Monitoring Violations IA

Evansdale Water Works

EPA ID: IA0723027 · 4,561 people served · 4 ZIP codes

Even though Evansdale Water Works accumulated 1 violation over five years, all have been formally resolved — the provider currently meets EPA standards for 4,561 people.

Data: EPA SDWIS Last verified: 2026-04-02

D · 53
Avg Safety Score
4,561
People Served
4
ZIP Codes Served
1
Violations (5yr)
Groundwater
Water Source
0.0012 mg/L
Max Lead Level
Zone 1
Radon Risk · High
1
Contaminants Flagged
$177K
Median Home Value in Service Area

Service Area Map

Coverage area for Evansdale Water Works Source: EPA SDWIS service area boundaries.

Service area boundary — Grade D

Service Area Demographics

$62,835
Median Household Income
38,140
Service Area Population
34%
Disadvantaged Population
40th
Poverty Percentile
40th
Energy Burden Percentile
68%
Pre-1986 Housing

The Evansdale Water Works serves a community with a median household income of $62,835 and an estimated 38,140 residents across its service area. Approximately 68% of housing stock was built before 1986, which increases the likelihood of lead service lines and older plumbing.

Environmental Justice Note: 34% of the population in this service area is classified as disadvantaged under EPA's EJScreen criteria. Communities with higher disadvantaged populations often face disproportionate environmental and health burdens, including aging water infrastructure and limited resources for remediation.

💧 Where Does Your Water Come From?

Groundwater

Evansdale Water Works's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table.

Moderate Risk
Source Contamination Risk
50th
Wastewater Discharge Proximity
80th
Superfund Site Proximity

About 1% of homes in Black Hawk County, Iowa rely on private wells rather than public water systems. Private well owners are responsible for their own water testing and treatment.

Superfund Proximity Note: This service area ranks in the 80th percentile nationally for proximity to Superfund (NPL) sites. Groundwater sources near contaminated sites may face elevated risk from industrial chemicals.

Infrastructure Risk

58 yr
Avg Pipe Age
Galvanized Steel or Copper
Pipe Material
8 yr
Est. Remaining Life
Moderate Wear
Decay Status
Installed 88% of expected lifespan used End of life

Detected Contaminants

How Evansdale Water Works compares to EPA limits

What This Means For You

Contaminant 1003 at 1 mg/L exceeds the EPA maximum of mg/L.

PFAS Detected in Service Area

PFAS ("forever chemicals") have been detected in water serving this system's area. 8 detections recorded. 2 exceed federal EPA limits (4 ppt for PFOA/PFOS).

Health concern: PFAS are linked to cancer, thyroid disease, immune suppression, and developmental effects. They do not break down naturally.
Recommended filter: Reverse osmosis (RO) or activated carbon filters certified for PFAS removal. Find the right filter →

Comparable Water Systems

Similar-sized systems in Iowa

Camanche Water Supply
4,570 people
C 0 violations
B 0 violations
Tiffin Water Supply
4,512 people
C 3 violations
C 1 violation
C 5 violations

Estimated Remediation Costs

Average estimated costs across ZIP codes served by this system

Radon Mitigation Flood Insurance PFAS Treatment
Radon Mitigation $1,200
Flood Insurance $1,050
PFAS Treatment $300
Total Estimated Cost $2,550

Based on national averages for common remediation projects. Actual costs vary by property. Only issues flagged by EPA, FEMA, or state data for each ZIP code are included.

Cost of Inaction

If water quality issues in this service area are not addressed, the estimated financial impact per household is:

Estimated Healthcare Costs $500

Annual per household (CDC est.)

PFAS Exposure — Lifetime Cost $1,000

Per person (emerging research est.)

Estimated Cumulative Cost Per Household

5 years
$2,665
10 years
$5,330
20 years
$10,660

Compare: Estimated remediation cost is $2,550 (one-time) vs. $5,330 in estimated inaction costs over 10 years.

Estimates based on published EPA, CDC, and peer-reviewed research. Individual costs vary by household size, property, and health factors. These are conservative lower-bound estimates intended for awareness, not financial advice.

System Overview

EVANSDALE WATER WORKS (EPA ID: IA0723027) is a community water system in Iowa that serves approximately 4,561 people from groundwater sources.

This system provides water to 4 ZIP codes across 4 communities.

Average Home Safety Score: D (53/100)

Based on water quality violations, lead levels, and radon risk across all ZIP codes served by this system.

Violation History

1 monitoring/reporting violation recorded. These are procedural violations (missed tests or late reports), not necessarily water safety issues.

Contaminants Detected

The following contaminants have been flagged in EPA records for this water system:

Contaminant Category Violations Health-Based
Contaminant 1003 Other Violation 1 No

Lead & Copper

EPA Lead and Copper Rule sampling data for ZIP codes served by this system:

ZIP Code Lead Level Exceeds Limit Sample Date
50707 0.0012 mg/L No N/A

Radon Risk in Service Area

Dominant radon zone for ZIP codes served by this system: Zone 1 (High Risk)

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Need help with your water quality?

Typical cost: Water test: typically $20–$50 (DIY kit) · Professional inspection: $150–$400

Find the Right Water Filter

Free tip: Let cold water run for 2 minutes before drinking — this helps flush lead from your pipes.

ZIP Codes Served

Coverage: 2 ZIP codes confirmed via EPA Community Water System Service Area Boundaries v3 plus 2 additional ZIPs inferred from SDWIS registry data. The EPA-confirmed set is the most reliable; SDWIS-inferred entries may be narrower than the real deployment area.

Data Sources

This report uses public data from the EPA Safe Drinking Water Information System (SDWIS). View the full compliance record for Evansdale Water Works (IA0723027) on EPA.gov.

Frequently Asked Questions

Is Evansdale Water Works water safe to drink?

Evansdale Water Works has only monitoring/reporting violations, which are procedural in nature. The system meets federal health-based standards.

How many people does Evansdale Water Works serve?

Evansdale Water Works serves approximately 4,561 people across 4 ZIP codes in Iowa.

Where does Evansdale Water Works get its water?

The primary water source is groundwater.

Federal UCMR5 PFAS Monitoring: Tested Clean

This water system was tested under the federal EPA Unregulated Contaminant Monitoring Rule (UCMR5). No PFAS compounds were detected.

Samples collected
58

Current MCL reflects the lowest state-enforceable limit (NYS 10 ppt for PFOA/PFOS, effective August 2020). The federal final MCL of 4 ppt for PFOA/PFOS (EPA April 2024 rule) is not enforceable until April 2029. Detections above 4 ppt but below 10 ppt are below current MCL but above the future federal limit.

Source: U.S. EPA UCMR5 (Unregulated Contaminant Monitoring Rule, 5th cycle) — per-system federal sampling, 2023–2025. EPA UCMR5 monitoring program →

Understand PFAS health context and filtration →

Lead Service Line Inventory

Service line breakdown reported under the federal Lead and Copper Rule Improvements (LCRI) inventory requirement:

0
Confirmed Lead
0
Galvanized — Replacement Required
2
Unknown Material
2,118
Confirmed Non-Lead

This system reports zero confirmed lead service lines in its inventory. Unknown-material counts may still warrant verification.

Federal LCRI rule (effective October 2024) requires every public water system to inventory its service lines and complete lead-line replacement within 10 years.

Federal Regulatory Status · 2026Q1
LCRR inventory submission: Reported all required service line types
Latest tap sample on 2023-01-01 did not exceed the federal lead action level.
Population served: 4,561
Reported to Iowa

Source: EPA SDWIS Federal Service Line Inventory (Phase 2) · Submitted 2026

ZipCheckup is not affiliated with the utility or state agency. Inventory figures render verbatim from the public LCRI submission cited above; ZipCheckup does not perform inspections or replacements.

Learn about lead in drinking water →

How Water Systems Appear in Rankings

Water systems are evaluated by violation history, contaminant detections, and service population. Larger systems with more service connections appear in more rankings.

Frequently Asked Questions

Is water from Evansdale Water Works safe to drink?
Evansdale Water Works has a D safety grade based on 1 recorded violation. Some contaminants may exceed EPA limits — independent testing is recommended.
What contaminants are in Evansdale Water Works's water?
Detected contaminants include Contaminant 1003. Each is compared against EPA maximum contaminant levels (MCLs) in the detailed breakdown above.
Should I use a water filter?
Given 1 contaminant above EPA limits, a certified water filter can provide an extra layer of protection. The best type depends on specific contaminants in your water.
How many people does Evansdale Water Works serve?
Evansdale Water Works serves approximately 4,561 people with drinking water across 4 ZIP codes.
What is Evansdale Water Works's water source?
Evansdale Water Works draws water from groundwater sources. Source type affects which contaminants are most likely to be present.
Is there lead in Evansdale Water Works's water?
The maximum detected lead level is 0.0012 mg/L. This is within EPA action level guidelines.
What is the demographic profile of Evansdale Water Works's service area?
The Evansdale Water Works service area has a median household income of $62,835. EPA EJScreen data classifies 34% of the population as disadvantaged, which may indicate greater vulnerability to environmental health risks.
Where does Evansdale Water Works get its water?
Evansdale Water Works's water is pumped from underground aquifers. Groundwater is naturally filtered through rock and soil, but it can be vulnerable to PFAS contamination, nitrates from agriculture, and industrial chemicals that seep into the water table. Based on available data, the source contamination risk is moderate.

What You Can Do

1

Test your water

Home test kits can detect lead, bacteria, and other contaminants at your tap. Find the right filter →

2

Check your specific ZIP code

Water quality can vary within a system. View nearest ZIP report →

3

Contact your utility

Evansdale Water Works (EPA ID: IA0723027) — request the latest Consumer Confidence Report or ask about specific contaminants.

Home Water Systems Iowa Evansdale Water Works

Get safety alerts for Evansdale Water Works, Iowa

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found — check filter options Free tool — no phone call required.