Health Violations Found ME 3 HEALTH VIOLATIONS

Monson Utilities District

EPA ID: ME0091030 · 298 people served · 3 ZIP codes

Monson Utilities District's current EPA file includes 5 unresolved violations — every outstanding finding is documented in federal records for this utility, which supplies water to approximately 298 residents across its service territory.

Data: EPA SDWIS Last verified: 2026-04-02

D · 48
Avg Safety Score
298
People Served
3
ZIP Codes Served
12
Violations (5yr)
Groundwater
Water Source
0.0015 mg/L
Max Lead Level
Zone 1
Radon Risk · High
3
Contaminants Flagged
$182K
Median Home Value in Service Area

Service Area Map

Coverage area for Monson Utilities District Source: EPA SDWIS service area boundaries.

Service area boundary — Grade D

Service Area Demographics

$53,250
Median Household Income
1,505
Service Area Population
88%
Disadvantaged Population
70th
Poverty Percentile
100th
Energy Burden Percentile
61%
Pre-1986 Housing

The Monson Utilities District serves a community with a median household income of $53,250 and an estimated 1,505 residents across its service area. Approximately 61% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

Environmental Justice Note: 88% of the population in this service area is classified as disadvantaged under EPA's EJScreen criteria. Communities with higher disadvantaged populations often face disproportionate environmental and health burdens, including aging water infrastructure and limited resources for remediation.

💧 Where Does Your Water Come From?

Groundwater

Monson Utilities District's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Elevated Risk
Source Contamination Risk
0th
Wastewater Discharge Proximity
30th
Superfund Site Proximity

About 2% of homes in Piscataquis County, Maine rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Infrastructure Risk

48 yr
Avg Pipe Age
Copper
Pipe Material
22 yr
Est. Remaining Life
Moderate Wear
Decay Status
Installed 69% of expected lifespan used End of life

Detected Contaminants

How Monson Utilities District compares to EPA limits

What This Means For You

Stage 1 DBP Rule at 8 mg/L exceeds the EPA maximum of mg/L.

Surface Water Treatment Rule at 3 mg/L exceeds the EPA maximum of mg/L.

Lead and Copper Rule at 1 mg/L exceeds the EPA maximum of mg/L.

Comparable Water Systems

Similar-sized systems in Maine

C 2 violations
Highpine Village
300 people
0 violations
B 1 violation
F 13 violations
D 0 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Radon Mitigation Flood Insurance Water Filtration
Radon Mitigation $1,200
Flood Insurance $400
Water Filtration $200
Total Estimated Cost $1,800

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $1,000

Annual per household (CDC est.)

Estimated Cumulative Cost Per Household

5 years
$5,000
10 years
$10,000
20 years
$20,000

Compare: Estimated remediation cost is $1,800 (one-time) vs. $10,000 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

MONSON UTILITIES DISTRICT (EPA ID: ME0091030) is a community water system in Maine that serves approximately 298 people from groundwater sources.

This system provides water to 3 ZIP codes across 3 communities.

Average Home Safety Score: D (48/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

3 health-based violations recorded in the past 5 years. 5 remain unresolved.

Recent Violations

Date Contaminant Type Status
July 1, 2025 Stage 1 DBP Rule Monitoring Unresolved
November 2, 2024 Stage 1 DBP Rule Health-based Unresolved
September 29, 2024 Stage 1 DBP Rule Monitoring Resolved
April 12, 2024 Stage 1 DBP Rule Health-based Unresolved
March 7, 2024 Lead and Copper Rule Monitoring Unresolved
January 1, 2024 Stage 1 DBP Rule Monitoring Resolved
January 1, 2024 Stage 1 DBP Rule Health-based Unresolved
December 30, 2023 Stage 1 DBP Rule Monitoring Resolved
July 1, 2023 Surface Water Treatment Rule Monitoring Resolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Stage 1 DBP Rule Treatment Failure 8 Yes
Surface Water Treatment Rule Treatment Failure 3 No
Lead and Copper Rule Treatment Failure 1 No

Lead & Copper

EPA Lead and Copper Rule sampling data for ZIP codes served by this system:

ZIP Code Lead Level Exceeds Limit Sample Date
04464 0.0015 mg/L No N/A

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 1 (High Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Monson Utilities District (ME0091030) on EPA.gov.

Frequently Asked Questions

Is Monson Utilities District water safe to drink?

Monson Utilities District has recorded 3 health-based violations in the past 5 years. While the system is required to treat water to meet federal standards, you may want to consider additional precautions such as a certified water filter.

How many people does Monson Utilities District serve?

Monson Utilities District serves approximately 298 people across 3 ZIP codes in Maine.

Where does Monson Utilities District get its water?

The primary water source is groundwater.

Lead Service Line Inventory

Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:

0
Confirmed Lead
0
Galvanized — Replacement Required
0
Unknown Material
163
Confirmed Non-Lead

This system reports zero confirmed lead service lines in its inventory. Unknown-material counts may still warrant verification.

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Reported all required service line types
Latest tap sample on 2025-07-01 did not exceed the federal lead action level.
Population served: 298
Reported to Maine

Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

Frequently Asked Questions

Is water from Monson Utilities District safe to drink?
Monson Utilities District has a D safety grade based on 12 recorded violations. Some contaminants may exceed EPA limits — independent testing is recommended.
What contaminants are in Monson Utilities District's water?
Detected contaminants include Stage 1 DBP Rule, Surface Water Treatment Rule, Lead and Copper Rule. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 3 contaminants above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does Monson Utilities District serve?
Monson Utilities District serves approximately 298 people with drinking water across 3 ZIP codes.
What is Monson Utilities District's water source?
Monson Utilities District draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
Is there lead in Monson Utilities District's water?
The maximum detected lead level is 0.0015 mg/L. This is within EPA action level guidelines.
What is the demographic profile of Monson Utilities District's service area?
The Monson Utilities District service area has a median household income of $53,250. EPA EJScreen data classifies 88% of the population as disadvantaged, which may indicate greater vulnerability to environmental health risks.
Where does Monson Utilities District get its water?
Monson Utilities District's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table. Based on violation history and environmental factors, the source contamination risk is currently elevated.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

Monson Utilities District (EPA ID: ME0091030) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Maine Monson Utilities District

Get safety alerts for Monson Utilities District, Maine

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found — check filter options Free tool — no phone call required.