Monitoring Violations OK

JET

EPA ID: OK2000211 · 230 people served · 1 ZIP code

EPA compliance records for JET show 3 unresolved violations — findings that remain open and are tracked at the federal level, covering a service territory of approximately 230 people.

Data: EPA SDWIS Last verified: 2026-04-02

A · 91
Avg Safety Score
230
People Served
1
ZIP Code Served
8
Violations (5yr)
Groundwater
Water Source
0.0014 mg/L
Max Lead Level
Zone 3
Radon Risk · Low
4
Contaminants Flagged
$82K
Median Home Value in Service Area

Service Area Map

Coverage area for JET Source: EPA SDWIS service area boundaries.

Service area boundary — Grade A

Service Area Demographics

$53,986
Median Household Income
447
Service Area Population
0%
Disadvantaged Population
50th
Poverty Percentile
60th
Energy Burden Percentile
83%
Pre-1986 Housing

The JET serves a community with a median household income of $53,986 and an estimated 447 residents across its service area. Approximately 83% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

💧 Where Does Your Water Come From?

Groundwater

JET's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Moderate Risk
Source Contamination Risk
20th
Wastewater Discharge Proximity
0th
Superfund Site Proximity

About 0% of homes in Alfalfa County, Oklahoma rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Infrastructure Risk

60 yr
Avg Pipe Age
Galvanized Steel or Copper
Pipe Material
5 yr
Est. Remaining Life
Stable
Decay Status
Installed 92% of expected lifespan used End of life

Detected Contaminants

How JET compares to EPA limits

What This Means For You

Contaminant 1019 at 5 mg/L exceeds the EPA maximum of mg/L.

Stage 1 DBP Rule at 1 mg/L exceeds the EPA maximum of mg/L.

Consumer Confidence Report Rule at 1 mg/L exceeds the EPA maximum of mg/L.

Revised Total Coliform Rule at 1 presence exceeds the EPA maximum of presence.

Comparable Water Systems

Similar-sized systems in Oklahoma

0 violations
Mulhall
225 people
0 violations
0 violations
0 violations
C 19 violations

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $1,000

Annual per household (CDC est.)

Estimated Cumulative Cost Per Household

5 years
$5,000
10 years
$10,000
20 years
$20,000

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

JET (EPA ID: OK2000211) is a community water system in Oklahoma that serves approximately 230 people from groundwater sources.

This system serves ZIP code 73749 in Jet.

Average Home Safety Score: A (91/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

8 monitoring/reporting violations recorded. These are procedural violations (missed tests or late reports), not necessarily water safety issues.

Recent Violations

Date Contaminant Type Status
August 1, 2025 Revised Total Coliform Rule Monitoring Unresolved
August 1, 2025 Consumer Confidence Report Rule Monitoring Unresolved
January 1, 2024 Contaminant 1019 Monitoring Resolved
January 1, 2023 Contaminant 1019 Monitoring Unresolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Contaminant 1019 Other Violation 5 No
Stage 1 DBP Rule Treatment Failure 1 No
Consumer Confidence Report Rule Reporting Failure 1 No
Revised Total Coliform Rule Microbiological 1 No

Lead & Copper

EPA Lead and Copper Rule sampling data for ZIP codes served by this system:

ZIP Code Lead Level Exceeds Limit Sample Date
73749 0.0014 mg/L No N/A

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 3 (Low Risk)

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for JET (OK2000211) on EPA.gov.

Frequently Asked Questions

Is JET water safe to drink?

JET has only monitoring/reporting violations, which are procedural in nature. The system meets federal health-based standards.

How many people does JET serve?

JET serves approximately 230 people across 1 ZIP code in Oklahoma.

Where does JET get its water?

The primary water source is groundwater.

Contact Your Water Utility

Public-record contact information for the water utility serving this system. Use these channels to request water quality reports, ask about service, or report issues directly.

Phone
580-626-4401
ZipCheckup is not affiliated with this water utility, does not act as its agent, and does not provide customer support for it. Contact details shown are public-record information from CCR filings. For service issues, contact the utility directly using the information above.
Address
BOX 247, JET OK, 73749

Contact information from JET Consumer Confidence Report.

ZipCheckup is not affiliated with this water utility, does not act as its agent, and does not provide customer support for it. Contact details shown are public-record information from CCR filings. For service issues, contact the utility directly using the information above.

Water Source & Treatment

Where this water originates and how it's treated before reaching your tap.

Source
Groundwater
Drawn from underground aquifers via wells.
Disinfectant used
Multiple methods
Treatment chemicals reported
fluoride

Source: JET Consumer Confidence Report.

ZipCheckup is not affiliated with this water utility. Treatment and source data are sourced from the utility's published CCR filings.

Treatment regime

How this utility classifies its treatment process and what each reported treatment chemical does.

Treatment classification
Multi-stage
Multiple treatment stages — typically coagulation, filtration, and disinfection. Common for surface-water systems requiring removal of particulates, microorganisms, and dissolved organic compounds before disinfection.

Treatment chemicals and what each one does

Chemical names are reported verbatim by the utility. Purpose categories are ZipCheckup annotations based on standard drinking-water treatment practice.

Fluoridation
Added at low levels per state or local public-health policy for dental health.
fluoride

Watershed exposure sources reported

Land-use and natural conditions identified in the utility's source-water assessment as potential contamination sources upstream of treatment.

AgricultureIndustrial activityUrban runoffMining

Treatment classification and chemical list sourced from JET Consumer Confidence Report.

Treatment intensity is a ZipCheckup-derived classification based on the chemicals and processes the utility reports. Chemicals and contamination sources are taken verbatim from the utility's CCR filing. Routine federal monitoring and contaminant testing shown elsewhere on this page determine whether the water meets safety standards, not the treatment classification.

Lead Service Line Inventory

Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:

0
Confirmed Lead
0
Galvanized — Replacement Required
148
Unknown Material
0
Confirmed Non-Lead

This system reports zero confirmed lead service lines in its inventory. Unknown-material counts may still warrant verification.

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Reported all required service line types
Latest tap sample on 2025-07-01 did not exceed the federal lead action level.
Population served: 230
Reported to Oklahoma

Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

Aesthetic water quality

These measurements describe the look, taste, and feel of the water this utility delivers. They are not contaminant violations — they sit alongside federal Secondary Maximum Contaminant Levels (SMCLs) which the EPA publishes as non-enforceable guidance.

pH
7.3
How acidic or basic the water is on a 0-14 scale. Drinking water is typically near neutral.
EPA secondary range: 6.5 – 8.5
Fluoride
0.1 ppm
Utility adds fluoride
Measured fluoride concentration in parts per million.
EPA secondary MCL: 2.0 ppm
Alkalinity
36 ppm CaCO₃
Capacity of the water to neutralize acids, expressed as calcium carbonate equivalent.

Aesthetic measurements from JET Consumer Confidence Report.

Aesthetic measurements are reported by the utility from its annual sampling. EPA Secondary MCLs are advisory thresholds — values outside them indicate aesthetic concerns such as taste or appearance, not health violations. Federal contaminant testing is shown in the sections above.

Notable events and violations

This section summarizes events the utility chose to disclose in its most recent Consumer Confidence Report, plus any federal compliance violations the utility recorded against itself. Both lists are utility-authored — ZipCheckup does not audit, judge, or reorder them.

Federal compliance violations on record

These entries are taken verbatim from the utility's CCR violations section. EPA defines four broad violation categories: Maximum Contaminant Level (MCL), Treatment Technique (TT), Monitoring & Reporting (M&R), and Public Notification (PN).

  • monitoring · WATER QUALITY PARAMS
    2024-01-01/2024-06-30
    Missed monitoring samples for lead and copper (Water Quality Parameter M/R under LCR).

Violations record from JET Consumer Confidence Report.

Notable events from the utility's CCR

These bullet entries are the utility's own narration of operational, regulatory, or infrastructure events during the reporting period.

Notable events from JET Consumer Confidence Report:
  • Monitoring violation for lead/copper samples missed 1/1/2024–6/30/2024 (samples taken in future; no adverse health impact expected)

ZipCheckup note: items above reflect what the utility published in its most recent CCR. Federal violation records are also tracked separately by the EPA Safe Drinking Water Information System (SDWIS) — the SDWIS record is the authoritative federal source for any specific regulatory action.

Frequently Asked Questions

Is water from JET safe to drink?
JET earns a A safety grade with 8 violations in the past 5 years. Tap water meets EPA standards for most contaminants.
What contaminants are in JET's water?
Detected contaminants include Contaminant 1019, Stage 1 DBP Rule, Consumer Confidence Report Rule, Revised Total Coliform Rule. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 4 contaminants above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does JET serve?
JET serves approximately 230 people with drinking water across 1 ZIP code.
What is JET's water source?
JET draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
Is there lead in JET's water?
The maximum detected lead level is 0.0014 mg/L. This is within EPA action level guidelines.
What is the demographic profile of JET's service area?
The JET service area has a median household income of $53,986. Demographic data is sourced from the U.S. Census Bureau and EPA EJScreen.
Where does JET get its water?
JET's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table. Based on available data, the source contamination risk is moderate.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

JET (EPA ID: OK2000211) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Oklahoma JET

Get safety alerts for JET, Oklahoma

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found — check filter options Free tool — no phone call required.