Health Violations Found CA 1 HEALTH VIOLATION

San Ardo Water District

EPA ID: CA2700728 · 575 people served · 1 ZIP code

Not yet resolved: 2 EPA violations at San Ardo Water District, affecting about 575 residents.

Data: EPA SDWIS Last verified: 2026-04-02

B · 78
Avg Safety Score
575
People Served
1
ZIP Code Served
2
Violations (5yr)
Groundwater
Water Source
0.001 mg/L
Max Lead Level
Zone 2
Radon Risk · Moderate
1
Contaminants Flagged
$427K
Median Home Value in Service Area

Service Area Map

Coverage area for San Ardo Water District Source: EPA SDWIS service area boundaries.

Service area boundary — Grade B

💧 Where Does Your Water Come From?

Groundwater

San Ardo Water District's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Elevated Risk
Source Contamination Risk
20th
Wastewater Discharge Proximity
60th
Superfund Site Proximity

About 1% of homes in Monterey County, California rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Superfund Proximity Note: This service area ranks in the 60th percentile nationally for proximity to Superfund (NPL) sites. Groundwater sources near contaminated sites may face elevated risk from industrial chemicals.

Infrastructure Risk

63 yr
Avg Pipe Age
Galvanized Steel or Copper
Pipe Material
2 yr
Est. Remaining Life
Moderate Wear
Decay Status
Installed 97% of expected lifespan used End of life

Detected Contaminants

How San Ardo Water District compares to EPA limits

What This Means For You

Stage 2 DBP Rule at 2 mg/L exceeds the EPA maximum of mg/L.

Comparable Water Systems

Similar-sized systems in California

Oak Glen Retreat
576 people
A 2 violations
River Pines Pud
574 people
C 2 violations
0 violations
B 1 violation
Glen Eden Sun Club
566 people
0 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Radon Mitigation Water Filtration
Radon Mitigation $400
Water Filtration $300
Total Estimated Cost $700

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $500

Annual per household (CDC est.)

Estimated Cumulative Cost Per Household

5 years
$2,500
10 years
$5,000
20 years
$10,000

Compare: Estimated remediation cost is $700 (one-time) vs. $5,000 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

San Ardo Water District (EPA ID: CA2700728) is a community water system in California that serves approximately 575 people from groundwater sources.

This system serves ZIP code 93450 in San Ardo.

Average Home Safety Score: B (78/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

1 health-based violation recorded in the past 5 years. 2 remain unresolved.

Recent Violations

Date Contaminant Type Status
October 17, 2024 Stage 2 DBP Rule Health-based Unresolved
October 17, 2024 Stage 2 DBP Rule Monitoring Unresolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Stage 2 DBP Rule Treatment Failure 2 Yes

Lead & Copper

EPA Lead and Copper Rule sampling data for ZIP codes served by this system:

ZIP Code Lead Level Exceeds Limit Sample Date
93450 0.001 mg/L No N/A

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 2 (Moderate Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for San Ardo Water District (CA2700728) on EPA.gov.

Frequently Asked Questions

Is San Ardo Water District water safe to drink?

San Ardo Water District has recorded 1 health-based violation in the past 5 years. While the system is required to treat water to meet federal standards, you may want to consider additional precautions such as a certified water filter.

How many people does San Ardo Water District serve?

San Ardo Water District serves approximately 575 people across 1 ZIP code in California.

Where does San Ardo Water District get its water?

The primary water source is groundwater.

Contact Your Water Utility

Public-record contact information for the water utility serving this system. Use these channels to request water quality reports, ask about service, or report issues directly.

Phone
(831) 627-2349
ZipCheckup is not affiliated with this water utility, does not act as its agent, and does not provide customer support for it. Contact details shown are public-record information from CCR filings. For service issues, contact the utility directly using the information above.

Contact information from San Ardo Water District Consumer Confidence Report.

ZipCheckup is not affiliated with this water utility, does not act as its agent, and does not provide customer support for it. Contact details shown are public-record information from CCR filings. For service issues, contact the utility directly using the information above.

Water Source & Treatment

Where this water originates and how it's treated before reaching your tap.

Source
Groundwater
Drawn from underground aquifers via wells.

Source: San Ardo Water District Consumer Confidence Report.

ZipCheckup is not affiliated with this water utility. Treatment and source data are sourced from the utility's published CCR filings.

Treatment regime

How this utility classifies its treatment process and what each reported treatment chemical does.

Treatment classification
Minimal — disinfection only
Disinfection (typically chlorine) without additional filtration or coagulation stages. Common for groundwater systems where source water meets federal standards after disinfection alone.

Watershed exposure sources reported

Land-use and natural conditions identified in the utility's source-water assessment as potential contamination sources upstream of treatment.

AgricultureIndustrial activitySeptic systemsUrban stormwater runoffMiningOil and gas production

Treatment classification and chemical list sourced from San Ardo Water District Consumer Confidence Report.

Treatment intensity is a ZipCheckup-derived classification based on the chemicals and processes the utility reports. Chemicals and contamination sources are taken verbatim from the utility's CCR filing. Routine federal monitoring and contaminant testing shown elsewhere on this page determine whether the water meets safety standards, not the treatment classification.

Aesthetic water quality

These measurements describe the look, taste, and feel of the water this utility delivers. They are not contaminant violations — they sit alongside federal Secondary Maximum Contaminant Levels (SMCLs) which the EPA publishes as non-enforceable guidance.

Fluoride
0.2 ppm
Utility does not add fluoride
Measured fluoride concentration in parts per million.
EPA secondary MCL: 2.0 ppm
Total dissolved solids
290 ppm
Mineral content remaining after evaporation, including calcium, magnesium, sodium, and other dissolved substances.
EPA secondary MCL: 500 ppm

Aesthetic measurements from San Ardo Water District Consumer Confidence Report.

Aesthetic measurements are reported by the utility from its annual sampling. EPA Secondary MCLs are advisory thresholds — values outside them indicate aesthetic concerns such as taste or appearance, not health violations. Federal contaminant testing is shown in the sections above.

Hard water detected in San Ardo Water District

Your utility reported water hardness of 175 ppm CaCO₃ (10.2 grains per gallon) in its most recent Consumer Confidence Report. This is in the moderately hard range and may cause scale buildup, reduced appliance lifespan, and dry skin or hair.

Solutions for hard water

There are three common approaches to treating hard water: salt-based ion-exchange softeners (most effective, require salt refills), salt-free conditioners (lower maintenance, scale prevention only), and reverse osmosis at the kitchen sink (cooking and drinking water only). Aquasana, EcoWater, Pelican, and SpringWell are among the major US brands.

Recommended Aquasana system for your hardness level

Paid Partner. ZipCheckup earns commission on Aquasana purchases. We do not test water or verify product effectiveness for specific hardness levels — manufacturer claims are theirs alone. Consult a certified water-quality professional for personalized advice.

Hardness data parsed from this utility's most recent Consumer Confidence Report. Severity bands per USGS hard water classification.

Frequently Asked Questions

Is water from San Ardo Water District safe to drink?
San Ardo Water District earns a B safety grade with 2 violations in the past 5 years. Tap water meets EPA standards for most contaminants.
What contaminants are in San Ardo Water District's water?
Detected contaminants include Stage 2 DBP Rule. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 1 contaminant above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does San Ardo Water District serve?
San Ardo Water District serves approximately 575 people with drinking water across 1 ZIP code.
What is San Ardo Water District's water source?
San Ardo Water District draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
Is there lead in San Ardo Water District's water?
The maximum detected lead level is 0.001 mg/L. This is within EPA action level guidelines.
Where does San Ardo Water District get its water?
San Ardo Water District's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table. Based on violation history and environmental factors, the source contamination risk is currently elevated.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

San Ardo Water District (EPA ID: CA2700728) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems California San Ardo Water District

Get safety alerts for San Ardo Water District, California

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found — check filter options Free tool — no phone call required.