City of Tulare
EPA ID: CA5410015 · 72,131 people served · 3 ZIP codes
Right now, City of Tulare shows 9 EPA violations marked active and unresolved — the provider continues to supply approximately 72,131 residents while each finding awaits closure.
Data: EPA SDWIS Last verified: 2026-04-02
Compliance Trajectory
Stable · Risk tier: High · 84% chance of violation in next 12 months
Violations went from 4 (2021) to 1 (2025). Violation counts have remained relatively steady.
Service Area Map
Coverage area for City of Tulare Source: EPA SDWIS service area boundaries.
Service area boundary — Grade D
Service Area Demographics
The City of Tulare serves a community with a median household income of $75,345 and an estimated 124,677 residents across its service area. Approximately 46% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.
Environmental Justice Note: 78% of the population in this service area is classified as disadvantaged under EPA's EJScreen criteria. Communities with higher disadvantaged populations often face disproportionate environmental and health burdens, including aging water infrastructure and limited resources for remediation.
💧 Where Does Your Water Come From?
City of Tulare's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.
About 1% of homes in Tulare County, California rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.
Infrastructure Risk
Detected Contaminants
How City of Tulare compares to EPA limits
What This Means For You
Lead at 7 mg/L (action level) exceeds the EPA maximum of 0.015 mg/L (action level). Brain damage in children, kidney & blood pressure in adults. Consider reverse osmosis filtration.
Consumer Confidence Report Rule at 4 mg/L exceeds the EPA maximum of mg/L.
Stage 2 DBP Rule at 2 mg/L exceeds the EPA maximum of mg/L.
Stage 1 DBP Rule at 1 mg/L exceeds the EPA maximum of mg/L.
PFAS Detected in Service Area
PFAS ("forever chemicals") have been detected in water serving this system's area. 12 detections recorded. 4 exceed federal EPA limits (4 ppt for PFOA/PFOS). 2 exceed state limits.
Lead was detected in this water system. reverse osmosis filtration can reduce exposure.
Find a certified water filter →Comparable Water Systems
Similar-sized systems in California
Estimated Remediation Costs
Average estimated costs across ZIP codes served by this system
Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.
System Overview
City of Tulare, (EPA ID: CA5410015) is a community water system in California that serves approximately 72,131 people from groundwater sources.
This system provides water to 3 ZIP codes across 2 communities.
Average Home Safety Score: D (52/100)
Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.
Violation History
Recent Violations
| Date | Contaminant | Type | Status |
|---|---|---|---|
| October 17, 2024 | Stage 2 DBP Rule | Health-based | Unresolved |
| October 17, 2024 | Stage 2 DBP Rule | Monitoring | Unresolved |
| January 1, 2023 | Lead | Health-based | Unresolved |
Contaminants Detected
The following contaminants have been flagged in EPA records for this water system:
| Contaminant | Category | Violations | Health-Based |
|---|---|---|---|
| Lead | Inorganic | 7 | Yes |
| Consumer Confidence Report Rule | Reporting Failure | 4 | No |
| Stage 2 DBP Rule | Treatment Failure | 2 | Yes |
| Stage 1 DBP Rule | Treatment Failure | 1 | No |
Health Risk Details
Lead (EPA limit: 0.015 mg/L (action level))
Brain damage in children, kidney & blood pressure in adults At-risk groups: infants, children under 6, pregnant women.
Removal methods: reverse osmosis, distillation, certified carbon block filter (NSF/ANSI 53). Find the right filter →
Lead & Copper
No Lead and Copper Rule sampling data available for this water system.
Radon Risk in Service Area
Dominant radon zone for ZIP codes served by this system: Zone 2 (Moderate Risk)
The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.
Need help with your water quality?
Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400
Find the Right Water FilterFree tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.
ZIP Codes Served
Coverage: 2 ZIP codes confirmed via EPA Community Water System Service Area Boundaries v3 plus 1 additional ZIP inferred from SDWIS registry data. The EPA-confirmed set is the most reliable; SDWIS-inferred entries may be narrower than the real deployment area.
Data Sources
This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for City of Tulare (CA5410015) on EPA.gov.
Frequently Asked Questions
Is City of Tulare water safe to drink?
City of Tulare has recorded 8 health-based violations in the past 5 years. While the system is required to treat water to meet federal standards, you may want to consider additional precautions such as a certified water filter.
How many people does City of Tulare serve?
City of Tulare serves approximately 72,131 people across 3 ZIP codes in California.
Where does City of Tulare get its water?
The primary water source is groundwater.
Federal UCMR5 PFAS Monitoring: Tested Clean
This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). No PFAS compounds were detected.
Current MCL reflects the lowest state-enforceable limit (NYS 10 ppt for PFOA/PFOS, effective August 2020). The federal final MCL of 4 ppt for PFOA/PFOS (EPA April 2024 rule) is not enforceable until April 2029. Detections above 4 ppt but below 10 ppt are below current MCL but above the future federal limit.
Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) — per-system federal sampling, 2023–2025. EPA UCMR5 monitoring program →
Lead Service Line Inventory
Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:
Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.
Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026
ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.
Frequently Asked Questions
What You Can Do
Test your water
Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →
Check your specific ZIP code
Water quality can vary within a system. View nearest ZIP report →
Contact your utility
City of Tulare (EPA ID: CA5410015) — request the latest Consumer Confidence Report or ask about specific contaminants.