Copper in Farmington, MN Drinking Water
Copper data for Farmington, Minnesota · 36,681 residents · 1 ZIP code
ZipCheckup's reading of Copper in Farmington, Minnesota: the highest detected level is 0.76 ppb; the EPA limit is 1.3 mg/L (action level). Copper carries a moderate health-risk designation.
Federal water monitoring extends to thousands of public water systems, and in Farmington, Minnesota, that tracking has turned up Copper - the detection is logged in the EPA compliance record and reflects samples collected under routine Safe Drinking Water Act reporting requirements.
Data: EPA SDWIS, CCR Reports, ECHO Last verified: 2026-07-13
Copper in Farmington Tap Water
Copper has been detected in Farmington, Minnesota drinking water at a maximum level of 0.76 ppm — below the EPA action level of 1.3 mg/L (action level).
This analysis covers 36,681 residents across 1 ZIP code in Farmington.
Farmington's overall water quality grade is C (65/100).
Is Copper in Farmington Water Safe?
Copper was detected in Farmington water but currently falls within EPA limits. However, some health organizations argue the EPA action level may not be protective enough.
If you are concerned, a reverse osmosis or nsf 53 carbon block filter can reduce copper levels further.
Copper Levels by ZIP Code
| ZIP Code | Copper Level | EPA Limit | Status |
|---|---|---|---|
| 55024 | 0.76 ppm | 1.3 mg/L (action level) | OK |
Average copper level across Farmington: 0.76 ppb
Health Effects of Copper
- Nausea, vomiting, and diarrhea (short-term, high levels)
- Liver and kidney damage (long-term)
- Particularly dangerous for people with Wilson's disease
- Infants are more sensitive than adults
Health risk severity: Moderate. Governed by the Lead and Copper Rule.
How Copper Gets Into Drinking Water
- Corrosion of copper household plumbing
- Acidic (low pH) water accelerates copper leaching
- New copper pipes leach more than aged ones
- Mining and industrial discharge (rare for tap water)
What to Do About Copper in Farmington Water
- Run water for 30-60 seconds before use (flushes stagnant water)
- Install an NSF 53 or NSF 58 certified filter
- If pH is low, consider a whole-home acid neutralizer
- Test first-draw morning water to check actual copper levels
Look for filters certified under NSF 53 for copper removal.