Southeast Waterworks District 2
EPA ID: LA1113031 · 6,810 people served · 3 ZIP codes
Water monitoring history at Southeast Waterworks District 2 shows a clean slate — EPA tracking over the past five years turned up no violations, and 6,810 residents continue to receive fully compliant service.
Data: EPA SDWIS Last verified: 2026-04-02
Service Area Map
Coverage area for Southeast Waterworks District 2 Source: EPA SDWIS service area boundaries.
Service area boundary
Service Area Demographics
The Southeast Waterworks District 2 serves a community with a median household income of $58,312 and an estimated 30,702 residents across its service area. Approximately 53% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.
Environmental Justice Note: 33% of the population in this service area is classified as disadvantaged under EPA's EJScreen criteria. Communities with higher disadvantaged populations often face disproportionate environmental and health burdens, including aging water infrastructure and limited resources for remediation.
💧 Where Does Your Water Come From?
Southeast Waterworks District 2's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.
About 1% of homes in Vermilion Parish, Louisiana rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.
Infrastructure Risk
PFAS Detected in Service Area
PFAS ("forever chemicals") have been detected in water serving this system's area. 2 detections recorded.
Comparable Water Systems
Similar-sized systems in Louisiana
Estimated Remediation Costs
Average estimated costs across ZIP codes served by this system
Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.
System Overview
Southeast Waterworks District 2 (EPA ID: LA1113031) is a community water system in Louisiana that serves approximately 6,810 people from groundwater sources.
This system provides water to 3 ZIP codes across 2 communities.
Violation History
Lead & Copper
No Lead and Copper Rule sampling data available for this water system.
Need help with your water quality?
Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400
Find the Right Water FilterFree tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.
ZIP Codes Served
Coverage: 2 ZIP codes confirmed via EPA Community Water System Service Area Boundaries v3 plus 1 additional ZIP inferred from SDWIS registry data. The EPA-confirmed set is the most reliable; SDWIS-inferred entries may be narrower than the real deployment area.
Data Sources
This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Southeast Waterworks District 2 (LA1113031) on EPA.gov.
Frequently Asked Questions
Is Southeast Waterworks District 2 water safe to drink?
Based on EPA records, Southeast Waterworks District 2 has no recorded violations in the past 5 years — a positive indicator of water quality management.
How many people does Southeast Waterworks District 2 serve?
Southeast Waterworks District 2 serves approximately 6,810 people across 3 ZIP codes in Louisiana.
Where does Southeast Waterworks District 2 get its water?
The primary water source is groundwater.
Water Source & Treatment
Where this water originates and how it's treated before reaching your tap.
Source: Southeast Waterworks District 2 Consumer Confidence Report.
ZipCheckup is not affiliated with this water utility. Treatment and source data are sourced from the utility's published CCR filings.
Treatment regime
How this utility classifies its treatment process and what each reported treatment chemical does.
Treatment chemicals and what each one does
Chemical names are reported verbatim by the utility. Purpose categories are ZipCheckup annotations based on standard drinking-water treatment practice.
Treatment classification and chemical list sourced from Southeast Waterworks District 2 Consumer Confidence Report.
Treatment intensity is a ZipCheckup-derived classification based on the chemicals and processes the utility reports. Chemicals and contamination sources are taken verbatim from the utility's CCR filing. Routine federal monitoring and contaminant testing shown elsewhere on this page determine whether the water meets safety standards, not the treatment classification.
Federal UCMR5 PFAS Monitoring: Tested Clean
This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). No PFAS compounds were detected.
Current MCL reflects the lowest state-enforceable limit (NYS 10 ppt for PFOA/PFOS, effective August 2020). The federal final MCL of 4 ppt for PFOA/PFOS (EPA April 2024 rule) is not enforceable until April 2029. Detections above 4 ppt but below 10 ppt are below current MCL but above the future federal limit.
Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) — per-system federal sampling, 2023–2025. EPA UCMR5 monitoring program →
Lead Service Line Inventory
Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:
This system reports zero confirmed lead service lines in its inventory. Unknown-material counts may still warrant verification.
Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.
Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026
ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.
Aesthetic water quality
These measurements describe the look, taste, and feel of the water this utility delivers. They are not contaminant violations — they sit alongside federal Secondary Maximum Contaminant Levels (SMCLs) which the EPA publishes as non-enforceable guidance.
Aesthetic measurements from Southeast Waterworks District 2 Consumer Confidence Report.
Aesthetic measurements are reported by the utility from its annual sampling. EPA Secondary MCLs are advisory thresholds — values outside them indicate aesthetic concerns such as taste or appearance, not health violations. Federal contaminant testing is shown in the sections above.
Hard water detected in Southeast Waterworks District 2
Your utility reported water hardness of 128.4 ppm CaCO₃ (7.5 grains per gallon) in its most recent Consumer Confidence Report. This is in the moderately hard range and may cause scale buildup, reduced appliance lifespan, and dry skin or hair.
There are three common approaches to treating hard water: salt-based ion-exchange softeners (most effective, require salt refills), salt-free conditioners (lower maintenance, scale prevention only), and reverse osmosis at the kitchen sink (cooking and drinking water only). Aquasana, EcoWater, Pelican, and SpringWell are among the major US brands.
Paid Partner. ZipCheckup earns commission on Aquasana purchases. We do not test water or verify product effectiveness for specific hardness levels — manufacturer claims are theirs alone. Consult a certified water-quality professional for personalized advice.
Hardness data parsed from this utility's most recent Consumer Confidence Report. Severity bands per USGS hard water classification.
Notable events and violations
This section summarizes events the utility chose to disclose in its most recent Consumer Confidence Report, plus any federal compliance violations the utility recorded against itself. Both lists are utility-authored — ZipCheckup does not audit, judge, or reorder them.
Notable events from the utility's CCR
These bullet entries are the utility's own narration of operational, regulatory, or infrastructure events during the reporting period.
- Coliform health effects: coliforms were found in more samples than allowed, warning of potential problems
- TTHM health effects: some people who drink water containing trihalomethanes in excess of the MCL over many years may experience problems with their liver, kidneys, or central nervous systems, and may have an increased risk of getting cancer.
ZipCheckup note: items above reflect what the utility published in its most recent CCR. Federal violation records are also tracked separately by the EPA Safe Drinking Water Information System (SDWIS) — the SDWIS record is the authoritative federal source for any specific regulatory action.