Marshall
EPA ID: MN1420006 · 13,890 people served · 1 ZIP code
Federal monitoring spanning five full years has produced zero violations at Marshall — a clean record across every reporting cycle for a utility serving approximately 13,890 residents.
Data: EPA SDWIS Last verified: 2026-04-02
Service Area Map
Coverage area for Marshall Source: EPA SDWIS service area boundaries.
Service area boundary — Grade D
Service Area Demographics
The Marshall serves a community with a median household income of $70,640 and an estimated 15,843 residents across its service area. Approximately 66% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.
💧 Where Does Your Water Come From?
Marshall's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.
About 1% of homes in Lyon County, Minnesota rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.
Wastewater Proximity Note: This service area ranks in the 60th percentile nationally for proximity to wastewater discharge points.
Infrastructure Risk
PFAS Detected in Service Area
PFAS ("forever chemicals") have been detected in water serving this system's area. 1 detection recorded.
Comparable Water Systems
Similar-sized systems in Minnesota
Estimated Remediation Costs
Average estimated costs across ZIP codes served by this system
Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.
System Overview
Marshall (EPA ID: MN1420006) is a community water system in Minnesota that serves approximately 13,890 people from groundwater sources.
This system serves ZIP code 56258 in Marshall.
Average Home Safety Score: D (53/100)
Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.
Violation History
Lead & Copper
EPA Lead and Copper Rule sampling data for ZIP codes served by this system:
| ZIP Code | Lead Level | Exceeds Limit | Sample Date |
|---|---|---|---|
| 56258 | 0.008 mg/L | No | N/A |
Radon Risk in Service Area
Dominant radon zone for ZIP codes served by this system: Zone 1 (High Risk)
The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.
Need help with your water quality?
Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400
Find the Right Water FilterFree tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.
ZIP Codes Served
Coverage: Service area ZIP codes sourced from EPA Community Water System Service Area Boundaries v3 (March 2026 release). These ZIPs reflect the actual deployment footprint recorded by MN or modeled from parcel and building-footprint data.
- 56258 — Marshall
Data Sources
This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Marshall (MN1420006) on EPA.gov.
Frequently Asked Questions
Is Marshall water safe to drink?
Based on EPA records, Marshall has no recorded violations in the past 5 years — a positive indicator of water quality management.
How many people does Marshall serve?
Marshall serves approximately 13,890 people across 1 ZIP code in Minnesota.
Where does Marshall get its water?
The primary water source is groundwater.
Contact Your Water Utility
Public-record contact information for the water utility serving this system. Use these channels to request water quality reports, ask about service, or report issues directly.
Contact information from Marshall Consumer Confidence Report.
ZipCheckup is not affiliated with this water utility, does not act as its agent, and does not provide customer support for it. Contact details shown are public-record information from CCR filings. For service issues, contact the utility directly using the information above.
Treatment regime
How this utility classifies its treatment process and what each reported treatment chemical does.
Treatment chemicals and what each one does
Chemical names are reported verbatim by the utility. Purpose categories are ZipCheckup annotations based on standard drinking-water treatment practice.
Treatment classification and chemical list sourced from Marshall Consumer Confidence Report.
Treatment intensity is a ZipCheckup-derived classification based on the chemicals and processes the utility reports. Chemicals and contamination sources are taken verbatim from the utility's CCR filing. Routine federal monitoring and contaminant testing shown elsewhere on this page determine whether the water meets safety standards, not the treatment classification.
Federal UCMR5 PFAS Monitoring: Detected
This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). PFAS compounds were detected below the current state-enforceable MCL.
Current MCL reflects the lowest state-enforceable limit (NYS 10 ppt for PFOA/PFOS, effective August 2020). The federal final MCL of 4 ppt for PFOA/PFOS (EPA April 2024 rule) is not enforceable until April 2029. Detections above 4 ppt but below 10 ppt are below current MCL but above the future federal limit.
Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) — per-system federal sampling, 2023–2025. EPA UCMR5 monitoring program →
PFAS Substances Detected in This System
This water system's Consumer Confidence Report disclosed the following PFAS compounds. Levels are from the utility's most recent reporting cycle.
In April 2024, EPA finalized the first National Primary Drinking Water Regulation for six PFAS. Public water systems have until 2029 to comply. EPA — PFAS regulation overview →
Source: Consumer Confidence Report disclosed by Marshall.
ZipCheckup is not affiliated with this water utility. PFAS detection data is sourced from public Consumer Confidence Reports filed by the utility itself.
Lead Service Line Inventory
Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:
Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.
Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026
ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.
Notable events and violations
This section summarizes events the utility chose to disclose in its most recent Consumer Confidence Report, plus any federal compliance violations the utility recorded against itself. Both lists are utility-authored — ZipCheckup does not audit, judge, or reorder them.
Notable events from the utility's CCR
These bullet entries are the utility's own narration of operational, regulatory, or infrastructure events during the reporting period.
- Sulfate (664 ppm) exceeds the 500 ppm secondary comparison value; sodium (310 ppm) far exceeds the 20 ppm comparison value — laxative-effect and dietary-sodium considerations.
ZipCheckup note: items above reflect what the utility published in its most recent CCR. Federal violation records are also tracked separately by the EPA Safe Drinking Water Information System (SDWIS) — the SDWIS record is the authoritative federal source for any specific regulatory action.
How Water Systems Appear in Rankings
Water systems are evaluated by violation history, contaminant detections, and service population. Larger systems with more service connections appear in more rankings.
Frequently Asked Questions
What You Can Do
Test your water
Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →
Check your specific ZIP code
Water quality can vary within a system. View nearest ZIP report →
Contact your utility
Marshall (EPA ID: MN1420006) — request the latest Consumer Confidence Report or ask about specific contaminants.