Columbus Light & Water
EPA ID: MS0440003 · 23,616 people served · 7 ZIP codes
Federal data shows 4 unresolved violations at Columbus Light & Water — roughly 23,616 residents in the service area.
Data: EPA SDWIS Last verified: 2026-04-02
Service Area Map
Coverage area for Columbus Light & Water Source: EPA SDWIS service area boundaries.
Service area boundary — Grade C
Service Area Demographics
The Columbus Light & Water serves a community with a median household income of $56,349 and an estimated 51,182 residents across its service area. Approximately 59% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.
Environmental Justice Note: 57% of the population in this service area is classified as disadvantaged under EPA's EJScreen criteria. Communities with higher disadvantaged populations often face disproportionate environmental and health burdens, including aging water infrastructure and limited resources for remediation.
💧 Where Does Your Water Come From?
Columbus Light & Water's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.
About 0% of homes in Lowndes County, Mississippi rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.
Wastewater Proximity Note: This service area ranks in the 60th percentile nationally for proximity to wastewater discharge points.
Superfund Proximity Note: This service area ranks in the 80th percentile nationally for proximity to Superfund (NPL) sites. Groundwater sources near contaminated sites may face elevated risk from industrial chemicals.
Infrastructure Risk
Detected Contaminants
How Columbus Light & Water compares to EPA limits
What This Means For You
Total Trihalomethanes (TTHM) at 4 mg/L exceeds the EPA maximum of 0.08 mg/L. Bladder & rectal cancer risk; reproductive concerns. Consider granular activated carbon (GAC) filtration.
Total Trihalomethanes (TTHM) was detected in this water system. granular activated carbon (GAC) filtration can reduce exposure.
Find a certified water filter →Comparable Water Systems
Similar-sized systems in Mississippi
Estimated Remediation Costs
Average estimated costs across ZIP codes served by this system
Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.
System Overview
Columbus Light & Water (EPA ID: MS0440003) is a community water system in Mississippi that serves approximately 23,616 people from groundwater sources.
This system provides water to 7 ZIP codes across 2 communities.
Average Home Safety Score: C (67/100)
Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.
Violation History
Recent Violations
| Date | Contaminant | Type | Status |
|---|---|---|---|
| January 1, 2024 | Total Trihalomethanes (TTHM) | Monitoring | Unresolved |
| January 1, 2023 | Total Trihalomethanes (TTHM) | Monitoring | Unresolved |
Contaminants Detected
The following contaminants have been flagged in EPA records for this water system:
| Contaminant | Category | Violations | Health-Based |
|---|---|---|---|
| Total Trihalomethanes (TTHM) | Disinfection Byproducts | 4 | No |
Lead & Copper
EPA Lead and Copper Rule sampling data for ZIP codes served by this system:
| ZIP Code | Lead Level | Exceeds Limit | Sample Date |
|---|---|---|---|
| 39701 | 0.0005 mg/L | No | N/A |
| 39702 | 0.0005 mg/L | No | N/A |
| 39703 | 0.0005 mg/L | No | N/A |
| 39704 | 0.0005 mg/L | No | N/A |
| 39705 | 0.0005 mg/L | No | N/A |
| 39710 | 0.0005 mg/L | No | N/A |
Radon Risk in Service Area
Dominant radon zone for ZIP codes served by this system: Zone 2 (Moderate Risk)
The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.
Need help with your water quality?
Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400
Find the Right Water FilterFree tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.
ZIP Codes Served
Coverage: 3 ZIP codes confirmed via EPA Community Water System Service Area Boundaries v3 plus 4 additional ZIPs inferred from SDWIS registry data. The EPA-confirmed set is the most reliable; SDWIS-inferred entries may be narrower than the real deployment area.
- 39701 — Columbus
- 39702 — Columbus
- 39703 — Columbus
- 39704 — Columbus
- 39705 — Columbus
- 39710 — Columbus
- 39766 — Steens
Data Sources
This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Columbus Light & Water (MS0440003) on EPA.gov.
Frequently Asked Questions
Is Columbus Light & Water water safe to drink?
Columbus Light & Water has only monitoring/reporting violations, which are procedural in nature. The system meets federal health-based standards.
How many people does Columbus Light & Water serve?
Columbus Light & Water serves approximately 23,616 people across 7 ZIP codes in Mississippi.
Where does Columbus Light & Water get its water?
The primary water source is groundwater.
Contact Your Water Utility
Public-record contact information for the water utility serving this system. Use these channels to request water quality reports, ask about service, or report issues directly.
Contact information from Columbus Light and Water Consumer Confidence Report.
ZipCheckup is not affiliated with this water utility, does not act as its agent, and does not provide customer support for it. Contact details shown are public-record information from CCR filings. For service issues, contact the utility directly using the information above.
Water Source & Treatment
Where this water originates and how it's treated before reaching your tap.
Source: Columbus Light and Water Consumer Confidence Report.
ZipCheckup is not affiliated with this water utility. Treatment and source data are sourced from the utility's published CCR filings.
The source water assessment has been completed for our public water system to identify potential sources of contamination and determine the overall susceptibility of the drinking water supply. Susceptibility assessment has been completed and all wells have ranked moderate by the MDEQ for vulnerability to contamination.
Treatment regime
How this utility classifies its treatment process and what each reported treatment chemical does.
Treatment classification and chemical list sourced from Columbus Light and Water Consumer Confidence Report.
Treatment intensity is a ZipCheckup-derived classification based on the chemicals and processes the utility reports. Chemicals and contamination sources are taken verbatim from the utility's CCR filing. Routine federal monitoring and contaminant testing shown elsewhere on this page determine whether the water meets safety standards, not the treatment classification.
Federal UCMR5 PFAS Monitoring: Tested Clean
This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). No PFAS compounds were detected.
Current MCL reflects the lowest state-enforceable limit (NYS 10 ppt for PFOA/PFOS, effective August 2020). The federal final MCL of 4 ppt for PFOA/PFOS (EPA April 2024 rule) is not enforceable until April 2029. Detections above 4 ppt but below 10 ppt are below current MCL but above the future federal limit.
Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) — per-system federal sampling, 2023–2025. EPA UCMR5 monitoring program →
PFAS Substances Detected in This System
This water system's Consumer Confidence Report disclosed the following PFAS compounds. Levels are from the utility's most recent reporting cycle.
In April 2024, EPA finalized the first National Primary Drinking Water Regulation for six PFAS. Public water systems have until 2029 to comply. EPA — PFAS regulation overview →
Source: Consumer Confidence Report disclosed by Columbus Light and Water.
ZipCheckup is not affiliated with this water utility. PFAS detection data is sourced from public Consumer Confidence Reports filed by the utility itself.
Lead Service Line Replacement Tracker
This water utility's lead service line (LSL) replacement program is tracked from public Consumer Confidence Report filings. Email signup notifies subscribers when the utility files an updated replacement plan or progress milestone.
Columbus Light and Water
ZipCheckup is not affiliated with this water utility. LSL replacement-program data is sourced from public CCR filings published by the utility. Subscription notifications are based on automated parsing of subsequent CCR releases.
Learn more about Lead and Copper Rule replacement requirements →
Lead Service Line Inventory
Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:
This system reports zero confirmed lead service lines in its inventory. Unknown-material counts may still warrant verification.
Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.
Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026
ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.
How Water Systems Appear in Rankings
Water systems are evaluated by violation history, contaminant detections, and service population. Larger systems with more service connections appear in more rankings.
Frequently Asked Questions
What You Can Do
Test your water
Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →
Check your specific ZIP code
Water quality can vary within a system. View nearest ZIP report →
Contact your utility
Columbus Light & Water (EPA ID: MS0440003) — request the latest Consumer Confidence Report or ask about specific contaminants.