Monitoring Violations IA

Irwin Municipal Supply

EPA ID: IA8340099 · 313 people served · 2 ZIP codes

The EPA enforcement database lists 1 active violation for Irwin Municipal Supply — a provider that delivers drinking water to approximately 313 people and has not yet formally resolved those findings.

Data: EPA SDWIS Last verified: 2026-04-02

C · 62
Avg Safety Score
313
People Served
2
ZIP Codes Served
5
Violations (5yr)
Groundwater
Water Source
0.002 mg/L
Max Lead Level
Zone 1
Radon Risk · High
1
Contaminants Flagged
$169K
Median Home Value in Service Area

Service Area Map

Coverage area for Irwin Municipal Supply Source: EPA SDWIS service area boundaries.

Service area boundary — Grade C

Service Area Demographics

$88,197
Median Household Income
569
Service Area Population
0%
Disadvantaged Population
50th
Poverty Percentile
60th
Energy Burden Percentile
93%
Pre-1986 Housing

The Irwin Municipal Supply serves a community with a median household income of $88,197 and an estimated 569 residents across its service area. Approximately 93% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

💧 Where Does Your Water Come From?

Groundwater

Irwin Municipal Supply's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Moderate Risk
Source Contamination Risk
10th
Wastewater Discharge Proximity
20th
Superfund Site Proximity

About 1% of homes in Shelby County, Iowa rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Infrastructure Risk

68 yr
Avg Pipe Age
Galvanized Steel or Copper
Pipe Material
0 yr
Est. Remaining Life
Moderate Wear
Decay Status
Installed 100% of expected lifespan used End of life

Detected Contaminants

How Irwin Municipal Supply compares to EPA limits

What This Means For You

Consumer Confidence Report Rule at 5 mg/L exceeds the EPA maximum of mg/L.

Comparable Water Systems

Similar-sized systems in Iowa

C 1 violation
0 violations
Wheel Estates Mhc
315 people
0 violations
0 violations
0 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Radon Mitigation
Radon Mitigation $1,200
Total Estimated Cost $1,200

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $1,000

Annual per household (CDC est.)

Estimated Cumulative Cost Per Household

5 years
$5,000
10 years
$10,000
20 years
$20,000

Compare: Estimated remediation cost is $1,200 (one-time) vs. $10,000 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

Irwin Municipal Supply (EPA ID: IA8340099) is a community water system in Iowa that serves approximately 313 people from groundwater sources.

This system provides water to 2 ZIP codes across 2 communities.

Average Home Safety Score: C (62/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

5 monitoring/reporting violations recorded. These are procedural violations (missed tests or late reports), not necessarily water safety issues.

Recent Violations

Date Contaminant Type Status
May 1, 2025 Consumer Confidence Report Rule Monitoring Resolved
December 1, 2024 Consumer Confidence Report Rule Monitoring Resolved
October 1, 2024 Consumer Confidence Report Rule Monitoring Resolved
December 1, 2023 Consumer Confidence Report Rule Monitoring Unresolved

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Consumer Confidence Report Rule Reporting Failure 5 No

Lead & Copper

EPA Lead and Copper Rule sampling data for ZIP codes served by this system:

ZIP Code Lead Level Exceeds Limit Sample Date
51446 0.002 mg/L No N/A

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 1 (High Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Irwin Municipal Supply (IA8340099) on EPA.gov.

Frequently Asked Questions

Is Irwin Municipal Supply water safe to drink?

Irwin Municipal Supply has only monitoring/reporting violations, which are procedural in nature. The system meets federal health-based standards.

How many people does Irwin Municipal Supply serve?

Irwin Municipal Supply serves approximately 313 people across 2 ZIP codes in Iowa.

Where does Irwin Municipal Supply get its water?

The primary water source is groundwater.

Lead Service Line Inventory

Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:

0
Confirmed Lead
21
Galvanized — Replacement Required
7
Unknown Material
174
Confirmed Non-Lead

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Reported all required service line types
Latest tap sample on 2022-01-01 did not exceed the federal lead action level.
Population served: 313
Reported to Iowa

Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

Frequently Asked Questions

Is water from Irwin Municipal Supply safe to drink?
Irwin Municipal Supply has a C safety grade based on 5 recorded violations. Some contaminants may exceed EPA limits — independent testing is recommended.
What contaminants are in Irwin Municipal Supply's water?
Detected contaminants include Consumer Confidence Report Rule. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 1 contaminant above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does Irwin Municipal Supply serve?
Irwin Municipal Supply serves approximately 313 people with drinking water across 2 ZIP codes.
What is Irwin Municipal Supply's water source?
Irwin Municipal Supply draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
Is there lead in Irwin Municipal Supply's water?
The maximum detected lead level is 0.002 mg/L. This is within EPA action level guidelines.
What is the demographic profile of Irwin Municipal Supply's service area?
The Irwin Municipal Supply service area has a median household income of $88,197. Demographic data is sourced from the U.S. Census Bureau and EPA EJScreen.
Where does Irwin Municipal Supply get its water?
Irwin Municipal Supply's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table. Based on available data, the source contamination risk is moderate.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

Irwin Municipal Supply (EPA ID: IA8340099) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Iowa Irwin Municipal Supply

Get safety alerts for Irwin Municipal Supply, Iowa

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found — check filter options Free tool — no phone call required.