CITY REPORT MI

Milford, MI: 10 Violations - Home Safety 82/100

2 ZIP codes · 9 water systems · Updated

ZipCheckup grade for Milford: B.

This ZIP looks solid, with a few items worth a quick check.

Drinking water tracked for Milford by MI authorities posts above-average scores - the majority of systems are free from health-based exceedances and the city's grade sits above the state median.

How Milford Compares

Milford82/100
Michigan avg85/100
National avg73/100

Data: EPA SDWIS

2
ZIP Codes
9
Water Systems
1
ZIPs with Violations
B · 82
Avg Safety Score
Zone 2
Radon Risk (Moderate)
$439K
Median Home Value

Milford Water: The Quick Version

  • Your city's water systems recorded 10 violations in the past 5 years.
  • Average lead level: 0.0055 mg/L.
  • Homes built before 1986: 48% - older plumbing may contain lead solder.
  • CDC health risk index: 11.75.

Water Systems Serving Milford

With 3 utilities splitting service in Milford, MI, water accountability is distributed across 9 systems on the federal record.

Overview

We track home safety data for 2 ZIP codes in Milford, Michigan (population ~21,238), covering 9 community water systems serving approximately 39,950 people region-wide. The EPA snapshots used for this build directly map water systems to 2 of 2 ZIP codes.

1 of 2 ZIP codes with a reported violation count in the available EPA record (50%) have recorded EPA violations. The available record reports no health-based violations for this measured scope.

Home Safety Score

Average Home Safety Score for Milford: B (82/100)

Model 4.0.0 uses four measured components across three equally weighted domains. If a required domain is unavailable, no score is published:

Factor What It Measures
Water Quality EPA violations and compliance history
PFAS MCL Screen UCMR 5 testing against the covered federal MCLs
Radon Risk EPA radon zone classification
Annual AQI EPA AirData county-year median with at least 90 observed days

Water Sources

Milford water systems draw from: Groundwater, Surface water.

Lead & Copper

  • Average lead level (90th percentile): 0.0055 mg/L (EPA action level: 0.015 mg/L)
  • 0 of 2 ZIP codes with known status exceed the EPA lead action level

Radon Risk

Dominant radon zone: Zone 2 (Moderate Risk)

  • Zone 1 (High): 0 ZIP codes
  • Zone 2 (Moderate): 2 ZIP codes
  • Zone 3 (Low): 0 ZIP codes

The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.

Top Contaminants

Contaminant Category Violations ZIPs Affected
Haloacetic Acids (HAA5) Disinfection Byproducts 4 1
Revised Total Coliform Rule Microbiological 4 1
Lead Inorganic 2 1
Total Trihalomethanes (TTHM) Disinfection Byproducts 2 1
Stage 1 DBP Rule Treatment Technique 2 1

Areas with Most Violations

ZIP Code Safety Score Violations Health-Based System
48381 B 10 0 Milford, Village of

Areas with No Violations

ZIP Code Safety Score System Population
48380 B Highland Township 3,837

All ZIP Codes in Milford

Data Sources

Reporting periods vary by source. Missing data is shown as unavailable, not as zero.

CDC Health Data for Milford

10.6%
Asthma (US: 9.8%)
10.2%
Diabetes (US: 10.4%)
14.8%
Poor Mental Health (US: 14.8%)

Source: CDC PLACES (County-level estimates). Water contamination can correlate with respiratory and chronic health conditions.

Compared to National Average

Asthma 10.6% ↑
Diabetes 10.2% ↓
Mental Health 14.8% ↓

Vertical line = national average. Above national · Below national

Key Contaminants Detected in Milford

Haloacetic Acids (HAA5) 4 violations
Disinfection Byproducts · EPA limit: 0.06 mg/L
Increased cancer risk with long-term exposure
Revised Total Coliform Rule 4 violations
Microbiological
Indicates possible bacterial contamination
Lead 2 violations
Inorganic · EPA limit: 0.015 mg/L

Based on EPA violation records. Check your ZIP code report for system-specific contaminant data.

How Old Is Milford's Housing Stock?

1982
Median Build Year
48%
Built Before 1986
16%
Built Before 1970
Copper
Likely Pipe Material

With 48% of homes built before 1986, lead solder in plumbing is a potential concern. The EPA banned lead solder in 1986, but many older homes retain original plumbing.

Source: U.S. Census Bureau American Community Survey (ACS).

Housing Age Profile

When trying to understand water quality at the household level, the year a home was built often matters more than any city-wide water report. That's because the 1986 federal ban on lead solder in plumbing, and the earlier phase-out of lead pipes before 1970, created sharp discontinuities in residential plumbing risk by construction era. Milford's median build year of 1982 puts the city in the transition zone: a substantial share of the housing stock postdates the solder ban, but a comparable fraction predates it - with the oldest homes carrying both the solder risk and the pipe risk simultaneously. Whether any individual household sits on the safer or riskier side of these thresholds is the key question, and it's one the city-wide median alone can't answer.

1982
Median Year Built
48%
Pre-1986 (Lead Paint Risk)
16%
Pre-1970 (Lead Pipes Risk)
Pre-1970 (16%) 1970–1986 (32%) Post-1986 (52%)

Most homes in Milford were built after 1986, reducing the risk of lead contamination from plumbing. Older homes should still be tested.

Source: U.S. Census Bureau ACS B25034.

Protecting Children from Lead in Milford

48%
Homes Built Before 1986
0.0055
mg/L Avg Lead (Limit: 0.015)

Why children are most at risk: The CDC states there is no safe level of lead exposure for children. Children under 6 absorb lead more readily than adults, and even low levels can cause developmental delays, learning difficulties, and behavioral problems.

Older interior plumbing shapes the local picture: 48% of Milford homes predate the federal solder ban, and aggregate sampling either approaches or crosses the action benchmark. That mix makes a single-home draw a standard pre-purchase or pre-occupancy step.

Sources: EPA Lead and Copper Rule, U.S. Census Bureau ACS, CDC childhood lead poisoning prevention guidelines.

Frequently Asked Questions

What does the Home Safety Score mean for Milford, MI?
Milford has an average Home Safety Score of 82/100 (Grade B) under model 4.0.0. The score combines EPA SDWIS identity plus accepted ECHO SDWA lifecycle-based water compliance, the PFAS MCL screen, EPA radon zone, and annual EPA AQI, and is published only when all required domains are observed. 10 EPA violations have been recorded. Check individual ZIP code reports for component details.
How many water violations does Milford have?
Milford water systems have a total of 10 EPA violations. Violations are tracked across 2 ZIP codes.
Does Milford water have lead?
The average 90th-percentile lead level in Milford is 0.0055 mg/L. This is below the EPA action level of 0.015 mg/L. Lead levels can vary by home - testing is recommended especially in older properties.
How does Milford compare to Michigan average?
Milford has an average Home Safety Score of 82/100, which is below the Michigan state average of 85/100 for the same model series.
How many water systems serve Milford?
Milford is served by 9 public water systems across 2 ZIP codes, serving approximately 21,238 people.
HomeCitiesMichigan → Milford, MI

How to cite this page

APA ZipCheckup. (2026). Milford, MI: 10 Violations - Home Safety 82/100. https://zipcheckup.com/cities/mi/milford/
BibTeX
@misc{zipcheckup-cities-mi-milford,
  author = {{ZipCheckup}},
  title  = {{Milford, MI: 10 Violations - Home Safety 82/100}},
  year   = {2026},
  url    = {https://zipcheckup.com/cities/mi/milford/}
}

Page version: August 2026.

Get safety alerts for Milford, Michigan

Free updates when EPA data changes for this area. No spam.

Unsubscribe anytime. Privacy Policy.

Share This Page

X Facebook
Violations found - check filter options Free tool - no phone call required.