Health Violations Found IN 1 HEALTH VIOLATION

Dana Water Works

EPA ID: IN5283005 · 660 people served · 1 ZIP code

Federal data shows 2 unresolved violations at Dana Water Works — roughly 660 residents in the service area.

Data: EPA SDWIS Last verified: 2026-04-02

D · 50
Avg Safety Score
660
People Served
1
ZIP Code Served
5
Violations (5yr)
Groundwater
Water Source
Zone 1
Radon Risk · High
3
Contaminants Flagged
$57K
Median Home Value in Service Area

Service Area Map

Coverage area for Dana Water Works Source: EPA SDWIS service area boundaries.

Service area boundary — Grade D

Service Area Demographics

$54,840
Median Household Income
869
Service Area Population
20%
Disadvantaged Population
60th
Poverty Percentile
80th
Energy Burden Percentile
90%
Pre-1986 Housing

The Dana Water Works serves a community with a median household income of $54,840 and an estimated 869 residents across its service area. Approximately 90% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

💧 Where Does Your Water Come From?

Groundwater

Dana Water Works's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Elevated Risk
Source Contamination Risk
80th
Wastewater Discharge Proximity
40th
Superfund Site Proximity

About 1% of homes in Vermillion County, Indiana rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Wastewater Proximity Note: This service area ranks in the 80th percentile nationally for proximity to wastewater discharge points.

Infrastructure Risk

125 yr
Avg Pipe Age
Galvanized Steel or Lead
Pipe Material
0 yr
Est. Remaining Life
Moderate Wear
Decay Status
Installed 100% of expected lifespan used End of life

Detected Contaminants

How Dana Water Works compares to EPA limits

What This Means For You

Stage 2 DBP Rule at 2 mg/L exceeds the EPA maximum of mg/L.

Surface Water Treatment Rule at 2 mg/L exceeds the EPA maximum of mg/L.

Consumer Confidence Report Rule at 1 mg/L exceeds the EPA maximum of mg/L.

Comparable Water Systems

Similar-sized systems in Indiana

C 6 violations
Paragon Water Works
663 people
C 2 violations
D 0 violations
0 violations
0 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Radon Mitigation Water Filtration
Radon Mitigation $1,200
Water Filtration $300
Total Estimated Cost $1,500

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $1,000

Annual per household (CDC est.)

Estimated Cumulative Cost Per Household

5 years
$5,000
10 years
$10,000
20 years
$20,000

Compare: Estimated remediation cost is $1,500 (one-time) vs. $10,000 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

Dana Water Works (EPA ID: IN5283005) is a community water system in Indiana that serves approximately 660 people from groundwater sources.

This system serves ZIP code 47847 in Dana.

Average Home Safety Score: D (50/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

1 health-based violation recorded in the past 5 years. 2 remain unresolved.

Recent Violations

Date Contaminant Type Status
May 1, 2025 Consumer Confidence Report Rule Monitoring Resolved
October 17, 2024 Stage 2 DBP Rule Health-based Unresolved
October 17, 2024 Stage 2 DBP Rule Monitoring Unresolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Stage 2 DBP Rule Treatment Failure 2 Yes
Surface Water Treatment Rule Treatment Failure 2 No
Consumer Confidence Report Rule Reporting Failure 1 No

Lead & Copper

No Lead and Copper Rule sampling data available for this water system.

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 1 (High Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Dana Water Works (IN5283005) on EPA.gov.

Frequently Asked Questions

Is Dana Water Works water safe to drink?

Dana Water Works has recorded 1 health-based violation in the past 5 years. While the system is required to treat water to meet federal standards, you may want to consider additional precautions such as a certified water filter.

How many people does Dana Water Works serve?

Dana Water Works serves approximately 660 people across 1 ZIP code in Indiana.

Where does Dana Water Works get its water?

The primary water source is groundwater.

Frequently Asked Questions

Is water from Dana Water Works safe to drink?
Dana Water Works has a D safety grade based on 5 recorded violations. Some contaminants may exceed EPA limits — independent testing is recommended.
What contaminants are in Dana Water Works's water?
Detected contaminants include Stage 2 DBP Rule, Surface Water Treatment Rule, Consumer Confidence Report Rule. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 3 contaminants above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does Dana Water Works serve?
Dana Water Works serves approximately 660 people with drinking water across 1 ZIP code.
What is Dana Water Works's water source?
Dana Water Works draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
What is the demographic profile of Dana Water Works's service area?
The Dana Water Works service area has a median household income of $54,840. Demographic data is sourced from the U.S. Census Bureau and EPA EJScreen.
Where does Dana Water Works get its water?
Dana Water Works's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table. Based on violation history and environmental factors, the source contamination risk is currently elevated.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

Dana Water Works (EPA ID: IN5283005) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Indiana Dana Water Works

Get safety alerts for Dana Water Works, Indiana

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found — check filter options Free tool — no phone call required.