Unknown Material
213
Confirmed Non-Lead

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Reported all required service line types
Latest tap sample on 2025-07-01 did not exceed the federal lead action level.
Population served: 482
Reported to Minnesota

Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

Notable events and violations

This section summarizes events the utility chose to disclose in its most recent Consumer Confidence Report, plus any federal compliance violations the utility recorded against itself. Both lists are utility-authored — ZipCheckup does not audit, judge, or reorder them.

Notable events from the utility's CCR

These bullet entries are the utility's own narration of operational, regulatory, or infrastructure events during the reporting period.

Notable events from Stewart Consumer Confidence Report:
  • TTHMs MCL violation issued 4/11/2025; system considering alternative water source or treatment.
  • Copper action level exceeded in two consecutive sampling rounds (April 2025 and January 2026).
  • HAA5 range reached 73.40 ppb (above the 60 ppb MCL at a single point, though running average 45.7 ppb is compliant).

ZipCheckup note: items above reflect what the utility published in its most recent CCR. Federal violation records are also tracked separately by the EPA Safe Drinking Water Information System (SDWIS) — the SDWIS record is the authoritative federal source for any specific regulatory action.

Frequently Asked Questions

Is water from Stewart safe to drink?
Stewart has a D safety grade based on 4 recorded violations. Some contaminants may exceed EPA limits — independent testing is recommended.
What contaminants are in Stewart's water?
Detected contaminants include Haloacetic Acids (HAA5). Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 1 contaminant above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does Stewart serve?
Stewart serves approximately 482 people with drinking water across 1 ZIP code.
What is Stewart's water source?
Stewart draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
Is there lead in Stewart's water?
The maximum detected lead level is 0.002 mg/L. This is within EPA action level guidelines.
What is the demographic profile of Stewart's service area?
The Stewart service area has a median household income of $75,365. Demographic data is sourced from the U.S. Census Bureau and EPA EJScreen.
Where does Stewart get its water?
Stewart's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table. Based on violation history and environmental factors, the source contamination risk is currently elevated.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

Stewart (EPA ID: MN1430009) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Minnesota Stewart

Get safety alerts for Stewart, Minnesota

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found — check filter options Free tool — no phone call required.