Disinfection Byproducts (TTHM & HAA5) TX EPA VIOLATION

Disinfection Byproducts (TTHM & HAA5) in Drinking Wa...

City of Beaumont Water Utility Dept · Beaumont, TX · 115,282 people served

236.3 ppb
Highest Level Detected
80 ppb (TTHM) / 60 ppb (HAA5)
EPA Limit
Moderate
Health Risk Level
14
ZIP Codes Served
115,282
People Served
Granular Activated Carbon
Best Filter Method

Data: EPA SDWIS, ECHO, 2023 Consumer Confidence Report

Medical Disclaimer: This page provides environmental data and general health information from EPA and CDC sources. It is not medical advice. If you have health concerns related to your drinking water, consult a healthcare provider.

Disinfection Byproducts (TTHM & HAA5) Detected in CITY OF BEAUMONT WATER UTILITY DEPT

Disinfection Byproducts (TTHM & HAA5) was detected at 236.3 ppb in the CITY OF BEAUMONT WATER UTILITY DEPT water system serving Beaumont (TX), exceeding the EPA limit of 80 ppb (TTHM) / 60 ppb (HAA5).

This system serves approximately 115,282 people across 14 ZIP codes.

Data source: 2023 Consumer Confidence Report (CCR) and EPA SDWIS/ECHO.

Detected Levels

Contaminant Level Detected EPA Limit Status
Haloacetic Acid HAA5 236.3 ppb 60 ppb Violation

Health Effects of Disinfection Byproducts (TTHM & HAA5)

Disinfection byproducts (DBPs) form when chlorine or other disinfectants react with naturally occurring organic matter in water. The two regulated groups are Total Trihalomethanes (TTHMs) and Haloacetic Acids (HAA5). Long-term exposure to elevated DBP levels is associated with increased risk of bladder and colorectal cancer. Some studies also link DBPs to reproductive effects including miscarriage and low birth weight. DBP levels tend to be higher in systems using surface water and during warmer months.

Source: CDC — Disinfection Byproducts; EPA.

EPA Standard

The EPA maximum contaminant level (MCL) for disinfection byproducts is 80 ppb (TTHM) / 60 ppb (HAA5), governed by the Stage 2 Disinfectants and Disinfection Byproducts Rule. Water systems that exceed this limit must notify consumers and take corrective action.

What You Can Do

  • Install a granular activated carbon (GAC) filter — the most practical DBP removal method
  • Point-of-use carbon filters (pitcher, faucet-mount, under-sink) can reduce DBP levels
  • Letting water sit in an open container or aerating it can reduce some volatile THMs
  • Reverse osmosis systems also remove DBPs effectively
  • Contact your utility if you notice a strong chlorine taste or smell — DBPs may be elevated
  • Check your system's annual Consumer Confidence Report for TTHM and HAA5 levels

Recommended Water Filters

The most effective treatment for disinfection byproducts removal is Granular Activated Carbon.

Filter Type Effectiveness NSF Standard Notes
Granular Activated Carbon (GAC) 80-95% NSF 53 Most practical solution; replace filters per manufacturer schedule
Reverse Osmosis (RO) 90-99% NSF 58 Very effective but higher cost and water waste
Aeration / Air Stripping 50-90% N/A Effective for volatile THMs; less effective for HAAs

ZIP Codes Served by This System

Check water quality for your specific ZIP code:

Related Resources

Detected Levels

Contaminant Level Detected EPA Limit Status
Haloacetic Acid HAA5 236.3 ppb 60 ppb Violation

Recommended Water Filters

The most effective treatment for disinfection byproducts removal is Granular Activated Carbon.

Filter Type Effectiveness NSF Standard Notes
Granular Activated Carbon (GAC) 80-95% NSF 53 Most practical solution; replace filters per manufacturer schedule
Reverse Osmosis (RO) 90-99% NSF 58 Very effective but higher cost and water waste
Aeration / Air Stripping 50-90% N/A Effective for volatile THMs; less effective for HAAs

ZIP Codes Served by This System

Full Water System Profile: See all contaminants, violations, and lead levels for City of Beaumont Water Utility Dept.
HomeHealth & WaterDisinfection Byproducts (TTHM & HAA5) → City of Beaumont Water Utility Dept
Check your water filter options Free tool — no phone call required.