Monitoring Violations NH

Milford Water Utilities Department

EPA ID: NH1561010 · 9,500 people served · 1 ZIP code

Even though Milford Water Utilities Department accumulated 2 violations over five years, all have been formally resolved — the provider currently meets EPA standards for 9,500 people.

Data: EPA SDWIS Last verified: 2026-04-02

B · 82
Avg Safety Score
9,500
People Served
1
ZIP Code Served
2
Violations (5yr)
Surface Water
Water Source
0.002 mg/L
Max Lead Level
Zone 2
Radon Risk · Moderate
1
Contaminants Flagged
$364K
Median Home Value in Service Area

Service Area Map

Coverage area for Milford Water Utilities Department Source: EPA SDWIS service area boundaries.

Service area boundary — Grade B

Service Area Demographics

$94,514
Median Household Income
16,258
Service Area Population
18%
Disadvantaged Population
30th
Poverty Percentile
60th
Energy Burden Percentile
61%
Pre-1986 Housing

The Milford Water Utilities Department serves a community with a median household income of $94,514 and an estimated 16,258 residents across its service area. Approximately 61% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

🌊 Where Does Your Water Come From?

Surface Water

Milford Water Utilities Department's water is drawn from rivers, lakes, or reservoirs. Surface water sources are more exposed to agricultural runoff, stormwater, and upstream discharges, but they typically receive more intensive treatment before reaching your tap.

Moderate Risk
Source Contamination Risk
40th
Wastewater Discharge Proximity
70th
Superfund Site Proximity

About 1% of homes in Hillsborough County, New Hampshire rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Superfund Proximity Note: This service area ranks in the 70th percentile nationally for proximity to Superfund (NPL) sites.

Infrastructure Risk

38 yr
Avg Pipe Age
Copper
Pipe Material
32 yr
Est. Remaining Life
Stable
Decay Status
Installed 54% of expected lifespan used End of life

Detected Contaminants

How Milford Water Utilities Department compares to EPA limits

What This Means For You

Stage 1 DBP Rule at 2 mg/L exceeds the EPA maximum of mg/L.

Comparable Water Systems

Similar-sized systems in New Hampshire

Berlin Water Works
9,575 people
B 1 violation
Pease Trade Port
9,900 people
0 violations
B 1 violation
Lebanon Water Department
10,050 people
B 2 violations
C 0 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Flood Insurance Radon Mitigation
Flood Insurance $1,200
Radon Mitigation $400
Total Estimated Cost $1,600

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $500

Annual per household (CDC est.)

Estimated Cumulative Cost Per Household

5 years
$2,500
10 years
$5,000
20 years
$10,000

Compare: Estimated remediation cost is $1,600 (one-time) vs. $5,000 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

Milford Water Utilities Department (EPA ID: NH1561010) is a community water system in New Hampshire that serves approximately 9,500 people from surface water sources.

This system serves ZIP code 03055 in Milford.

Average Home Safety Score: B (82/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

2 monitoring/reporting violations recorded. These are procedural violations (missed tests or late reports), not necessarily water safety issues.

Recent Violations

Date Contaminant Type Status
January 1, 2024 Stage 1 DBP Rule Monitoring Resolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Stage 1 DBP Rule Treatment Failure 2 No

Lead & Copper

EPA Lead and Copper Rule sampling data for ZIP codes served by this system:

ZIP Code Lead Level Exceeds Limit Sample Date
03055 0.002 mg/L No N/A

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 2 (Moderate Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Coverage: Service area ZIP codes sourced from EPA Community Water System Service Area Boundaries v3 (March 2026 release). These ZIPs reflect the actual deployment footprint recorded by NH or modeled from parcel and building-footprint data.

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Milford Water Utilities Department (NH1561010) on EPA.gov.

Frequently Asked Questions

Is Milford Water Utilities Department water safe to drink?

Milford Water Utilities Department has only monitoring/reporting violations, which are procedural in nature. The system meets federal health-based standards.

How many people does Milford Water Utilities Department serve?

Milford Water Utilities Department serves approximately 9,500 people across 1 ZIP code in New Hampshire.

Where does Milford Water Utilities Department get its water?

The primary water source is surface water.

Federal UCMR5 PFAS Monitoring: Tested Clean

This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). No PFAS compounds were detected.

Samples collected
174

Current MCL reflects the lowest state-enforceable limit (NYS 10 ppt for PFOA/PFOS, effective August 2020). The federal final MCL of 4 ppt for PFOA/PFOS (EPA April 2024 rule) is not enforceable until April 2029. Detections above 4 ppt but below 10 ppt are below current MCL but above the future federal limit.

Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) — per-system federal sampling, 2023–2025. EPA UCMR5 monitoring program →

Understand PFAS health context and filtration →

Lead Service Line Inventory

Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:

0
Confirmed Lead
0
Galvanized — Replacement Required
2,945
Unknown Material
0
Confirmed Non-Lead

This system reports zero confirmed lead service lines in its inventory. Unknown-material counts may still warrant verification.

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Reported some but not all service line types
Latest tap sample on 2022-01-01 did not exceed the federal lead action level.
Population served: 9,500
Reported to New Hampshire

Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

How Water Systems Appear in Rankings

Water systems are evaluated by violation history, contaminant detections, and service population. Larger systems with more service connections appear in more rankings.

Frequently Asked Questions

Is water from Milford Water Utilities Department safe to drink?
Milford Water Utilities Department earns a B safety grade with 2 violations in the past 5 years. Tap water meets EPA standards for most contaminants.
What contaminants are in Milford Water Utilities Department's water?
Detected contaminants include Stage 1 DBP Rule. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 1 contaminant above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does Milford Water Utilities Department serve?
Milford Water Utilities Department serves approximately 9,500 people with drinking water across 1 ZIP code.
What is Milford Water Utilities Department's water source?
Milford Water Utilities Department draws water from surface water sources. Source type affects which contaminants are most likely to be present.
Is there lead in Milford Water Utilities Department's water?
The maximum detected lead level is 0.002 mg/L. This is within EPA action level guidelines.
What is the demographic profile of Milford Water Utilities Department's service area?
The Milford Water Utilities Department service area has a median household income of $94,514. Demographic data is sourced from the U.S. Census Bureau and EPA EJScreen.
Where does Milford Water Utilities Department get its water?
Milford Water Utilities Department's water is drawn from rivers, lakes, or reservoirs. Surface water sources are more exposed to agricultural runoff, stormwater, and upstream discharges, but they typically receive more intensive treatment before reaching your tap. Based on available data, the source contamination risk is moderate.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

Milford Water Utilities Department (EPA ID: NH1561010) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems New Hampshire Milford Water Utilities Department

Get safety alerts for Milford Water Utilities Department, New Hampshire

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found — check filter options Free tool — no phone call required.