Willard Public Water System
EPA ID: MO5010860 · 8,400 people served · 8 ZIP codes
Past issues aside, Willard Public Water System cleared all 1 violation and is compliant today, supplying 8,400 residents.
Data: EPA SDWIS Last verified: 2026-04-02
Compliance Trajectory
Worsening · Risk tier: High · 95% chance of violation in next 12 months
Violations went from 2 (2024) to 2 (2025). The pattern suggests growing compliance challenges.
Service Area Map
Coverage area for Willard Public Water System Source: EPA SDWIS service area boundaries.
Service area boundary — Grade B
Service Area Demographics
The Willard Public Water System serves a community with a median household income of $62,368 and an estimated 133,326 residents across its service area. Approximately 52% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.
Environmental Justice Note: 35% of the population in this service area is classified as disadvantaged under EPA's EJScreen criteria. Communities with higher disadvantaged populations often face disproportionate environmental and health burdens, including aging water infrastructure and limited resources for remediation.
💧 Where Does Your Water Come From?
Willard Public Water System's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.
About 1% of homes in Greene County, Missouri rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.
Wastewater Proximity Note: This service area ranks in the 66th percentile nationally for proximity to wastewater discharge points.
Superfund Proximity Note: This service area ranks in the 68th percentile nationally for proximity to Superfund (NPL) sites. Groundwater sources near contaminated sites may face elevated risk from industrial chemicals.
Infrastructure Risk
Detected Contaminants
How Willard Public Water System compares to EPA limits
What This Means For You
Stage 1 DBP Rule at 1 mg/L exceeds the EPA maximum of mg/L.
PFAS Detected in Service Area
PFAS ("forever chemicals") have been detected in water serving this system's area. 8 detections recorded. 4 exceed federal EPA limits (4 ppt for PFOA/PFOS).
Comparable Water Systems
Similar-sized systems in Missouri
Estimated Remediation Costs
Average estimated costs across ZIP codes served by this system
Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.
System Overview
Willard Public Water System (EPA ID: MO5010860) is a community water system in Missouri that serves approximately 8,400 people from groundwater sources.
This system provides water to 8 ZIP codes across 7 communities.
Average Home Safety Score: B (83/100)
Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.
Violation History
Recent Violations
| Date | Contaminant | Type | Status |
|---|---|---|---|
| December 30, 2023 | Stage 1 DBP Rule | Monitoring | Resolved |
Contaminants Detected
The following contaminants have been flagged in EPA records for this water system:
| Contaminant | Category | Violations | Health-Based |
|---|---|---|---|
| Stage 1 DBP Rule | Treatment Failure | 1 | No |
Lead & Copper
EPA Lead and Copper Rule sampling data for ZIP codes served by this system:
| ZIP Code | Lead Level | Exceeds Limit | Sample Date |
|---|---|---|---|
| 65781 | 0.00392 mg/L | No | N/A |
Radon Risk in Service Area
Dominant radon zone for ZIP codes served by this system: Zone 2 (Moderate Risk)
The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.
Need help with your water quality?
Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400
Find the Right Water FilterFree tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.
ZIP Codes Served
Coverage: Service area ZIP codes sourced from EPA Community Water System Service Area Boundaries v3 (March 2026 release). These ZIPs reflect the actual deployment footprint recorded by MO or modeled from parcel and building-footprint data.
- 65604 — Ash Grove
- 65610 — Billings
- 65612 — Bois D Arc
- 65738 — Republic
- 65770 — Walnut Grove
- 65781 — Willard
- 65802 — Springfield
- 65803 — Springfield
Data Sources
This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Willard Public Water System (MO5010860) on EPA.gov.
Frequently Asked Questions
Is Willard Public Water System water safe to drink?
Willard Public Water System has only monitoring/reporting violations, which are procedural in nature. The system meets federal health-based standards.
How many people does Willard Public Water System serve?
Willard Public Water System serves approximately 8,400 people across 8 ZIP codes in Missouri.
Where does Willard Public Water System get its water?
The primary water source is groundwater.
Contact Your Water Utility
Public-record contact information for the water utility serving this system. Use these channels to request water quality reports, ask about service, or report issues directly.
Contact information from WILLARD PWS Consumer Confidence Report.
ZipCheckup is not affiliated with this water utility, does not act as its agent, and does not provide customer support for it. Contact details shown are public-record information from CCR filings. For service issues, contact the utility directly using the information above.
Water Source & Treatment
Where this water originates and how it's treated before reaching your tap.
Source: WILLARD PWS Consumer Confidence Report.
ZipCheckup is not affiliated with this water utility. Treatment and source data are sourced from the utility's published CCR filings.
The Department of Natural Resources conducted a source water assessment to determine the susceptibility of our water source to potential contaminants. Assessment maps and summary information sheets are available at https://drinkingwater.missouri.edu/.
Treatment regime
How this utility classifies its treatment process and what each reported treatment chemical does.
Watershed exposure sources reported
Land-use and natural conditions identified in the utility's source-water assessment as potential contamination sources upstream of treatment.
Treatment classification and chemical list sourced from WILLARD PWS Consumer Confidence Report.
Treatment intensity is a ZipCheckup-derived classification based on the chemicals and processes the utility reports. Chemicals and contamination sources are taken verbatim from the utility's CCR filing. Routine federal monitoring and contaminant testing shown elsewhere on this page determine whether the water meets safety standards, not the treatment classification.
Federal UCMR5 PFAS Monitoring: Tested Clean
This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). No PFAS compounds were detected.
Current MCL reflects the lowest state-enforceable limit (NYS 10 ppt for PFOA/PFOS, effective August 2020). The federal final MCL of 4 ppt for PFOA/PFOS (EPA April 2024 rule) is not enforceable until April 2029. Detections above 4 ppt but below 10 ppt are below current MCL but above the future federal limit.
Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) — per-system federal sampling, 2023–2025. EPA UCMR5 monitoring program →
A service line inventory was required to be prepared and can be requested from WILLARD PWS.
Lead Service Line Replacement Tracker
This water utility's lead service line (LSL) replacement program is tracked from public Consumer Confidence Report filings. Email signup notifies subscribers when the utility files an updated replacement plan or progress milestone.
WILLARD PWS
ZipCheckup is not affiliated with this water utility. LSL replacement-program data is sourced from public CCR filings published by the utility. Subscription notifications are based on automated parsing of subsequent CCR releases.
Learn more about Lead and Copper Rule replacement requirements →
Lead Service Line Inventory
Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:
This system reports zero confirmed lead service lines in its inventory. Unknown-material counts may still warrant verification.
Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.
Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026
ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.
Aesthetic water quality
These measurements describe the look, taste, and feel of the water this utility delivers. They are not contaminant violations — they sit alongside federal Secondary Maximum Contaminant Levels (SMCLs) which the EPA publishes as non-enforceable guidance.
Aesthetic measurements from WILLARD PWS Consumer Confidence Report.
Aesthetic measurements are reported by the utility from its annual sampling. EPA Secondary MCLs are advisory thresholds — values outside them indicate aesthetic concerns such as taste or appearance, not health violations. Federal contaminant testing is shown in the sections above.
Hard water detected in WILLARD PWS
Your utility reported water hardness of 167 ppm CaCO₃ (9.8 grains per gallon) in its most recent Consumer Confidence Report. This is in the moderately hard range and may cause scale buildup, reduced appliance lifespan, and dry skin or hair.
There are three common approaches to treating hard water: salt-based ion-exchange softeners (most effective, require salt refills), salt-free conditioners (lower maintenance, scale prevention only), and reverse osmosis at the kitchen sink (cooking and drinking water only). Aquasana, EcoWater, Pelican, and SpringWell are among the major US brands.
Paid Partner. ZipCheckup earns commission on Aquasana purchases. We do not test water or verify product effectiveness for specific hardness levels — manufacturer claims are theirs alone. Consult a certified water-quality professional for personalized advice.
Hardness data parsed from this utility's most recent Consumer Confidence Report. Severity bands per USGS hard water classification.
Notable events and violations
This section summarizes events the utility chose to disclose in its most recent Consumer Confidence Report, plus any federal compliance violations the utility recorded against itself. Both lists are utility-authored — ZipCheckup does not audit, judge, or reorder them.
Notable events from the utility's CCR
These bullet entries are the utility's own narration of operational, regulatory, or infrastructure events during the reporting period.
- Special Lead and Copper Notice: Lead can cause serious health problems, especially for pregnant women and young children. WILLARD PWS is responsible for providing high quality drinking water and removing water system owned and controlled lead pipes, but cannot control the variety of materials used in plumbing components in your home.
ZipCheckup note: items above reflect what the utility published in its most recent CCR. Federal violation records are also tracked separately by the EPA Safe Drinking Water Information System (SDWIS) — the SDWIS record is the authoritative federal source for any specific regulatory action.
Frequently Asked Questions
What You Can Do
Test your water
Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →
Check your specific ZIP code
Water quality can vary within a system. View nearest ZIP report →
Contact your utility
Willard Public Water System (EPA ID: MO5010860) — request the latest Consumer Confidence Report or ask about specific contaminants.