Water System Report MA

Williamstown Water Department

EPA ID: MA1341000 · 7,326 people served · 1 ZIP code

Five clean years on EPA record — Williamstown Water Department, 7,326 residents served.

Data: EPA SDWIS Last verified: 2026-04-02

B · 78
Avg Safety Score
7,326
People Served
1
ZIP Code Served
0
Violations (5yr)
Groundwater
Water Source
0.00062 mg/L
Max Lead Level
Zone 2
Radon Risk · Moderate
0
Contaminants Flagged
$438K
Median Home Value in Service Area

Service Area Map

Coverage area for Williamstown Water Department Source: EPA SDWIS service area boundaries.

Service area boundary — Grade B

Service Area Demographics

$98,750
Median Household Income
7,985
Service Area Population
23%
Disadvantaged Population
40th
Poverty Percentile
80th
Energy Burden Percentile
81%
Pre-1986 Housing

The Williamstown Water Department serves a community with a median household income of $98,750 and an estimated 7,985 residents across its service area. Approximately 81% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

💧 Where Does Your Water Come From?

Groundwater

Williamstown Water Department's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Low Risk
Source Contamination Risk
40th
Wastewater Discharge Proximity
70th
Superfund Site Proximity

About 1% of homes in Berkshire County, Massachusetts rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Superfund Proximity Note: This service area ranks in the 70th percentile nationally for proximity to Superfund (NPL) sites. Groundwater sources near contaminated sites may face elevated risk from industrial chemicals.

Infrastructure Risk

72 yr
Avg Pipe Age
Galvanized Steel or Copper
Pipe Material
0 yr
Est. Remaining Life
Moderate Wear
Decay Status
Installed 100% of expected lifespan used End of life

Comparable Water Systems

Similar-sized systems in Massachusetts

D 9 violations
C 0 violations
C 3 violations
C 1 violation
D 1 violation

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Flood Insurance Radon Mitigation
Flood Insurance $1,200
Radon Mitigation $400
Total Estimated Cost $1,600

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

System Overview

Williamstown Water Department (EPA ID: MA1341000) is a community water system in Massachusetts that serves approximately 7,326 people from groundwater sources.

This system serves ZIP code 01267 in Williamstown.

Average Home Safety Score: B (78/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

No violations recorded — This water system has no recorded EPA violations in the past 5 years.

Lead & Copper

EPA Lead and Copper Rule sampling data for ZIP codes served by this system:

ZIP Code Lead Level Exceeds Limit Sample Date
01267 0.00062 mg/L No N/A

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 2 (Moderate Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Coverage: Service area ZIP codes sourced from EPA Community Water System Service Area Boundaries v3 (March 2026 release). These ZIPs reflect the actual deployment footprint recorded by MA or modeled from parcel and building-footprint data.

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Williamstown Water Department (MA1341000) on EPA.gov.

Frequently Asked Questions

Is Williamstown Water Department water safe to drink?

Based on EPA records, Williamstown Water Department has no recorded violations in the past 5 years — a positive indicator of water quality management.

How many people does Williamstown Water Department serve?

Williamstown Water Department serves approximately 7,326 people across 1 ZIP code in Massachusetts.

Where does Williamstown Water Department get its water?

The primary water source is groundwater.

Contact Your Water Utility

Public-record contact information for the water utility serving this system. Use these channels to request water quality reports, ask about service, or report issues directly.

Phone
(413) 458-3383
ZipCheckup is not affiliated with this water utility, does not act as its agent, and does not provide customer support for it. Contact details shown are public-record information from CCR filings. For service issues, contact the utility directly using the information above.
Address
675 Simonds Rd, Williamstown, MA 01267

Contact information from Williamstown Water Department Consumer Confidence Report.

ZipCheckup is not affiliated with this water utility, does not act as its agent, and does not provide customer support for it. Contact details shown are public-record information from CCR filings. For service issues, contact the utility directly using the information above.

Water Source & Treatment

Where this water originates and how it's treated before reaching your tap.

Source
Groundwater
Drawn from underground aquifers via wells.
Disinfectant used
Chlorine
Treatment chemicals reported
Sodium Hypochlorite (NaOCL)Poly-orthophosphate (PO4)3AQUAMAG

Source: Williamstown Water Department Consumer Confidence Report.

ZipCheckup is not affiliated with this water utility. Treatment and source data are sourced from the utility's published CCR filings.

Source water assessment from Williamstown Water Department Consumer Confidence Report:
Significant sources of potential contamination in Williamstown’s Zone II recharge are inclusive of the following but not limited to: Non-conforming Zone I, Residential Lane Uses, Transportation Corridors, Hazardous Materials Storage and Use, Confirmed Oil or hazardous material contamination sites, Comprehensive wellhead protection planning with the City of North Adams, Agricultural Activities, Right of way owned by other Natural gas, National Grid (electric high-tension lines), HQWD (wastewater interceptor mains), and Railroad lines.

Treatment regime

How this utility classifies its treatment process and what each reported treatment chemical does.

Treatment classification
Standard
Disinfection plus one or more treatment additives — typically corrosion control, pH adjustment, or fluoridation. Standard regime for utilities serving treated municipal water.

Treatment chemicals and what each one does

Chemical names are reported verbatim by the utility. Purpose categories are ZipCheckup annotations based on standard drinking-water treatment practice.

Other reported chemicals
Reported by the utility but not in our annotation dictionary.
Sodium Hypochlorite (NaOCL)Poly-orthophosphate (PO4)3AQUAMAG

Watershed exposure sources reported

Land-use and natural conditions identified in the utility's source-water assessment as potential contamination sources upstream of treatment.

AgricultureIndustrial activityResidential land useTransportationHazardous materialsWastewaterOil and gasRailroad

Treatment classification and chemical list sourced from Williamstown Water Department Consumer Confidence Report.

Treatment intensity is a ZipCheckup-derived classification based on the chemicals and processes the utility reports. Chemicals and contamination sources are taken verbatim from the utility's CCR filing. Routine federal monitoring and contaminant testing shown elsewhere on this page determine whether the water meets safety standards, not the treatment classification.

Federal UCMR5 PFAS Monitoring: Tested Clean

This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). No PFAS compounds were detected.

Samples collected
174

Current MCL reflects the lowest state-enforceable limit (NYS 10 ppt for PFOA/PFOS, effective August 2020). The federal final MCL of 4 ppt for PFOA/PFOS (EPA April 2024 rule) is not enforceable until April 2029. Detections above 4 ppt but below 10 ppt are below current MCL but above the future federal limit.

Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) — per-system federal sampling, 2023–2025. EPA UCMR5 monitoring program →

Understand PFAS health context and filtration →

PFAS Substances Detected in This System

This water system's Consumer Confidence Report disclosed the following PFAS compounds. Levels are from the utility's most recent reporting cycle.

Substance Detected level EPA limit Status
PFOA
Perfluorooctanoic acid
EPA-regulated (2024 NPDWR)
Not disclosed 4 ppt
PFOS
Perfluorooctanesulfonic acid
EPA-regulated (2024 NPDWR)
Not disclosed 4 ppt
PFHxS
Perfluorohexanesulfonic acid
EPA-regulated (2024 NPDWR)
Not disclosed 10 ppt
PFNA
Perfluorononanoic acid
EPA-regulated (2024 NPDWR)
Not disclosed 10 ppt
GenX
Not yet EPA-regulated
Not disclosed 10 ppt

In April 2024, EPA finalized the first National Primary Drinking Water Regulation for six PFAS. Public water systems have until 2029 to comply. EPA — PFAS regulation overview →

Source: Consumer Confidence Report disclosed by Williamstown Water Department.

ZipCheckup is not affiliated with this water utility. PFAS detection data is sourced from public Consumer Confidence Reports filed by the utility itself.

Learn more about PFAS health effects and filtration →

Lead Service Line Inventory

Utility-reported lead service line presence and tap-sample lead level under federal LCRI requirements:

None reported
Lead Service Lines Reported
Non-detect
Tap Sample Lead Level

Below federal action level (0.015 mg/L)

MassDEP reports utility-level presence flag and tap-sampling without per-line breakdown. Customers should inquire with the utility about service line material at a specific address.

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Did not report any required service line types
Latest tap sample on 2019-01-01 did not exceed the federal lead action level.
Population served: 7,326
Reported to Massachusetts

Source: MassDEP LCRR Service Line Inventory · Submitted 2024

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

Notable events and violations

This section summarizes events the utility chose to disclose in its most recent Consumer Confidence Report, plus any federal compliance violations the utility recorded against itself. Both lists are utility-authored — ZipCheckup does not audit, judge, or reorder them.

Notable events from the utility's CCR

These bullet entries are the utility's own narration of operational, regulatory, or infrastructure events during the reporting period.

Notable events from Williamstown Water Department Consumer Confidence Report:
  • Repairs to 7 major water main breaks in 2023.
  • Well #2 was temporarily removed from production for inspection and pump replacement, expected to be back online in summer 2024.

ZipCheckup note: items above reflect what the utility published in its most recent CCR. Federal violation records are also tracked separately by the EPA Safe Drinking Water Information System (SDWIS) — the SDWIS record is the authoritative federal source for any specific regulatory action.

Frequently Asked Questions

Is water from Williamstown Water Department safe to drink?
Williamstown Water Department earns a B safety grade with 0 violations in the past 5 years. Tap water meets EPA standards for most contaminants.
Should I use a water filter?
Williamstown Water Department meets EPA standards, but a water filter can reduce trace contaminants below detectable levels for added peace of mind.
How many people does Williamstown Water Department serve?
Williamstown Water Department serves approximately 7,326 people with drinking water across 1 ZIP code.
What is Williamstown Water Department's water source?
Williamstown Water Department draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
Is there lead in Williamstown Water Department's water?
The maximum detected lead level is 0.00062 mg/L. This is within EPA action level guidelines.
What is the demographic profile of Williamstown Water Department's service area?
The Williamstown Water Department service area has a median household income of $98,750. Demographic data is sourced from the U.S. Census Bureau and EPA EJScreen.
Where does Williamstown Water Department get its water?
Williamstown Water Department's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.
Home Water Systems Massachusetts Williamstown Water Department

Get safety alerts for Williamstown Water Department, Massachusetts

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Check your water filter options Free tool — no phone call required.