Water Quality in Kettle Falls, WA: 1 Violation — Grade B
Grade B · Score 70/100 · 1 water system · Updated 2026-05-03
Kettle Falls's water is mostly safe. Minor violations exist but are primarily monitoring-related.
Data: EPA Safe Drinking Water Information System (SDWIS) Last verified: 2026-05-03
Kettle Falls, WA has 1 violation in the EPA compliance history — breakdown below.
Water Quality by ZIP Code in Kettle Falls
Water quality varies across Kettle Falls's 1 ZIP codes. Check your specific ZIP for detailed contaminant data.
| ZIP Code | Grade | Score | Violations | Health | |
|---|---|---|---|---|---|
| 99141 | B | 70 | 1 | 0 | View report → |
Water Quality Overview
Kettle Falls, Washington receives a water quality grade of B with an overall score of 70 out of 100, based on EPA compliance data from the Safe Drinking Water Information System (SDWIS).
The 1 water system serving Kettle Falls have accumulated 1 EPA violations (all monitoring/reporting type). These violations are tracked across 1 ZIP codes serving approximately 2,698 people.
What Grade B Means
A grade of B indicates good compliance with EPA drinking water standards. While not perfect, Kettle Falls's water systems meet the vast majority of federal requirements. Minor violations may exist but typically relate to monitoring or reporting rather than health-based standards.
Lead Levels
The average 90th percentile lead level across Kettle Falls water systems is 0.0010 mg/L — within EPA limits. No ZIP codes exceed the EPA lead action level.
With 46% of homes built before 1986, Kettle Falls has a higher-than-average risk of lead from older plumbing. Lead solder was banned in 1986, and homes built before this date may have lead in pipes, solder joints, or fixtures.
Radon Risk
Kettle Falls is in EPA Radon Zone 1 (High risk). The EPA recommends all homes in Zone 1 areas be tested for radon. Radon is the second leading cause of lung cancer after smoking.
Water Systems Serving Kettle Falls
Kettle Falls is served by 1 community water system regulated under the Safe Drinking Water Act. These systems collectively serve approximately 2,698 people across 1 ZIP codes.
Each water system is identified by a Public Water System ID (PWSID) and is required to:
- Test for over 90 regulated contaminants on a regular schedule
- Report results to the EPA and state regulators
- Issue an annual Consumer Confidence Report (CCR) to all customers
- Take corrective action when violations occur
The EPA has taken 1 enforcement action against water systems serving Kettle Falls. Enforcement actions range from informal compliance assistance to formal orders and penalties.
How to Check Your Water in Kettle Falls
Enter your ZIP code on ZipCheckup to see your specific water system data, including contaminant levels, violation history, and safety scores
Request your CCR — your water utility must provide an annual Consumer Confidence Report with detailed test results for all monitored contaminants
Get a home test — certified kits cost $20–$50 and test for lead, bacteria, and common contaminants. Professional lab tests ($150–$400) cover a broader panel
Consider filtration — NSF-certified filters can remove specific contaminants. Reverse osmosis removes the broadest range; activated carbon is effective for chlorine and many organics
Check for advisories — monitor your local utility website and local news for boil water advisories or system alerts
Contaminants Detected in Kettle Falls Water Systems
The following contaminants have been detected or caused violations across Kettle Falls's water systems:
| Contaminant | Category | MCL | Violations | ZIPs Affected | Health-Based |
|---|---|---|---|---|---|
| Surface Water Treatment Rule | Treatment Technique | N/A | 1 | 1 | No |
MCL = Maximum Contaminant Level (EPA enforceable standard). Health-based violations indicate levels that may pose direct health risks.
EPA Enforcement History
The EPA and state regulators have taken 1 enforcement action against water systems serving Kettle Falls. Recent actions:
| Date | Action Type |
|---|---|
| 2025-02-20 | State Order Extension |
Enforcement actions range from informal compliance assistance to formal orders and penalties. The most recent action was on 2025-02-20.
Kettle Falls vs. Nearby Washington Cities
How Kettle Falls's water quality compares to similar cities in Washington:
| City | Grade | Violations | Systems | Population |
|---|---|---|---|---|
| Kettle Falls | B | 1 | 1 | 2,698 |
| Boyds | D | 0 | 1 | 2,698 |
| Evans | D | 0 | 1 | 2,698 |
| Marcus | D | 0 | 1 | 2,698 |
Common Questions About Kettle Falls Water
These are the most common questions residents search for about water quality in Kettle Falls, Washington:
Is Kettle Falls water hard or soft? Water hardness varies by source. Kettle Falls's 1 water system uses a single source. Check your ZIP code report for specific hardness data.
Can I drink Kettle Falls tap water? Kettle Falls's water receives a grade of B (70/100). No health-based violations have been recorded, but home testing is always recommended.
What is the best water filter for Kettle Falls? A NSF/ANSI 53-certified filter for lead removal is a good general choice. See our Water Filter Matcher for personalized recommendations.
Kettle Falls vs. Washington Average
Understanding how Kettle Falls compares to the broader Washington average helps contextualize your local water quality. Factors like water source, treatment methods, and infrastructure age all contribute to differences between cities in the same state.
To see how individual neighborhoods compare, check the ZIP code reports below — water quality can vary significantly even within Kettle Falls.
ZIP Codes in Kettle Falls
Kettle Falls spans 1 ZIP code. The ZIP with the lowest water quality score is 99141. Each ZIP code has its own water quality profile based on the specific water system serving that area. Check each ZIP code for detailed contaminant data, violation history, and system information.
Data Sources
- Water quality: EPA Safe Drinking Water Information System (SDWIS)
- Lead/copper: EPA Lead and Copper Rule sampling data
- Radon: EPA Map of Radon Zones
- Enforcement: EPA ECHO database
- Filter recommendations: NSF/ANSI certified products
Updated daily.
Frequently Asked Questions
Your Water is Safe — Here's How to Keep It That Way
Grade B is excellent news. Here's what proactive homeowners do to maintain water quality:
Annual Water Testing
EPA recommends annual testing even with clean water. Home test kits: $20-$50. Catches changes before they become problems.
Maintenance Filtration
A basic carbon filter removes chlorine taste and catches emerging contaminants like PFAS that aren't yet fully regulated.
Plumbing Check
Even safe city water picks up lead from home pipes. If your home was built before 1986, a one-time pipe inspection is recommended.