Washington Public Water System
EPA ID: MO6010838 · 14,068 people served · 3 ZIP codes
ZipCheckup's reading of EPA SDWIS for Washington Public Water System (MO6010838): 1 unresolved EPA violation on record. Compliance tracking for Washington Public Water System shows 1 pending violation logged in the EPA system - the supplier delivers water to approximately 14,068 residents while those findings remain open.
Data: EPA SDWIS
Service Area Map
Coverage area for Washington Public Water System Source: EPA SDWIS service area boundaries.
Service area boundary
Service Area Demographics
The Washington Public Water System serves a community with a median household income of $72,332 and an estimated 48,912 residents across its service area. Approximately 51% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.
💧 Where Does Your Water Come From?
Washington Public Water System's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.
Wastewater Proximity Note: This service area ranks in the 80th percentile nationally for proximity to wastewater discharge points.
Superfund Proximity Note: This service area ranks in the 70th percentile nationally for proximity to Superfund (NPL) sites. Groundwater sources near contaminated sites may face elevated risk from industrial chemicals.
Infrastructure Risk
Detected Contaminants
How Washington Public Water System compares to EPA limits
What This Means For You
Haloacetic Acids (HAA5) at 1 mg/L exceeds the EPA maximum of 0.06 mg/L. Cancer risk; reproductive & developmental effects. Consider granular activated carbon (GAC) filtration.
Total Trihalomethanes (TTHM) at 1 mg/L exceeds the EPA maximum of 0.08 mg/L. Bladder & rectal cancer risk; reproductive concerns. Consider granular activated carbon (GAC) filtration.
Stage 2 DBP Rule at 1 mg/L exceeds the EPA maximum of mg/L.
Lead and Copper Rule at 1 mg/L exceeds the EPA maximum of mg/L.
Contaminant 0700 at 1 mg/L exceeds the EPA maximum of mg/L.
PFAS Detected in Service Area
PFAS ("forever chemicals") have been detected in water serving this system's area. 1 detection recorded.
Haloacetic Acids (HAA5) was detected in this water system. granular activated carbon (GAC) filtration can reduce exposure.
Find a certified water filter →Comparable Water Systems
Similar-sized systems in Missouri
Estimated Remediation Costs
Average estimated costs across ZIP codes served by this system
Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.
System Overview
Washington Public Water System (EPA ID: MO6010838) is a community water system in Missouri that serves approximately 14,068 people from groundwater sources.
This system provides water to 3 ZIP codes across 3 communities.
Violation History
Status breakdown for accepted records with record years 2021-2026: 4 resolved, 0 archived, 0 addressed, and 1 unaddressed. Under this source contract, current noncompliance is the sum of addressed and unaddressed records. Archived and resolved records are excluded from current noncompliance.
Recent Violations
| Date | Contaminant | Type | Status |
|---|---|---|---|
| July 2, 2025 | Stage 2 DBP Rule | Non-health-based | Unaddressed (current) |
| November 24, 2024 | Lead and Copper Rule | Non-health-based | Resolved |
| July 9, 2024 | Contaminant 0700 | Health-based | Resolved |
| January 1, 2024 | Haloacetic Acids (HAA5) | Non-health-based | Resolved |
| January 1, 2024 | Total Trihalomethanes (TTHM) | Non-health-based | Resolved |
Contaminants Detected
The following contaminants have been flagged in EPA records for this water system:
| Contaminant | Category | Violations | Health-Based |
|---|---|---|---|
| Total Trihalomethanes (TTHM) | Disinfection Byproducts | 1 | No |
| Haloacetic Acids (HAA5) | Disinfection Byproducts | 1 | No |
| Stage 2 DBP Rule | Treatment Failure | 1 | No |
| Lead and Copper Rule | Treatment Failure | 1 | No |
| Contaminant 0700 | Other Violation | 1 | Yes |
Lead & Copper
EPA Lead and Copper Rule evidence attributed directly to this water system:
| Lead Level | Exceeds Action Level | Sample Date |
|---|---|---|
| 0.00262 mg/L | No | N/A |
No copper action-level exceedance record appears for this PWSID in the accepted LCR snapshot. This does not establish a clean copper measurement.
Radon Risk in Service Area
Dominant radon zone for ZIP codes served by this system: Zone 2 (Moderate Risk)
The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.
Need help with your water quality?
Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400
Find the Right Water FilterFree tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.
ZIP Codes Served
Coverage: Service area ZIP codes sourced from EPA Community Water System Service Area Boundaries v3 (March 2026 release). These ZIPs reflect the actual deployment footprint recorded by MO or modeled from parcel and building-footprint data.
Data Sources
This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Washington Public Water System (MO6010838) on EPA.gov.
Frequently Asked Questions
Is Washington Public Water System water safe to drink?
The accepted 2026Q2 ECHO snapshot shows 1 current noncompliance record and zero current records classified as health-based. That classification is not a property-specific water test or safety guarantee.
How many people does Washington Public Water System serve?
Washington Public Water System serves approximately 14,068 people across 3 ZIP codes in Missouri.
Where does Washington Public Water System get its water?
The primary water source is groundwater.
Federal UCMR5 PFAS Monitoring: Tested Clean
This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). No PFAS compounds were detected.
Current MCL reflects the lowest state-enforceable limit (NYS 10 ppt for PFOA/PFOS, effective August 2020). The federal final MCL of 4 ppt for PFOA/PFOS (EPA April 2024 rule) is not enforceable until April 2029. Detections above 4 ppt but below 10 ppt are below current MCL but above the future federal limit.
Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) — per-system federal sampling, 2023–2025. EPA UCMR5 monitoring program →
How Water Systems Appear in Rankings
Water systems are evaluated by violation history, contaminant detections, and service population. Larger systems with more service connections appear in more rankings.
- #13 / 50 Highest Exposure Burden (Missouri)
Frequently Asked Questions
How to cite this page
ZipCheckup. (n.d.). Washington Public Water System (MO): 1 Health Violation. https://zipcheckup.com/water-system/mo6010838/
@misc{zipcheckup-water-system-mo6010838,
author = {{ZipCheckup}},
title = {{Washington Public Water System (MO): 1 Health Violation}},
year = {n.d.},
url = {https://zipcheckup.com/water-system/mo6010838/}
}
What You Can Do
Test your water
Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →
Check your specific ZIP code
Water quality can vary within a system. View nearest ZIP report →
Contact your utility
Washington Public Water System (EPA ID: MO6010838) - request the latest Consumer Confidence Report or ask about specific contaminants.