Detected Copper

Copper in Graniteville, SC Drinking Water

Copper data for Graniteville, South Carolina · 17,822 residents · 1 ZIP code

Federal water monitoring extends to thousands of public water systems, and in Graniteville, South Carolina, that tracking has turned up Copper — the detection is logged in the EPA compliance record and reflects samples collected under routine Safe Drinking Water Act reporting requirements.

1.1 ppb
Max Level Detected
1.1 ppb
Average Level
1.3 mg/L (action level)
EPA action level
Moderate
Health Risk
Reverse Osmosis or NSF 53 Carbon Block
Best Filter Method

Data: EPA SDWIS, CCR Reports, ECHO Last verified: 2026-05-14

Copper in Graniteville Tap Water

Copper has been detected in Graniteville, South Carolina drinking water at a maximum level of 1.1 ppb — below the EPA action level of 1.3 mg/L (action level).

This analysis covers 17,822 residents across 1 ZIP code in Graniteville.

Graniteville's overall water quality grade is A (95/100).

Is Copper in Graniteville Water Safe?

Copper was detected in Graniteville water but currently falls within EPA limits. However, some health organizations argue the EPA action level may not be protective enough.

If you are concerned, a reverse osmosis or nsf 53 carbon block filter can reduce copper levels further.

Copper Levels by ZIP Code

ZIP Code Copper Level EPA Limit Status
29829 1.1 ppm 1.3 mg/L (action level) OK

Average copper level across Graniteville: 1.1 ppb

Health Effects of Copper

  • Nausea, vomiting, and diarrhea (short-term, high levels)
  • Liver and kidney damage (long-term)
  • Particularly dangerous for people with Wilson's disease
  • Infants are more sensitive than adults

Health risk severity: Moderate. Governed by the Lead and Copper Rule.

How Copper Gets Into Drinking Water

  • Corrosion of copper household plumbing
  • Acidic (low pH) water accelerates copper leaching
  • New copper pipes leach more than aged ones
  • Mining and industrial discharge (rare for tap water)

What to Do About Copper in Graniteville Water

  1. Run water for 30-60 seconds before use (flushes stagnant water)
  2. Install an NSF 53 or NSF 58 certified filter
  3. If pH is low, consider a whole-home acid neutralizer
  4. Test first-draw morning water to check actual copper levels

Look for filters certified under NSF 53 for copper removal.

Related

HomeContaminantsCopperSouth Carolina → Graniteville
Check your water filter options Free tool — no phone call required.