Health Violations Found MT 18 HEALTH VIOLATIONS

Whitehall Town of

EPA ID: MT0000359 · 1,500 people served · 3 ZIP codes

Based on the latest federal compliance data, Whitehall Town of has 18 violations that the EPA has not yet closed — those outstanding findings are part of the enforcement record for a utility that delivers water to approximately 1,500 people throughout its service territory.

Data: EPA SDWIS Last verified: 2026-04-02

D · 42
Avg Safety Score
1,500
People Served
3
ZIP Codes Served
22
Violations (5yr)
Groundwater
Water Source
0.002 mg/L
Max Lead Level
Zone 1
Radon Risk · High
4
Contaminants Flagged
$335K
Median Home Value in Service Area

Compliance Trajectory

Worsening · Risk tier: High · 95% chance of violation in next 12 months

Violations went from 6 (2022) to 3 (2026). The pattern suggests growing compliance challenges.

Service Area Map

Coverage area for Whitehall Town of Source: EPA SDWIS service area boundaries.

Service area boundary — Grade D

Service Area Demographics

$64,375
Median Household Income
4,213
Service Area Population
0%
Disadvantaged Population
53th
Poverty Percentile
80th
Energy Burden Percentile
50%
Pre-1986 Housing

The Whitehall Town of serves a community with a median household income of $64,375 and an estimated 4,213 residents across its service area. Approximately 50% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

💧 Where Does Your Water Come From?

Groundwater

Whitehall Town of's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Elevated Risk
Source Contamination Risk
13th
Wastewater Discharge Proximity
27th
Superfund Site Proximity

About 0% of homes in Madison County, Montana rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Infrastructure Risk

41 yr
Avg Pipe Age
Copper
Pipe Material
29 yr
Est. Remaining Life
Moderate Wear
Decay Status
Installed 59% of expected lifespan used End of life

Detected Contaminants

How Whitehall Town of compares to EPA limits

Combined Radium 18 pCi/L (EXCEEDS LIMIT)
0 EPA Limit: 5 pCi/L

What This Means For You

Combined Radium at 18 pCi/L exceeds the EPA maximum of 5 pCi/L.

Total Coliform at 2 presence exceeds the EPA maximum of presence.

Gross Alpha at 1 pCi/L exceeds the EPA maximum of pCi/L. Increased cancer risk from radioactive particles. Consider reverse osmosis filtration.

Consumer Confidence Report Rule at 1 mg/L exceeds the EPA maximum of mg/L.

Gross Alpha was detected in this water system. reverse osmosis filtration can reduce exposure.

Find a certified water filter →

Comparable Water Systems

Similar-sized systems in Montana

City of Fort Benton
1,500 people
0 violations
C 13 violations
C 0 violations
City of Boulder
1,400 people
D 2 violations
Ennis Town of
1,400 people
D 1 violation

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Radon Mitigation Flood Insurance Water Filtration
Radon Mitigation $1,200
Flood Insurance $400
Water Filtration $200
Total Estimated Cost $1,800

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $1,500

Annual per household (CDC est.)

Estimated Property Value Decline $16,750

5% of median home value (EPA est.)

Estimated Cumulative Cost Per Household

5 years
$15,875
10 years
$31,750
20 years
$63,500

Compare: Estimated remediation cost is $1,800 (one-time) vs. $31,750 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

WHITEHALL TOWN OF (EPA ID: MT0000359) is a community water system in Montana that serves approximately 1,500 people from groundwater sources.

This system provides water to 3 ZIP codes across 3 communities.

Average Home Safety Score: D (42/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

18 health-based violations recorded in the past 5 years. 18 remain unresolved.

Recent Violations

Date Contaminant Type Status
July 1, 2025 Gross Alpha Health-based Unresolved
April 1, 2025 Combined Radium Health-based Unresolved
January 1, 2025 Combined Radium Health-based Unresolved
December 26, 2024 Total Coliform Monitoring Resolved
November 28, 2024 Total Coliform Monitoring Resolved
October 1, 2024 Combined Radium Health-based Unresolved
July 1, 2024 Combined Radium Health-based Unresolved
April 1, 2024 Combined Radium Health-based Unresolved
January 1, 2024 Combined Radium Health-based Unresolved
October 1, 2023 Combined Radium Health-based Unresolved
August 1, 2023 Consumer Confidence Report Rule Monitoring Resolved
July 1, 2023 Combined Radium Monitoring Resolved
April 1, 2023 Combined Radium Health-based Unresolved
January 1, 2023 Combined Radium Health-based Unresolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Combined Radium Radionuclides 18 Yes
Total Coliform Microbiological 2 No
Gross Alpha Radionuclides 1 Yes
Consumer Confidence Report Rule Reporting Failure 1 No

Health Risk Details

Gross Alpha Particle Activity (EPA limit: pCi/L)

Increased cancer risk from radioactive particles At-risk groups: long-term residents in areas with uranium or radium-rich geology, people on private wells in western US.

Removal methods: reverse osmosis, ion exchange (anion exchange for radium), lime softening. Find the right filter →

Lead & Copper

EPA Lead and Copper Rule sampling data for ZIP codes served by this system:

ZIP Code Lead Level Exceeds Limit Sample Date
59759 0.002 mg/L No N/A

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 1 (High Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Whitehall Town of (MT0000359) on EPA.gov.

Frequently Asked Questions

Is Whitehall Town of water safe to drink?

Whitehall Town of has recorded 18 health-based violations in the past 5 years. While the system is required to treat water to meet federal standards, you may want to consider additional precautions such as a certified water filter.

How many people does Whitehall Town of serve?

Whitehall Town of serves approximately 1,500 people across 3 ZIP codes in Montana.

Where does Whitehall Town of get its water?

The primary water source is groundwater.

Water Source & Treatment

Where this water originates and how it's treated before reaching your tap.

Source
Groundwater
Drawn from underground aquifers via wells.

Source: WHITEHALL TOWN OF Consumer Confidence Report.

ZipCheckup is not affiliated with this water utility. Treatment and source data are sourced from the utility's published CCR filings.

Source water assessment from WHITEHALL TOWN OF Consumer Confidence Report:
The source water assessment report for your water system provides additional information on your source water's susceptibility to contamination. To access this report please go to: https://deq.mt.gov/water/Programs/dw-sourcewater

Treatment regime

How this utility classifies its treatment process and what each reported treatment chemical does.

Treatment classification
Minimal — disinfection only
Disinfection (typically chlorine) without additional filtration or coagulation stages. Common for groundwater systems where source water meets federal standards after disinfection alone.

Watershed exposure sources reported

Land-use and natural conditions identified in the utility's source-water assessment as potential contamination sources upstream of treatment.

Sewage treatment plantsSepticsystemsAgriculturallivestockoperationsWildlifeUrbanstormwaterrunoffIndustrialordomesticwastewaterdischargesOilandgasproductionMiningFarmingPesticide applicationHerbicidesGasstationsNaturally-occurringmineralsRadioactivenaturalorindustrial

Treatment classification and chemical list sourced from WHITEHALL TOWN OF Consumer Confidence Report.

Treatment intensity is a ZipCheckup-derived classification based on the chemicals and processes the utility reports. Chemicals and contamination sources are taken verbatim from the utility's CCR filing. Routine federal monitoring and contaminant testing shown elsewhere on this page determine whether the water meets safety standards, not the treatment classification.

Lead Service Line Inventory

Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:

0
Confirmed Lead
0
Galvanized — Replacement Required
31
Unknown Material
502
Confirmed Non-Lead

This system reports zero confirmed lead service lines in its inventory. Unknown-material counts may still warrant verification.

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Reported all required service line types
Latest tap sample on 2021-01-01 did not exceed the federal lead action level.
Population served: 1,500
Reported to Montana

Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

Notable events and violations

This section summarizes events the utility chose to disclose in its most recent Consumer Confidence Report, plus any federal compliance violations the utility recorded against itself. Both lists are utility-authored — ZipCheckup does not audit, judge, or reorder them.

Federal compliance violations on record

These entries are taken verbatim from the utility's CCR violations section. EPA defines four broad violation categories: Maximum Contaminant Level (MCL), Treatment Technique (TT), Monitoring & Reporting (M&R), and Public Notification (PN).

  • monitoring
    2024-11-28 to 2024-12-02
    Failed to collect follow-up samples within 24 hours of learning of the total coliform-positive sample. These needed to be tested for fecal indicators from all sources that were being used at the time the positive sample was collected.
  • monitoring
    2024-12-26 to 2025-01-27
    Failed to collect follow-up samples within 24 hours of learning of the total coliform-positive sample. These needed to be tested for fecal indicators from all sources that were being used at the time the positive sample was collected.
  • MCL · Uranium
    2024-01-01 to 2024-03-31
    Water samples showed that the amount of Uranium in our drinking water was above its standard (called a maximum contaminant level and abbreviated MCL) for the period indicated.
  • MCL · Uranium
    2024-04-01 to 2024-06-30
    Water samples showed that the amount of Uranium in our drinking water was above its standard (called a maximum contaminant level and abbreviated MCL) for the period indicated.
  • MCL · Uranium
    2024-07-01 to 2024-09-30
    Water samples showed that the amount of Uranium in our drinking water was above its standard (called a maximum contaminant level and abbreviated MCL) for the period indicated.
  • MCL · Uranium
    2024-10-01 to 2024-12-31
    Water samples showed that the amount of Uranium in our drinking water was above its standard (called a maximum contaminant level and abbreviated MCL) for the period indicated.

Violations record from WHITEHALL TOWN OF Consumer Confidence Report.

ZipCheckup note: items above reflect what the utility published in its most recent CCR. Federal violation records are also tracked separately by the EPA Safe Drinking Water Information System (SDWIS) — the SDWIS record is the authoritative federal source for any specific regulatory action.

Frequently Asked Questions

Is water from Whitehall Town of safe to drink?
Whitehall Town of has a D safety grade based on 22 recorded violations. Some contaminants may exceed EPA limits — independent testing is recommended.
What contaminants are in Whitehall Town of's water?
Detected contaminants include Combined Radium, Total Coliform, Gross Alpha, Consumer Confidence Report Rule. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 4 contaminants above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does Whitehall Town of serve?
Whitehall Town of serves approximately 1,500 people with drinking water across 3 ZIP codes.
What is Whitehall Town of's water source?
Whitehall Town of draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
Is there lead in Whitehall Town of's water?
The maximum detected lead level is 0.002 mg/L. This is within EPA action level guidelines.
What is the demographic profile of Whitehall Town of's service area?
The Whitehall Town of service area has a median household income of $64,375. Demographic data is sourced from the U.S. Census Bureau and EPA EJScreen.
Where does Whitehall Town of get its water?
Whitehall Town of's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table. Based on violation history and environmental factors, the source contamination risk is currently elevated.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

Whitehall Town of (EPA ID: MT0000359) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Montana Whitehall Town of

Get safety alerts for Whitehall Town of, Montana

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found — check filter options Free tool — no phone call required.