Town of Princess Anne
EPA ID: MD0190002 · 3,300 people served · 2 ZIP codes
ZipCheckup's reading of EPA SDWIS for Town of Princess Anne (MD0190002): no EPA violations recorded in the last five years. Federal monitoring spanning five full years has produced zero violations at Town of Princess Anne - a clean record across every reporting cycle for a utility serving approximately 3,300 residents.
Data: EPA SDWIS
Service Area Map
Coverage area for Town of Princess Anne Source: EPA SDWIS service area boundaries.
Service area boundary
Service Area Demographics
The Town of Princess Anne serves a community with a median household income of $51,605 and an estimated 13,764 residents across its service area. Approximately 43% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.
Environmental Justice Note: 49% of the population in this service area is classified as disadvantaged under EPA's EJScreen criteria. Communities with higher disadvantaged populations often face disproportionate environmental and health burdens, including aging water infrastructure and limited resources for remediation.
💧 Where Does Your Water Come From?
Town of Princess Anne's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.
Infrastructure Risk
Comparable Water Systems
Similar-sized systems in Maryland
Estimated Remediation Costs
Average estimated costs across ZIP codes served by this system
Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.
System Overview
Town of Princess Anne (EPA ID: MD0190002) is a community water system in Maryland that serves approximately 3,300 people from groundwater sources.
This system provides water to 2 ZIP codes across 2 communities.
Violation History
Lead & Copper
EPA Lead and Copper Rule evidence attributed directly to this water system:
| Lead Level | Exceeds Action Level | Sample Date |
|---|---|---|
| 0.0031 mg/L | No | N/A |
No copper action-level exceedance record appears for this PWSID in the accepted LCR snapshot. This does not establish a clean copper measurement.
Radon Risk in Service Area
Dominant radon zone for ZIP codes served by this system: Zone 2 (Moderate Risk)
The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.
Need help with your water quality?
Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400
Find the Right Water FilterFree tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.
ZIP Codes Served
Coverage: Service area ZIP codes sourced from EPA Community Water System Service Area Boundaries v3 (March 2026 release). These ZIPs reflect the actual deployment footprint recorded by MD or modeled from parcel and building-footprint data.
Data Sources
This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Town of Princess Anne (MD0190002) on EPA.gov.
Frequently Asked Questions
Is Town of Princess Anne water safe to drink?
The accepted 2026Q2 ECHO snapshot contains zero violation records for Town of Princess Anne in the inclusive 2021-2026 record-year window. This is a compliance-record finding, not a guarantee about water at a specific tap.
How many people does Town of Princess Anne serve?
Town of Princess Anne serves approximately 3,300 people across 2 ZIP codes in Maryland.
Where does Town of Princess Anne get its water?
The primary water source is groundwater.
Federal UCMR5 PFAS Monitoring: Tested Clean
This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). No PFAS compounds were detected.
Current MCL reflects the lowest state-enforceable limit (NYS 10 ppt for PFOA/PFOS, effective August 2020). The federal final MCL of 4 ppt for PFOA/PFOS (EPA April 2024 rule) is not enforceable until April 2029. Detections above 4 ppt but below 10 ppt are below current MCL but above the future federal limit.
Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) — per-system federal sampling, 2023–2025. EPA UCMR5 monitoring program →
How Water Systems Appear in Rankings
Water systems are evaluated by violation history, contaminant detections, and service population. Larger systems with more service connections appear in more rankings.
Frequently Asked Questions
How to cite this page
ZipCheckup. (n.d.). Town of Princess Anne Water Quality Report, MD. https://zipcheckup.com/water-system/md0190002/
@misc{zipcheckup-water-system-md0190002,
author = {{ZipCheckup}},
title = {{Town of Princess Anne Water Quality Report, MD}},
year = {n.d.},
url = {https://zipcheckup.com/water-system/md0190002/}
}