Beallsville, MD Water - Home Safety Score unavailable
1 ZIP code · 0 water systems · Updated
Data: EPA SDWIS
What You Should Know About Beallsville Water
- Homes built before 1986: 88% - older plumbing may contain lead solder.
- Estimated remediation: $1,200 per household.
- CDC health risk index: 10.24.
Overview
We track home safety data for 1 ZIP code in Beallsville, Maryland, covering 0 community water system serving approximately 116 people. The EPA snapshots used for this build directly map water systems to 0 of 1 ZIP codes.
EPA water-system violation data is unavailable in the dataset used for this page for the tracked ZIP codes in Beallsville.
Lead & Copper
- Lead data: not yet available for Beallsville
- Lead action-level status: not available
Radon Risk
Dominant radon zone: Zone 1 (High Risk)
The EPA recommends testing homes in Zone 1 and Zone 2 areas for radon.
All ZIP Codes in Beallsville
Data Sources
- Water quality: EPA Safe Drinking Water Information System (SDWIS)
- Lead/copper: EPA Lead and Copper Rule sampling data
- Radon: EPA Map of Radon Zones
Reporting periods vary by source. Missing data is shown as unavailable, not as zero.
Health Outcomes in Beallsville
Source: CDC PLACES (County-level estimates). Water contamination can correlate with respiratory and chronic health conditions.
Compared to National Average
Vertical line = national average. ■ Above national · ■ Below national
Housing & Infrastructure in Beallsville
With 88% of homes built before 1986, lead solder in plumbing is a potential concern. The EPA banned lead solder in 1986, but many older homes retain original plumbing.
Source: U.S. Census Bureau American Community Survey (ACS).
Housing Age Profile
Beallsville's housing stock is predominantly older, with a median build year of 1978 that reflects decades of construction before federal plumbing standards were tightened. The 1986 ban on lead solder and the pre-1970 era of lead service lines are both relevant benchmarks here - a significant share of the residential inventory predates one or both of those cutoffs, creating an elevated baseline for plumbing-related lead risk that aggregate water quality data may not fully reflect at the household level.
Over half of homes in Beallsville were built before 1986, when lead solder was banned. Older plumbing may leach lead into drinking water, especially with corrosive water chemistry.
Source: U.S. Census Bureau ACS B25034.
Cost Context: What Remediation Means for Beallsville Homeowners
When remediation costs are measured against Beallsville home values, the resulting ratio is in the low tier - addressing documented water and safety issues here claims only a minor fraction of typical equity, and most homeowners are in a position where the financial commitment is straightforward rather than a material burden on their household budget.
Remediation costs in Beallsville are relatively low compared to home values. The $800–$1,500 estimated range is a small fraction of median property value. Home values are 111% above the Maryland average.
Lead Exposure Risk for Children in Beallsville
Why children are most at risk: The CDC states there is no safe level of lead exposure for children. Children under 6 absorb lead more readily than adults, and even low levels can cause developmental delays, learning difficulties, and behavioral problems.
If 88% of the Beallsville inventory comes from before the federal ban on lead-bearing solder - and if utility samples sit at or near 0.015 mg/L - the gap between citywide averages and one specific faucet becomes a practical concern rather than a theoretical one. That is why one-home reads exist as a separate measurement. A certified filter through retailer networks addresses confirmed exposure where it appears in a household.
Sources: EPA Lead and Copper Rule, U.S. Census Bureau ACS, CDC childhood lead poisoning prevention guidelines.
Deep Dive Reports
Detailed analysis for Beallsville, MD