Historical Compliance Records IL

Glenwood

EPA ID: IL0311050 ยท 8,956 people served ยท 2 ZIP codes

ZipCheckup's reading of EPA SDWIS for Glenwood (IL0311050): 4 EPA violations in the last five years. Despite the 4 historical violations in its record, Glenwood has cleared every one and now meets EPA standards serving 8,956 residents.

Data: EPA SDWIS

C ยท 68
Avg Safety Score
8,956
People Served
2
ZIP Codes Served
4
Violations (5yr)
Surface Water
Water Source
Zone 2
Radon Risk ยท Moderate
3
Contaminants Flagged
$164K
Median Home Value in Service Area

Service Area Map

Coverage area for Glenwood Source: EPA SDWIS service area boundaries.

Service area boundary - Grade C

Service Area Demographics

$66,230
Median Household Income
10,606
Service Area Population
46%
Disadvantaged Population
50th
Poverty Percentile
40th
Energy Burden Percentile
95%
Pre-1986 Housing

The Glenwood serves a community with a median household income of $66,230 and an estimated 10,606 residents across its service area. Approximately 95% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

Environmental Justice Note: 46% of the population in this service area is classified as disadvantaged under EPA's EJScreen criteria. Communities with higher disadvantaged populations often face disproportionate environmental and health burdens, including aging water infrastructure and limited resources for remediation.

๐ŸŒŠ Where Does Your Water Come From?

Surface Water

Glenwood's water is drawn from rivers, lakes, or reservoirs. Surface water sources are more exposed to agricultural runoff, stormwater, and upstream discharges, but they typically receive more intensive treatment before reaching your tap.

Elevated Risk
Source Contamination Risk
50th
Wastewater Discharge Proximity
40th
Superfund Site Proximity

Infrastructure Risk

68 yr
Avg Pipe Age
Galvanized Steel or Copper
Pipe Material
1 yr
Est. Remaining Life
Stable
Decay Status
Installed 99% of expected lifespan used End of life

Detected Contaminants

How Glenwood compares to EPA limits

What This Means For You

Stage 1 DBP Rule at 2 mg/L exceeds the EPA maximum of mg/L.

Surface Water Treatment Rule at 1 mg/L exceeds the EPA maximum of mg/L.

Lead and Copper Rule at 1 mg/L exceeds the EPA maximum of mg/L.

PFAS Detected in Service Area

PFAS ("forever chemicals") have been detected in water serving this system's area. 1 detection recorded.

State limits: PFOA: 0.002 ppt, PFOS: 0.014 ppt
Health concern: PFAS are linked to cancer, thyroid disease, immune suppression, and developmental effects. They do not break down naturally.
Recommended filter: Reverse osmosis (RO) or activated carbon filters certified for PFAS removal. Find the right filter โ†’

Comparable Water Systems

Similar-sized systems in Illinois

Willowbrook
9,000 people
7 violations
Monmouth
8,902 people
2 violations
Olney
8,877 people
2 violations
Glencoe
8,849 people
B 0 violations
Harwood Heights
9,065 people
0 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Flood Insurance Radon Mitigation PFAS Treatment
Flood Insurance $1,200
Radon Mitigation $400
PFAS Treatment $250
Total Estimated Cost $1,850

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $500

Annual per household (CDC est.)

PFAS Exposure - Lifetime Cost $1,000

Per person (emerging research est.)

Estimated Cumulative Cost Per Household

5 years
$2,665
10 years
$5,330
20 years
$10,660

Compare: Estimated remediation cost is $1,850 (one-time) vs. $5,330 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

Glenwood (EPA ID: IL0311050) is a community water system in Illinois that serves approximately 8,956 people from surface water sources.

This system provides water to 2 ZIP codes across 2 communities.

ZIP-Area Home Safety Context: C (68/100)

This is the average Home Safety Score for 1 of 2 service-area ZIP codes with all required score domains observed. It is not a grade for the water utility.

Model 4.0.0 uses SDWIS identity plus accepted ECHO SDWA lifecycle-based water compliance, the UCMR 5 PFAS MCL screen, EPA radon zone, and annual EPA AirData AQI across three equally weighted domains. Missing required evidence suppresses the score.

Violation History

No current noncompliance in the accepted 2026Q2 snapshot. The 4 records in the 2021-2026 window are classified as resolved or archived, not current.

Status breakdown for accepted records with record years 2021-2026: 4 resolved, 0 archived, 0 addressed, and 0 unaddressed. Under this source contract, current noncompliance is the sum of addressed and unaddressed records. Archived and resolved records are excluded from current noncompliance.

Recent Violations

Date Contaminant Type Status
July 1, 2023 Surface Water Treatment Rule Non-health-based Resolved
December 30, 2022 Stage 1 DBP Rule Non-health-based Resolved
October 21, 2021 Lead and Copper Rule Non-health-based Resolved
October 1, 2021 Stage 1 DBP Rule Non-health-based Resolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Stage 1 DBP Rule Treatment Failure 2 No
Surface Water Treatment Rule Treatment Failure 1 No
Lead and Copper Rule Treatment Failure 1 No

Lead & Copper

EPA Lead and Copper Rule evidence attributed directly to this water system:

Lead Level Exceeds Action Level Sample Date
0 mg/L No N/A

No copper action-level exceedance record appears for this PWSID in the accepted LCR snapshot. This does not establish a clean copper measurement.

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 2 (Moderate Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20โ€“$50 (DIY kit) ยท Professional inspection: $150โ€“$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking โ€” this helps flush lead from your pipes.

ZIP Codes Served

Coverage: Service area ZIP codes sourced from EPA Community Water System Service Area Boundaries v3 (March 2026 release). These ZIPs reflect the actual deployment footprint recorded by IL or modeled from parcel and building-footprint data.

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Glenwood (IL0311050) on EPA.gov.

Frequently Asked Questions

Is Glenwood water safe to drink?

The accepted 2026Q2 ECHO snapshot shows no current noncompliance for Glenwood; its 4 accepted 2021-2026 records are resolved or archived. Historical compliance status does not establish conditions at a specific tap.

How many people does Glenwood serve?

Glenwood serves approximately 8,956 people across 2 ZIP codes in Illinois.

Where does Glenwood get its water?

The primary water source is surface water.

Federal UCMR5 PFAS Monitoring: Tested Clean

This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). No PFAS compounds were detected.

Samples collected
116

Current MCL reflects the lowest state-enforceable limit (NYS 10 ppt for PFOA/PFOS, effective August 2020). The federal final MCL of 4 ppt for PFOA/PFOS (EPA April 2024 rule) is not enforceable until April 2029. Detections above 4 ppt but below 10 ppt are below current MCL but above the future federal limit.

Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) โ€” per-system federal sampling, 2023โ€“2025. EPA UCMR5 monitoring program โ†’

Understand PFAS health context and filtration โ†’

How Water Systems Appear in Rankings

Water systems are evaluated by violation history, contaminant detections, and service population. Larger systems with more service connections appear in more rankings.

Frequently Asked Questions

Is water from Glenwood safe to drink?
Glenwood has a C safety grade based on 4 recorded violations. Some contaminants may exceed EPA limits - independent testing is recommended.
What contaminants are in Glenwood's water?
Detected contaminants include Stage 1 DBP Rule, Surface Water Treatment Rule, Lead and Copper Rule. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 3 contaminants above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does Glenwood serve?
Glenwood serves approximately 8,956 people with drinking water across 2 ZIP codes.
What is Glenwood's water source?
Glenwood draws water from surface water sources. Source type affects which contaminants are most likely to be present.
What is the demographic profile of Glenwood's service area?
The Glenwood service area has a median household income of $66,230. EPA EJScreen data classifies 46% of the population as disadvantaged, which may indicate greater vulnerability to environmental health risks.
Where does Glenwood get its water?
Glenwood's water is drawn from rivers, lakes, or reservoirs. Surface water sources are more exposed to agricultural runoff, stormwater, and upstream discharges, but they typically receive more intensive treatment before reaching your tap. Based on the exported violation history and environmental factors, the source contamination risk is classified as elevated.

How to cite this page

APA ZipCheckup. (n.d.). Glenwood (IL): 4 EPA Violations. https://zipcheckup.com/water-system/il0311050/
BibTeX
@misc{zipcheckup-water-system-il0311050,
  author = {{ZipCheckup}},
  title  = {{Glenwood (IL): 4 EPA Violations}},
  year   = {n.d.},
  url    = {https://zipcheckup.com/water-system/il0311050/}
}

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter โ†’

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report โ†’

3

Contact your utility

Glenwood (EPA ID: IL0311050) - request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Illinois Glenwood

Get safety alerts for Glenwood, Illinois

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found - check filter options Free tool - no phone call required.