Water System Report CA

City of Wasco

EPA ID: CA1510021 · 22,757 people served · 1 ZIP code

City of Wasco carries zero EPA violations in five years — a spotless record for a utility serving 22,757 residents.

Data: EPA SDWIS Last verified: 2026-04-02

B · 83
Avg Safety Score
22,757
People Served
1
ZIP Code Served
0
Violations (5yr)
Groundwater
Water Source
0.0014 mg/L
Max Lead Level
Zone 2
Radon Risk · Moderate
0
Contaminants Flagged
$255K
Median Home Value in Service Area

Compliance Trajectory

Stable · Risk tier: High · 49% chance of violation in next 12 months

Violations went from 2 (2023) to 3 (2024). Violation counts have remained relatively steady.

Service Area Map

Coverage area for City of Wasco Source: EPA SDWIS service area boundaries.

Service area boundary — Grade B

Service Area Demographics

$55,060
Median Household Income
27,266
Service Area Population
67%
Disadvantaged Population
70th
Poverty Percentile
60th
Energy Burden Percentile
55%
Pre-1986 Housing

The City of Wasco serves a community with a median household income of $55,060 and an estimated 27,266 residents across its service area. Approximately 55% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

Environmental Justice Note: 67% of the population in this service area is classified as disadvantaged under EPA's EJScreen criteria. Communities with higher disadvantaged populations often face disproportionate environmental and health burdens, including aging water infrastructure and limited resources for remediation.

💧 Where Does Your Water Come From?

Groundwater

City of Wasco's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Low Risk
Source Contamination Risk
0th
Wastewater Discharge Proximity
30th
Superfund Site Proximity

About 1% of homes in Kern County, California rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Infrastructure Risk

38 yr
Avg Pipe Age
Copper
Pipe Material
32 yr
Est. Remaining Life
Stable
Decay Status
Installed 54% of expected lifespan used End of life

Comparable Water Systems

Similar-sized systems in California

City of Millbrae
22,795 people
C 2 violations
City of Corcoran
22,808 people
C 0 violations
B 10 violations
0 violations
A 0 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Flood Insurance Radon Mitigation
Flood Insurance $1,800
Radon Mitigation $400
Total Estimated Cost $2,200

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

System Overview

City of Wasco, (EPA ID: CA1510021) is a community water system in California that serves approximately 22,757 people from groundwater sources.

This system serves ZIP code 93280 in Wasco.

Average Home Safety Score: B (83/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

No violations recorded — This water system has no recorded EPA violations in the past 5 years.

Lead & Copper

EPA Lead and Copper Rule sampling data for ZIP codes served by this system:

ZIP Code Lead Level Exceeds Limit Sample Date
93280 0.0014 mg/L No N/A

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 2 (Moderate Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Coverage: Service area ZIP codes sourced from EPA Community Water System Service Area Boundaries v3 (March 2026 release). These ZIPs reflect the actual deployment footprint recorded by CA or modeled from parcel and building-footprint data.

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for City of Wasco (CA1510021) on EPA.gov.

Frequently Asked Questions

Is City of Wasco water safe to drink?

Based on EPA records, City of Wasco has no recorded violations in the past 5 years — a positive indicator of water quality management.

How many people does City of Wasco serve?

City of Wasco serves approximately 22,757 people across 1 ZIP code in California.

Where does City of Wasco get its water?

The primary water source is groundwater.

Contact Your Water Utility

Public-record contact information for the water utility serving this system. Use these channels to request water quality reports, ask about service, or report issues directly.

Phone
(661) 758-7271
ZipCheckup is not affiliated with this water utility, does not act as its agent, and does not provide customer support for it. Contact details shown are public-record information from CCR filings. For service issues, contact the utility directly using the information above.

Contact information from City of Wasco Water Department Consumer Confidence Report.

ZipCheckup is not affiliated with this water utility, does not act as its agent, and does not provide customer support for it. Contact details shown are public-record information from CCR filings. For service issues, contact the utility directly using the information above.

Water Source & Treatment

Where this water originates and how it's treated before reaching your tap.

Source
Groundwater
Drawn from underground aquifers via wells.
Disinfectant used
Chlorine
Treatment chemicals reported
chlorine

Source: City of Wasco Water Department Consumer Confidence Report.

ZipCheckup is not affiliated with this water utility. Treatment and source data are sourced from the utility's published CCR filings.

Treatment regime

How this utility classifies its treatment process and what each reported treatment chemical does.

Treatment classification
Standard
Disinfection plus one or more treatment additives — typically corrosion control, pH adjustment, or fluoridation. Standard regime for utilities serving treated municipal water.

Treatment chemicals and what each one does

Chemical names are reported verbatim by the utility. Purpose categories are ZipCheckup annotations based on standard drinking-water treatment practice.

Disinfectant
Inactivates bacteria, viruses, and parasites in the treated water.
chlorine

Treatment classification and chemical list sourced from City of Wasco Water Department Consumer Confidence Report.

Treatment intensity is a ZipCheckup-derived classification based on the chemicals and processes the utility reports. Chemicals and contamination sources are taken verbatim from the utility's CCR filing. Routine federal monitoring and contaminant testing shown elsewhere on this page determine whether the water meets safety standards, not the treatment classification.

Federal UCMR5 PFAS Monitoring: Tested Clean

This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). No PFAS compounds were detected.

Samples collected
348

Current MCL reflects the lowest state-enforceable limit (NYS 10 ppt for PFOA/PFOS, effective August 2020). The federal final MCL of 4 ppt for PFOA/PFOS (EPA April 2024 rule) is not enforceable until April 2029. Detections above 4 ppt but below 10 ppt are below current MCL but above the future federal limit.

Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) — per-system federal sampling, 2023–2025. EPA UCMR5 monitoring program →

Understand PFAS health context and filtration →

Lead Service Line Inventory

Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:

0
Confirmed Lead
0
Galvanized — Replacement Required
0
Unknown Material
5,361
Confirmed Non-Lead

This system reports zero confirmed lead service lines in its inventory. Unknown-material counts may still warrant verification.

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Reported all required service line types
Latest tap sample on 2021-01-01 did not exceed the federal lead action level.
Population served: 22,757
Reported to California

Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

Notable events and violations

This section summarizes events the utility chose to disclose in its most recent Consumer Confidence Report, plus any federal compliance violations the utility recorded against itself. Both lists are utility-authored — ZipCheckup does not audit, judge, or reorder them.

Federal compliance violations on record

These entries are taken verbatim from the utility's CCR violations section. EPA defines four broad violation categories: Maximum Contaminant Level (MCL), Treatment Technique (TT), Monitoring & Reporting (M&R), and Public Notification (PN).

  • MCL · 1,2,3-Trichloropropane [1,2,3-TCP]
    Date not published
    SWRCB recently began regulating 1,2,3-trichloropropane (1,2,3-TCP) and set the maximum contaminant level (MCL) at 5 parts per trillion (ppt). The level detected was 53 ppt, with a range of ND–150 ppt. The city will continue to sample for 1,2,3-TCP monthly and is working to resolve the issue within four years by drilling new wells and treating Well 12.

Violations record from City of Wasco Water Department Consumer Confidence Report.

ZipCheckup note: items above reflect what the utility published in its most recent CCR. Federal violation records are also tracked separately by the EPA Safe Drinking Water Information System (SDWIS) — the SDWIS record is the authoritative federal source for any specific regulatory action.

How Water Systems Appear in Rankings

Water systems are evaluated by violation history, contaminant detections, and service population. Larger systems with more service connections appear in more rankings.

Frequently Asked Questions

Is water from City of Wasco safe to drink?
City of Wasco earns a B safety grade with 0 violations in the past 5 years. Tap water meets EPA standards for most contaminants.
Should I use a water filter?
City of Wasco meets EPA standards, but a water filter can reduce trace contaminants below detectable levels for added peace of mind.
How many people does City of Wasco serve?
City of Wasco serves approximately 22,757 people with drinking water across 1 ZIP code.
What is City of Wasco's water source?
City of Wasco draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
Is there lead in City of Wasco's water?
The maximum detected lead level is 0.0014 mg/L. This is within EPA action level guidelines.
What is the demographic profile of City of Wasco's service area?
The City of Wasco service area has a median household income of $55,060. EPA EJScreen data classifies 67% of the population as disadvantaged, which may indicate greater vulnerability to environmental health risks.
Where does City of Wasco get its water?
City of Wasco's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.
Home Water Systems California City of Wasco

Get safety alerts for City of Wasco, California

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Check your water filter options Free tool — no phone call required.